The most remarkable characteristic of the food-frozen process is the coexistence of solid and liquid phase and the phase transition from liquid to solid.
食品冻结过程最大的特点是固液两相并存，并存在一个从液态向固态转变的相变过程。
The experiment showed that the mode of deformation and the plastic flow mechanism of solid and liquid phase under different solid phase ratio were different;
实验表明：半固态浆料模锻成形的变形方式是不同的，不同的固相率下其固液两相的塑性流动机制也是不同的；
For smaller clusters, there is no clear characteristic of first-order phase transition during the melting, implying a coexistence of solid and liquid phases due to finite-size effect.
对于较小的团簇，融化曲线没有出现清楚的一级相变特征，意味着由于尺寸效应导致的固态液态共存。
Preferably the hot melt ink has a sharp transition between solid and liquid phase as the temperature is raised and hence crystalline or semi-crystalline carrier vehicles are preferable.
最好热熔油墨有固体和液体之间的尖锐过渡期的温度升高，从而结晶或半结晶运载工具是可取的。
The elimination of void and oxide film removing model under solid state and the one under the coexistence solid and liquid phase are successively developed on basis of the above results.
并在试验的基础上，先后建立了振动条件下固态孔洞闭合和氧化膜破碎模型和固液共存状态下孔洞闭合和氧化膜破碎模型。
And turning the crank at equilibrium, being equal between the solid phase and the liquid phase.
在平衡态固相和液相的化学势相等，固相和气相一样。
When the reaction products form as high melting point CA2, CA6 and MA spinel in a continuous solid phase it will clog the liquid channel and resist the further diffusion of fused slag in the brick.
并且当熔渣与耐火材料的反应产物为高熔点的CA2、CA6和MA尖晶石相且连续交错分布时，能堵塞液相扩散通道，抑制熔渣向耐火材料内部的进一步渗透。
Turbulence models and wear models of low concentration as well as high concentration solid Liquid two - Phase flows in hydraulic turbomachinery are developed.
分别建立了水涡轮机械中、低、高浓度固液两相流湍流模型及泥沙磨损模型。
This instrument can be used for study on the structure of mother liquor grown high temperature crystals and the change of structure during the liquid solid phase transfer.
该装置可用于研究高温晶体生长过程中母液相的结构以及固-液相转变过程中结构的变化。
Conventional organic sample preparation methods, such as liquid-liquid extraction and solid phase extraction, are time and solvent consuming, and often involve several complicated procedures.
传统的有机物样品分析前处理方法主要有液-液萃取、固相萃取等方法，这些方法具有耗时长、操作繁琐、且需要大量有机溶剂等缺点。
The results showed that the solid liquid phase zone, temperature interval and segregation degree may be obviously enlarged with increasing s content so as to reduce the hot plasticity of the alloy.
结果表明，随着S含量的增加，导致固液两相区、温度范围和偏析程度明显加大，引起合金的热塑性降低。
The characteristics and types of phase change material (PCM) were introduced. The properties and applications of solid liquid and solid solid phase change material were discussed.
本文介绍了相变贮热材料的特点和种类，讨论了固液相变、固固相变贮热材料的性能和应用。
A solid phase extraction-high performance liquid chromatographic (HPLC) method was developed for the simultaneous analysis of thiabendazole and carbendazim in concentrated pear juice.
研究了一种可同时测定浓缩梨汁中噻菌灵和多菌灵残留量的固相萃取-高效液相色谱分析方法。
A calculation method of gas liquid solid three phase equilibrium is presented based on the characteristics of composition and phase behavior of an oil and gas system.
根据油气烃类体系的组成特点和相态特征，提出了气液固三相相平衡的计算方法。
After comparing and analysing varied rust removal techniques, this article recommends the new technique of rust removal with three phase abrasive water efflux of gas, liquid and solid.
针对上述问题，对多种除锈工艺进行分析比较，推荐采用气、液、固三相磨料水射流进行除锈的新工艺。
A method for analysis of tebuconazole in water using solid phase extraction and high performance liquid chromatography was developed.
首次建立了固相萃取-高效液相色谱法检测水中戊唑醇的方法并优化了固相萃取和高效液相色谱的条件。
In composite system filled with solid and solid liquid phase, rational particle grade improve particles arrangement closer and increase stacking density.
在固液相填充复合体系中，采用合理的颗粒级配可使颗粒排列更加紧密，提高堆积密度。
A rapid, simple and accurate method for the determination of momordicoside A has been established using solid phase extraction (SPE) followed by high performance liquid chromatography (HPLC).
建立了一个快速、简单、准确的固相萃取和高效液相色谱相结合的测定苦瓜甙A含量的方法。
As a porous solid adsorbent, porous glass microspheres were prepared and its adsorption feature in liquid phase was investigated.
对多孔玻璃微珠作为多孔性固体吸附剂的研制及其在液相中的吸附性能做了初步研究。
The test method for determining all kinds of additives in aluminium rolling oil was studied by solid phase extraction and reverse-phase high performance liquid chromatography.
采用固相萃取和反相液相色谱法研究了测定铝材轧制油中各种添加剂的方法。
The invasion of extrinsic liquid phase and the plugging of solid-phase particle are the main factors which damage dual-media reservoirs.
双重介质储层受损害的主要原因，是外来液相的侵入或固相颗粒的堵塞。
Because of the complexity and difficulty by theoretical study, solid-liquid two-phase flows are mainly studied by experimental method.
由于管道内部是复杂的两相流动，理论研究比较困难，历来的研究主要基于实验方法。
It is used for stirring, dissolving and dispersing of liquid and liquid-solid phase materials in coating, dye, paint, ink, paper, glue, cosmetics and other industries.
适用干涂料、染料、颜料、油墨、造纸、胶水、化妆品等行业对液体及液-固相物料讲行搅伴、溶解和分散。
Flow behavior of liquid and solid phases was simulated in an inversed fluidized bed based on two-fluid two-phase flow model.
基于欧拉·欧拉双流体模型，数值模拟倒置液固流化床内液固两相流动行为。
The gas phase equilibrated with the solid also had retrograde condensation, which results in three phases of gas-liquid-solid and layering in the liquid phase.
等液量线与相包络线平行，在一定的温度压力条件下有固相出现。
A method for the simultaneous determination of captan and folpet pesticide residues in apples was developed by solid-phase extraction and high performance liquid chromatography.
采用硅镁吸附剂和硅胶作吸附剂，建立了固相萃取-高效液相色谱法同时测定苹果中残留的克菌丹和灭菌丹的分析方法。
Based on the calculated liquid and solid phase velocity fields, the numerical simulation of silt abrasion on runner blade surfaces has been carried out.
根据液相和固相三维流速场的计算结果数值模拟了转轮叶片面的泥沙磨损。
Based on the calculated liquid and solid phase velocity fields, the numerical simulation of silt abrasion on runner blade surfaces has been carried out.
根据液相和固相三维流速场的计算结果数值模拟了转轮叶片面的泥沙磨损。
应用推荐