Unfortunately this early plant experienced the problem common to many forms of renewable energy: the flow in the Wey River was unreliable, and the waterwheel was soon replaced by a steam engine.
不幸的是,这个早期的工厂遇到了许多可再生能源形态都遇到的问题:韦河的水流不稳定,而水车很快就被蒸汽机取代了。
Causes of deviation of the main steam flow value indicated in DAS system for Beilun power plant unit 2 are analysed. The problems are found in the original calculation model.
对北仑电厂2号机组DAS系统主蒸汽流量指示值出现偏差的原因进行分析,找出原计算模块中存在的问题。
The sintered flat plate heat pipe can save a support structure in the prior art so as to avoid the problems of pipe expansion and steam flow disturbance caused by the support structure.
该烧结式平板热管可省去现有技术中的支撑结构,从而避免了支撑结构导致的胀管及扰乱蒸汽流动问题。
The reasonable layout of tube bundle can strengthen the heat regenerative effect and reduce flow steam resistance.
合理的管束布置,对于强化回热作用,降低流动汽阻具有重要意义。
The key technique is to simulate the flow field of steam and drop in bent plates.
研究的关键技术在于准确模拟蒸汽和水滴在波形板间的流场。
A theoretical calculation and experimental study is conducted of a supersonic steam liquid two phase flow pressure boosting unit, which incorporates a hot water recirculation system.
介绍了具有再循环系统的超音速汽液两相流升压装置,并对该装置的各种性能进行了理论计算及实验研究。
This flowmeter is a meter with automatic display and accumulation used for examining and measuring the flow of liquids, gases and steam with the aid of a throttle.
橡胶杯膜电远传流量计,是配合节流元件(孔板)用来检测液体,气体和蒸汽的流量,并能自动显示和累积的仪表。
An integrated probe system, which is capable of measuring the flow field of steam and the water droplets simultaneously has been successfully developed by authors.
作者研制了能同时测量汽液两相流动状况的集成化探针,并成功地在电厂进行了实测。
While the flow of gas or steam is detected, measurement error can be brought by the change of medium condition.
检测气体或蒸汽流量时,介质的工况变化将引入测量误差。
It also gives out a variable coefficient density compensation formula used for measurement of mass flow of the low pressure saturated steam, and the features of this formula.
给出了一个用于低压饱和蒸汽质量流量测量的变系数密度补偿式和该补偿式的特色。
James Watt's flyball governor (1769) regulated steam flow to a steam engine to maintain constant engine speed despite a changing load.
1769年瓦特的飞球调速器,它是一种调节蒸汽流的装置,即使荷载变化仍可保持蒸汽机的转速不变。 收藏。
The heat transfer and flow resistance performance of corrugated tube heat exchanger were examined by oil, water, and steam.
采用油、水、水蒸气对波纹管换热器的传热和流动阻力性能进行了试验研究。
This paper gives a brief description of the method for calculating three dimensional viscous flow field of a steam turbine blade row with the use of a finite volume time marching method.
介绍了用有限体积时间推进法进行以蒸汽为介质的蒸汽透平叶片排全三元粘性流场的计算方法。
Also the paper lists the factors mostly affecting the mass flow measurement consecutively as steam density, expandable coefficient, inner diameter and flow coefficient of the throttle element.
指出对质量流量影响最大因素依次为蒸气密度、可膨胀系数、节流件内径及流量系数。
A shock wave pressure rise device of the two phase flow is composed of a steam nozzle, a mixing chamber and relevant valves and piping.
由蒸汽喷嘴、混合腔及相应的阀门和管道组成汽液两相流激波升压装置。
The computations also show that for a regenerativereforming device, the flow direction of fuel and steam is the same as that of flue gas.
同时,计算表明,对于蓄热式催化重整器而言,燃料与水蒸汽的流动方向应采用与热烟气相同的流动方向。
The experimental results reveal the difference between helical tubes and straight tubes on flow induced vibration, and the design for 200MW HTR steam generator avoids large amplitude vibration.
实验结果表明,螺旋管管束的流体诱发振动响应与直管相比存在一定的差别; 200MW高温气冷堆蒸汽发生器的设计避免了管束的大振幅振动。
A dynamic simulation model for non-homogeneous flow in wet steam turbine was developed and was corrected by a time step method, and then could be applied to dynamic simulation.
建立了透平湿蒸汽非平衡流动动态仿真模型,并进行了时间步长修正,模型可以用于蒸汽轮机的动态仿真计算。
Unstructured tetrahedral meshes are used to simulate the flow field inside high pressure combined valves of a 600mw ultra supercritical steam turbine under the nominal condition.
采用非结构化四面体网格,对某600MW超超临界汽轮机组高压主汽调节联合阀的额定工况进行了数值模拟。
For investigating the effect of steam condensation on the flow, the steady flow on large power condensing turbine last stage was numerical simulated with commercial computational software CFX -5.
为了研究蒸汽凝结对流动的影响,采用商用软件CFX -5数值模拟了某大功率凝汽式汽轮机末级的定常流动。
The paper presents an introduction to a numerical calculation method of the steam flow field and heat transfer performance ot condensers, accompanied by the analysis of a calculated example.
介绍凝汽器汽相流场与传热特性的数值计算方法及算例分析。
The flow characters and the requirement for aerodynamic performance of modern large steam turbine exhaust hood, and their several effects on the steam turbine are discussed in detail.
本文详细讨论了现代大功率汽轮机排汽缸的流动特点对其气动性能的要求及对机组的各种影响。
Based on the genetic optimization theory, a design method for the flow path of an axial flow steam turbine stage is presented.
提出一种基于遗传算法的轴流汽轮机级通流部分的优化设计方法。
The numerical simulation of steam flow field and heat transfer in condenser is necessary for the design, modification and operation of condenser.
详细地模拟凝汽器壳侧汽相流动和传热过程,对于凝汽器的设计、改造和运行具有重要的指导作用。
Local feedback loop containing inverse model of controlled object is able to cancel feedwater disturbance and another important one, disturbance from steam flow.
由被控对象的逆对象组成的局部反馈回路可以有效地克服给水扰动以及汽包水位的另一主要扰动——蒸汽流量的扰动。
This paper presents the key technical points in increasing the capacity of an industrial turbine, such as steam flow, rotor strength, axial thrust and auxiliary equipments.
具体阐述提高工业汽轮机能力需考虑的主要技术问题:蒸汽流量,转子强度,轴向推力及辅助设施。
Experimental results are given. Its applications in the measurement of condensed steam flow and the liquid density are also presented.
文中对测量蒸汽凝集流量和测量液体密度方面的应用作了简要介绍。
The paper presents a method for calculating mass flow distribution and pressure losses in HP, IP and LP steam turbine extractions.
介绍汽轮机高、中和低压缸抽汽流道的流量分布和压损的计算方法。
The paper presents a method for calculating mass flow distribution and pressure losses in HP, IP and LP steam turbine extractions.
介绍汽轮机高、中和低压缸抽汽流道的流量分布和压损的计算方法。
应用推荐