This paper made some research on the modeling of some city bus body, FEM static intensity analysis and structure optimization.
本文对某型大客车进行有限元静态分析，探讨客车车身建模、强度分析与结构优化。
Through static, modal and crack stress intensity factor analysis, the vibration stress of blade under rotating state before fracture can be calculated out finally.
然后采用有限元数值计算方法对叶片进行静力分析、模态分析及裂纹应力强度因子计算，最后反推出叶片在旋转状态下振动应力值的大小。
Because only static intensity and stability analysis is considered and dynamic calculation is usually neglected in design, the problems like heavy vibration and local weak rigidity have appeared.
由于设计时仅进行了静强度和稳定性计算，而没有进行动力计算，在使用过程中出现了有时振动过大、个别部位刚度弱的问题。
Blade fracture location is match to the position of maximum stress derived from the static analysis, so try to reduce stress concentration increases the intensity of the blade is critical.
本文研究的叶片的断裂位置与静力分析所求出的最大应力位置吻合，因此设法减小该位置的应力集中情况对于提高叶片的强度很关键。
Applying the limited unit law the article carries out the static analysis to the electrical machinery commutation pumping unit support, calculated its static intensity and rigidity.
应用有限单元法对电机换向抽油机支架进行了静态分析，计算了其静强度和刚度。
The theoretical analysis shows that the intensity of the generated waves is in proportion to the product of the imposed static magnetic field and alternating electrical current.
理论解析表明，运用交变电磁力在液体金属内生成的磁声波的强度和所施加的静磁场的磁感应强度和交流电流的电流密度的乘积成正比；
To decrease the mismatch between the light and microwave velocities, the electrode structure of optical waveguide intensity modulator is designed by using quasi-static analysis method.
用准静态分析法分析了铌酸锂光强度调制器的电极结构参数。
To decrease the mismatch between the light and microwave velocities, the electrode structure of optical waveguide intensity modulator is designed by using quasi-static analysis method.
用准静态分析法分析了铌酸锂光强度调制器的电极结构参数。
应用推荐