Research about solid particle characters in circulating fluidized bed is very important to study the principle of gas-solid two phase flow.
循环流化床内固相颗粒运动特性的研究对于揭示床内气固两相流机理具有重要意义。
The results showed that the solid particle became finer, more homogeneous and rounder with the decrease of temperature or the increase of shearing rate.
研究表明：适量提高剪切速率或降低温度，半固态组织的固相颗粒会变得细小、均匀和圆整。
Liquid which contains solid particle, fibre and suspended matter.
含有固体颗粒、纤维、悬浮物的液体。
The flow property of solid particle in flowing bed is a key factor affecting the efficiency.
固体颗粒在移动床内的流动特性是影响床层使用效率的一个关键性因素。
The performance of solid propellants depends on the solid particle size after dispersive mixing.
固体推进剂的性能将取决于分散混合后固体颗粒的尺寸。
In the present study, higher power frequency makes the solid particle of the semi-solid AZ91D more spherical.
在试验范围内，随电磁搅拌电源频率的增大，半固态AZ91D合金组织中固相颗粒形态越来越圆整。
It is used to filter solid particle and slimes and effectively control cleanliness for oil-sucking filtration.
用于吸油过滤，滤除工作介质中的固体颗粒及胶状物质，有效控制工作介质的污染度。
The effects of the solid particle size distribution and the binder curing ratio were investigated experimentally.
实验研究了固体粒子尺寸分布和粘合剂固化比的影响。
The influences of various thin slurries with different solid particle sizes on filtration intensity are discussed.
实验研究了不同分级粒径对过滤强度的影响。
The applicable formulae of pressure drop in the dilute flow for solid particle through a vertical pipe are developed.
文中提出了固体粒子稀相流垂直管内适用的压力损失计算式。
The principle of fluidization and vibration has been applied to designing a dryer for the bulk solid particle sawdust.
把振动与流化床的原理结合起来干燥锯屑，证明是可行的。
It is installed in the low-pressure pipeline to filter solid particle and slimes in medium and effectively control cleanliness.
安装于低压管路中，滤除工作介质中的固体颗粒及胶状物质，有效控制工作介质的污染度。
Fluidized bed drier enjoys advantages of even solid particle mixing and large heat and mass transfer area of gas and solid phase.
流化床操作具有固体颗粒混合好，气固两相传热传质表面积大等优点。
The wear properties of antiwear adhesive coatings under solid particle erosion and slurry erosion condition were studied in this paper.
本文对气固冲蚀和浆体冲蚀条件下耐磨环氧胶粘涂层的磨损特性进行了研究。
With the increase of solid particle content, the time of phase disengagement will be prolonged and the interfacial emulsion intensified.
随固体微粒含量增加，分相时间延长，界面乳化程度加重。
When the solid particle was in slipping or jumping motion state in slurry flow, the solid particle will be influenced by frictional force.
沉降性浆体中固体颗粒处于滑跳移运动状态时，固体颗粒将受到摩擦力的影响。
The effect of solid particle content in feeding liquid on phase disengagement and interfacial emulsion in copper solvent extraction is studied.
研究了铜溶剂萃取时，萃原液中固体微粒含量对分相和界面乳化的影响。
Installed to compressor gas-oil seperator, to remove oil and solid particle in the compressed air, supplying clean air source for compressor back.
安装于制冷压缩机的油气分离器中，滤除压缩空气中的油雾及颗粒杂质，为压缩机后置系统提供清洁的气源。
Solid particle removal efficiency is chiefly decided by solid particle size, bubble size and the chemical properties of the solid particle surface.
气浮法的效率主要取决于固体颗粒直径、气泡直径和固体颗粒表面的化学性质。
The optical-electrical measurement is an effective and feasible way to measure solid particle concentration and velocity in gas-solid two phase flow.
应用光一电检测方法测量气一固两相流中固体微粒浓度、速度，是一种十分有效和可行的方法。
Theoretical analysis and experimental works have been carried out to study the solid particle attrition phenomena in a spouted-fluidized bed with a draft tube.
本文对导向喷动流化床中固体颗粒的破损进行了理论分析和实验测试。
In this paper, materials selection and preventing solid particle erosion measures of ultra-supercritical steam turbine's high temperature parts are introduced.
介绍了目前国内外关于超超临界汽轮机高温部件的材料选择及其对高温部件固粒侵蚀所采取的防止措施。
Erosion of the blade by the solid particle of the smoke and gas is the major problem of axial flow fan, which may make axial flow fan reduce power and even stop working.
轴流式引风机的失效形式主要表现为烟气中的固体颗粒对轴流式引风机叶片的冲蚀磨损，轴流式引风机叶片的失效会导致出力效率降低甚至停机。
Cyclone separator is a kind of equipment that USES rotary motion of gas-solid two-phase fluid to make the solid particle separated from the gas flow by centrifugal force.
旋风分离器是一种利用气固两相流体的旋转运动使固体颗粒在离心力的作用下从气流中分离出来的设备。
The relationship between the fractal dimension of the pore size distribution and the formation damage degree caused by solid particle transport and subsidence is discussed.
探讨了颗粒运移沉降对地层伤害的程度和孔隙大小分布分维之间的关系。
The EU calculates that the ABB solution eliminates 80 metric tons of nitrogen oxide, 60 tons of sulphur dioxide and two tons of solid particle emissions at the port each year.
欧盟认为ABB的解决方案每年为该港口减少了80公吨的氧化氮，60吨的氧化硫以及2吨固体微粒的排放。
The sizes of filler and abrasive have influence on the solid particle erosion of coating under the given condition, the size of filler be of weak influence on the slurry erosion.
填料粒度和磨料粒度都对涂层的气固冲蚀磨损有影响，但在给定的试验条件下，填料粒度对涂层的浆体冲蚀磨损影响甚微。
In addition, the blocking of the catalyst pore by the solid particle and some organic macromoleculars which are formed in the process of reaction is another reason for the deactivation.
同时在反应过程中产生的固体小颗粒和生成的有机大分子对催化剂孔道的阻塞也是催化剂失活的一个重要原因。
Two-phase flow in the cyclone separator is a process of the solid particle separation from the gas phase, while the particle movement trace is decided by the turbulence to a large extent.
旋风分离器内部进行的是两相流运动，是气相和固体颗粒相的分离过程，而固体颗粒的运动在很大程度上取决于分离器内湍流的运动。
Solid particle erosion may damage the turbogenerator sets. Minimizing particles, wear-proof covered layer and by pass are three effective approaches for Minimizing solid particle erosion.
固体颗粒磨蚀对汽轮机的危害不可忽视。减少颗粒、防磨镀层和将颗粒引向旁路是目前采用的三种解决方法。
应用推荐