The paper analyzes the vector control theory for doubly fed induction generator, Maximal Power Point Track (MPPT) and control strategy for the unity power factor of stator output.
阐述了双馈发电机的矢量控制原理及其相应的最大功率点跟踪和发电机定子侧输出单位功率因数的控制策略。
To avoid the "over-maintenance" or "under-maintenance" in generator set maintenance decision, a maintenance strategy based on Markov chain state estimation model is presented.
为避免发电机组“检修过剩”或“检修不足”现象的发生，提出了基于马尔可夫链状态估计模型的状态检修策略。
A new excitation control strategy is proposed for the rotor side converter in a doubly fed induction generator (DFIG) to allow the system to ride through a symmetrical grid fault.
提出了一种电网对称故障时保持双馈感应风力发电机不脱网运行的新型励磁控制策略。
A new excitation control strategy is proposed for the rotor side converter in an AC excited wind-power generator to allow the system to ride through the grid short-circuit fault.
提出一种电网短路故障时保持交流励磁风力发电机不脱网运行的新型励磁控制策略。
An optimal coordinated control strategy for the generator excitation and PET is deduced.
在此基础上推导了PET和发电机励磁的最优协调控制规律。
An interface power control strategy based on power flow tracing and generator re-dispatch is presented.
给出一种基于潮流追踪和发电机再调度的割集断面潮流控制方法。
ANN control strategy can make the voltage of generators stable in the course of load changed, load uninstalled, electrical network fault and generator fault and so on.
ANN控制方法能使发电机在负荷变化、甩负荷运行、电网故障以及发电机故障等各种工况条件下，发电机端电压保持稳定。
From the generation principle of switched reluctance generator (SRG), two methods of enhancing output power were introduced, and a new switching strategy was focused on.
根据开关磁阻发电机(SRG)的发电原理，介绍了提高SRG输出功率的两种方法，重点介绍了一种新的开关策略，并对SRG在各种可能的开关角下进行了仿真。
The thesis presents the principle of VSCF wind Power. In this thesis, we adopt the vector control strategy of stator field-orient and gain a vector control system model of double-feedback generator.
介绍了变速恒频风力发电的基本原理，并采用定子磁链定向的矢量控制方法得到了双馈发电机的矢量控制系统模型。
In wind power system, a vector control strategy using rotor induct electric potential orientation for doubly fed generator was proposed.
针对风力发电系统中的双馈电机提出一种转子感应电势定向矢量控制方法。
The strategy can realize cutting-in without accurate parameters of doubly-fed induction generator(DFIG)and the controller can be designed without accurate DFIG model.
该控制方案不需要精确电机参数就可以实现并网，控制器的设计也不需要建立精确的数学模型。
The strategy can realize cutting-in without accurate parameters of doubly-fed induction generator(DFIG)and the controller can be designed without accurate DFIG model.
该控制方案不需要精确电机参数就可以实现并网，控制器的设计也不需要建立精确的数学模型。
应用推荐