The ability to replicate a roast time and time again can be accomplished with sound profile management practices.
屡次重复烘焙的能力能够完成管理概况的实践。
The result shows that there are three basic types of sound speed profile structure in sea areas of China: D-type, S-type and T-type.
结果表明，中国近海的声速剖面结构可分为深海型、浅海型和过渡型三个基本类型。
The University of Canberra prides itself in being a recognised leader in the provision of high quality undergraduate and postgraduate education underpinned by a sound research profile.
在堪培拉大学感到自豪的是，在高品质的本科生和研究生教育的一个稳健的研究提供确认文件为基础的领导者。
The results showed that using single sound speed profile at source produced errors at simulation range large that 10 km.
其结果显示距声源10公里外，只使用单一声速剖面之音传模拟会产生较大的误差；10公里之内差值小于1分贝。
The results show that wind and the sound speed profile have little influence on air-to-water sound transmission.
结果表明：空气中风速剖面和声速剖面对空气中声传播有很大影响，但对于透射进入水中的声波影响很小。
As an example, the distribution of the detonation pressure, density, particle and sound velocity along the detonation profile are given for TNT.
以TNT为例进行了计算，给出了其爆轰波内压力、密度、流速和声速等参数的分布。
In the hydrographic practice, the real depth may be more than the depth of sound velocity profile.
在实施声速剖面测量时，由于某些原因可能存在实际水深大于声速剖面深度的情况。
For each profile Best Profiles allows selection of additional Settings such as: backlight, sound on activate, run custom application etc.
每个配置文件的最佳配置文件允许的其他设置例如，选择：声音的背景光激活运行自定义应用程序等。
Combined with the calibration method, two methods for the sound ray bending correction in deep sea are developed when the sound velocity profile is known and unknown separately.
文中结合海底应答器位置校准方法，分别就声速分布已知和未知两种条件开发了深海声线弯曲修正方法。
In this paper an numerical analysis is made through computer data simulation to infer the residual stress profile by using temperature gradient and ultra-sound. A valid numerical algorithm fo...
本文利用计算机模拟数据对超声波和温度梯度进行金属内部应力推断做了数值分析并引入了一种有效的提取应力信息的反演算法同时也给出了数值分析的初步结果。
Research results show that bad strip profile caused by wear and thermal crown of roller may be properly repaired by sound original roller contour, and strip profile is greatly improved.
研究结果表明，采用合理的初始辊形可以一定程度上弥补轧辊磨损和热变形对带钢断面的不良影响，大大优化了带钢断面形状。
Research results show that bad strip profile caused by wear and thermal crown of roller may be properly repaired by sound original roller contour, and strip profile is greatly improved.
研究结果表明，采用合理的初始辊形可以一定程度上弥补轧辊磨损和热变形对带钢断面的不良影响，大大优化了带钢断面形状。
应用推荐