The article mainly focuses on the characteristics of static temperature of Q-FLEX accelerometer.
本文主要研究石英挠性加速度计的静态温度特性。
Application acceleration model for the static temperature compensation for temperature error, model accuracy improved significantly.
应用加速度计静态温度模型进行温度误差补偿，模型精度显著提高。
The effect of the velocity difference on total pressure loss may be neglected, if the density and the static temperature difference are equal.
若密度比、静温比相同或相近时，速度差对总压损失的影响可忽略。
But total pressure loss increases with the increasing of the velocity difference accompanied with the increase of the density and the static temperature ratio.
但速度差随密度比、静温比增大而增大时总压损失亦随之增大。
Heat charge simulation method which was derived from comparison of electric and thermal field was presented to calculate the static temperature field of underground cables.
根据电场和温度场的相似性，提出了用于计算地下电缆群稳态温度场的模拟热荷法。
The static temperature field distribution of flanged joints was simulated by 3-d FEA, the results show that the calculative values accord well with data of the measurement.
利用3 - D有限元法模拟了法兰接头的稳态温度场分布，结果表明计算值与实测数据吻合较好。
The experimental results show that the higher the static temperature and the density ratio between two supersonic flow, the more the total pressure losses of flow during mixing.
实验结果表明：混合过程的总压损失随两种超声速流的密度比、静温比增大而增加。
There are two methods for improving the transmission capacity of lines, static temperature-raising capacity-increase technology and dynamic monitoring capacity-increase technology.
提高现有输电线路的输送容量有两种方法，即静态提温增容技术和动态监测增容技术。
Taking solar energy as a drive thermal resource, the static temperature distribution at some time, the dynamic state change of temperature, pressure and desorption speed with time was analyzed.
以太阳能为驱动热源，分析了吸附床内温度在某时刻的静态分布以及温度、压力和脱附速率随时间的动态变化。
Meanwhile, compared with the ramet, it has lower static temperature and pressure in the combustion chamber, thus obviously decreasing its structure loads as well as simplying its structure designing.
与亚燃冲压相比，发动机内静温、静压低，从而减轻了结构强度负荷，简化了结构设计。
Applies the method to controlling air temperature in the static hot-box device and compares the control performance with that of PI control.
采用这种控制算法对静态热箱装置的空气温度进行了控制，并与PI控制进行了比较。
Static adsorption showed that the adsorption effect was related to reaction temperature.
静态吸附结果表明，反应温度对纤维的吸附效果有影响。
The pitot static probes, temperature probe and alpha vanes provide air data information to the various using system, they are located on the left and right sides of the forward fuselage.
皮托静压探头、总温探头和迎角叶片用来提供大气数据信息给不同的应用系统，他们位于前机身在右侧。
On the earning data of the tests, temperature static model of gyro has been studied by the two ways of linear regression algorithm and of wavelet network identification.
在试验数据的基础上，分别使用线性回归算法和小波网络建立了陀螺仪的静态温度模型。
The relationship between equivalent static load and temperature field has been verified through tests.
文中还通过试验验证了上述当量静载与温度场的关系。
The temperature effect on initial equilibrium shape and characteristics of static responses of pretensioned cable-membrane structures is analyzed in this paper.
对预应力张拉索膜结构由于温度变化对结构初始平衡形状和静力效应的影响进行研究。
The influence of extraction temperature, static placing time, solvent burden ratio and flocculating agent on separation effect were discussed.
讨论了萃取温度、静置时间、溶剂配比和絮凝剂对分离效果的影响。
The thermodynamics and dynamics for adsorption of picric acid onto polyamide under static conditions were studied and the influence of temperature on the adsorption was also inspected.
在静态下，考察了温度对聚酰胺树脂吸附水溶液中苦味酸的影响，探讨了吸附的热力学、动力学规律。
Experimental study is performed on its temperature resistance, high temperature stability, salt tolerance, static shear force changed with time and its compatibility.
对该体系的抗温性、高温稳定性、抗盐性、静切力随时间的变化及配伍性进行了试验研究。
This model mainly includes the target temperature model, static model, dynamic model and dynamic self-adaptation.
工艺过渡模型主要包括带钢目标温度模型、静态模型、动态模型、动态自适应。
Under static or very slow gas flow, small signal gain distribution depends on temperature distribution in the discharge channel.
在静止气体或非常慢速流动下，小信号增益分布取决于气体温度的分布；
Finally a model between asphalt mixture creep stiffness and temperature was build to simulate the test results of static creep tests.
基于静载蠕变试验结果建立了沥青混合料粘滞劲度模量与温度之间的转换模型方程。
Numerical simulation of temperature field during al solidification process under static high pressure has been conducted.
采用数值模拟的方法，研究了纯铝在静高压作用下凝固过程温度场的变化情况。
The static models of EGO sensors for different temperature were built up using sectioned polynomial based on the least square.
采用基于最小二乘的分段多项式，建立了不同温度下EGO传感器的静态模型。
The static and dynamic mechanical properties have been studied for PP that have been injected at different melt temperature and mold temperature.
本文研究了在不同的熔体温度和模具温度下，注射成型的聚丙烯塑料试样的静态和动态力学性能；
The temperature of the actuator for the static boundary condition is a little higher than that for the moving boundary condition.
结果表明：静边界条件下形状记忆合金驱动器温度稍高于动边界条件；
The influence of the temperature and material parameters of the composed sphere on the void formation and growth are considered and compared with that for static analysis.
考察了参数对孔穴生成与增长的影响，并与相应的静态结果进行了比较。
The influence of the temperature and material parameters of the composed sphere on the void formation and growth are considered and compared with that for static analysis.
考察了参数对孔穴生成与增长的影响，并与相应的静态结果进行了比较。
应用推荐