The results show that the suitable solution treatment process can reduce the size and amount of coarse second phases effectively and then increase the super-saturation degree of alloy elements.
结果表明：利用优化的固溶工艺处理后，可有效减少粗大的第二相尺寸和数量，提高合金元素的固溶过饱和度；
Most precipitate dissolve into the matrix after solution treatment.
材料经固溶处理后析出物绝大多数都溶入基体。
Grain growth exponent increases with the increasing of solid solution treatment temperature.
晶粒生长指数随固溶温度的升高而增加。
During the fast cooling process of solution treatment, nonequilibrium segregation of manganese...
在固溶处理时快速冷却过程中锰在奥氏体晶界产生不平衡偏聚。
In the case of solution treatment adequately, the variation of wall thickness almost haven't any effect on aging.
在充分固溶的情况下，壁厚不同对时效影响不大。
The influence to corrosion resistant ability of duplex stainless steel (SAF2205) after solution treatment to weld joint.
分析了采用焊后固溶处理对SAF2205双相不锈钢耐腐蚀性能的影响。
And solution treatment is the valid method to improve the anticorrosion property of the austenite stainless steel bellows.
固溶处理是改善和提高奥氏体不锈钢波纹管抗应力腐蚀能力的有效措施。
This paper deals with the low frequency damping of ZA27 alloy with solid solution treatment after natural ageing stability.
研究了固溶化处理的ZA2 7合金在自然时效稳定后的低频阻尼。
The effects of progressive solution treatment on microstructure and mechanical properties of 7A04 aluminum alloy were investigated.
研究了分级固溶对7A04铝合金组织与性能的影响。
Hard anodizing film could be obtained on Al-Cu alloy surface which had been treated with solid solution treatment and natural aging.
经固溶处理和自然时效的铝铜合金可以进行硬质阳极氧化。
The influence of different solid solution treatment on the structure and corrosion resistant property of cast duplex stainless steel was investigated.
研究了不同固溶处理对双相铸造不锈钢的组织及其耐蚀性能的影响。
After solution treatment, the weld grains become coarse along with a large amount of granular precipitates dispersed in weld zone and base metal zones.
经过固溶处理后，焊缝组织晶粒变大，焊缝区和母材区弥散分布着大量的颗粒状析出物。
Flow injection technique is a solution treatment technique under nonhomogeneous and unbalanced condition and has gained wide application in food analysis.
流动注射是一种非均匀非平衡状态下的溶液处理技术，在食品分析领域中的应用日益广泛。
By proper solution treatment the grain size of alloys was moderate, thus a good combination of strength, plasticity and the resistance to thermal fatigue was obtained.
采用适当固溶温度处理，该二合金晶粒度适中，可获得强度、塑性和抗热疲劳性能较好的配合。
The effect of high temperature solution treatment on the structure and properties of a directionally solidified high strength nickel-base superalloy has been investigated.
本文研究高温固溶处理对一种定向凝固高强度镍基高温合金的组织和性能的影响。
Effects of master alloy of quasicrystal containing magnesium additions and solution treatment on microstructure and mechanical properties of AZ91 magnesium alloy were studied.
研究了镁基准晶中间合金和固溶处理工艺对AZ91合金显微组织和力学性能的影响。
The results show that the electrochemical performance of aluminum alloy electrodes is improved markedly after solution treatment, but the self-corrupt speed of electrodes is accelerated.
结果表明，经过固熔处理后，铝合金电极的电化学活性得到显著提高，但自腐蚀速率加快。
The results showed that calcium solution treatment significantly increased total calcium content in fruits, improved fruit firmness and maintained permeability of cell membrane significantly.
结果表明：浸钙处理的果实总钙含量显著提高，其硬度明显高于对照，且有利于细胞膜透性的保持；
The temperature of solid solution treatment affected not only the degree of the second phase dissolved in the matrix alloy, but also the recovery and recrystallization processing level of the alloy.
固溶处理温度的高低不仅影响第二相在基体中的溶解程度，还影响合金的回复再结晶过程进行的程度。
The results show that the precipitated austenite crystals of welded joint after solid solution treatment are fewer, the grains are smaller. And the shape of austenite changes from strip to roundness.
结果表明：经固溶处理的焊缝和热影响区，晶内奥氏体析出变少，晶粒尺寸变小，同时奥氏体的形状由长条状变为圆状。
The results show that the precipitated austenite crystals of welded joint after solid solution treatment are fewer, the grains are smaller. And the shape of austenite changes from strip to roundness.
结果表明：经固溶处理的焊缝和热影响区，晶内奥氏体析出变少，晶粒尺寸变小，同时奥氏体的形状由长条状变为圆状。
应用推荐