Solid particle erosion may damage the turbogenerator sets.
固体颗粒磨蚀对汽轮机的危害不可忽视。
Solid particle erosion (SPE) is very critical on the life cycle of control stage nozzle for supernormal parameters steam turbine.
固体颗粒冲蚀严重影响超常参数汽轮机调节级喷嘴寿命。
The effects of the solid particle size distribution and the binder curing ratio were investigated experimentally.
实验研究了固体粒子尺寸分布和粘合剂固化比的影响。
The applicable formulae of pressure drop in the dilute flow for solid particle through a vertical pipe are developed.
文中提出了固体粒子稀相流垂直管内适用的压力损失计算式。
The effect of solid particle content in feeding liquid on phase disengagement and interfacial emulsion in copper solvent extraction is studied.
研究了铜溶剂萃取时，萃原液中固体微粒含量对分相和界面乳化的影响。
Erosion of the blade by the solid particle of the smoke and gas is the major problem of axial flow fan, which may make axial flow fan reduce power and even stop working.
轴流式引风机的失效形式主要表现为烟气中的固体颗粒对轴流式引风机叶片的冲蚀磨损，轴流式引风机叶片的失效会导致出力效率降低甚至停机。
Fluidized bed drier enjoys advantages of even solid particle mixing and large heat and mass transfer area of gas and solid phase.
流化床操作具有固体颗粒混合好，气固两相传热传质表面积大等优点。
With the increase of solid particle content, the time of phase disengagement will be prolonged and the interfacial emulsion intensified.
随固体微粒含量增加，分相时间延长，界面乳化程度加重。
The flow property of solid particle in flowing bed is a key factor affecting the efficiency.
固体颗粒在移动床内的流动特性是影响床层使用效率的一个关键性因素。
In addition, the blocking of the catalyst pore by the solid particle and some organic macromoleculars which are formed in the process of reaction is another reason for the deactivation.
同时在反应过程中产生的固体小颗粒和生成的有机大分子对催化剂孔道的阻塞也是催化剂失活的一个重要原因。
The EU calculates that the ABB solution eliminates 80 metric tons of nitrogen oxide, 60 tons of sulphur dioxide and two tons of solid particle emissions at the port each year.
欧盟认为ABB的解决方案每年为该港口减少了80公吨的氧化氮，60吨的氧化硫以及2吨固体微粒的排放。
Liquid which contains solid particle, fibre and suspended matter.
含有固体颗粒、纤维、悬浮物的液体。
The group also studied particle pollution levels emitted from these sources, which are made up of a mix of tiny solid and liquid particles in the air.
这个组织同样对从这些源头释放出的颗粒污染水平进行了研究。它们由极小的固体和液体颗粒组成。
Drying is used to remove the liquid trapped in the solid structure of a particle.
干燥用于除去固体颗粒结构内的湿分。
The condensed phase particle size distribution affects the combustion chamber and nozzle efficiency of solid rocket motors to some extent.
凝聚相微粒尺寸分布对固体火箭发动机燃烧室效率和喷管效率有影响。
The relationship between the solid fuel particle size characteristic and the proportion between the fuel components in FAE and its microcosmic structure is set up.
建立了组分比例、固体燃料颗粒尺度的特性与固液混合燃料细观结构的相关性。
During the laser sintering, due to the large liquid phase viscosity and surface tension, the balling effect occurred when the molten did not wet the solid metal particle and the underlying substrate.
实验发现，在液相粘度较高、表面张力大，熔体材料不浸润固相颗粒和基板等因素的影响下，烧结过程中出现了球化现象。球化的出现妨碍了直接金属激光烧结成形的顺利进行。
Stochastic models can be used to approach the motion of a singular particle in the fluid, however, it is hardly expected to elucidate the mechanism of the interaction among the solid particles.
随机模型能用于研究流动中单个颗粒的运动，但很难解释固体颗粒之间相互作用的机制。
The structures of the gas solid two phase flow in the suspension bed were measured by a particle dynamic analyzer (PDA) at different apparent velocities for each of the nozzle structures.
用颗粒动态分析仪(PDA)测量了悬浮床内气固两相流动的结构，确定了不同表观气速和不同进气结构条件下的两相流场的特点。
The results showed that the solid particle became finer, more homogeneous and rounder with the decrease of temperature or the increase of shearing rate.
研究表明：适量提高剪切速率或降低温度，半固态组织的固相颗粒会变得细小、均匀和圆整。
In the model the exit area ratio, solid particle mass ratio, fuel enthalpy of combustion, jet gas molecular weight, chamber stagnation temperature, flight Math number etc. have been considered.
在该模型中考虑了底排出口面积比，排气固相颗粒质量比，燃料热值，燃气分子量，燃烧室总温，飞行马赫数等因素。
The performance of solid propellants depends on the solid particle size after dispersive mixing.
固体推进剂的性能将取决于分散混合后固体颗粒的尺寸。
The gas and particle phase in the gas solid two phase plane mixing layers flow is numerically simulated using the discrete vortex method and trajectory method respectively.
对气固两相平板混合层流动，采用离散涡方法模拟气相场，轨道法跟踪颗粒的运动。
When the solid particle was in slipping or jumping motion state in slurry flow, the solid particle will be influenced by frictional force.
沉降性浆体中固体颗粒处于滑跳移运动状态时，固体颗粒将受到摩擦力的影响。
The sizes of filler and abrasive have influence on the solid particle erosion of coating under the given condition, the size of filler be of weak influence on the slurry erosion.
填料粒度和磨料粒度都对涂层的气固冲蚀磨损有影响，但在给定的试验条件下，填料粒度对涂层的浆体冲蚀磨损影响甚微。
The effects of solid concentration and particle diameter on bubble collapse have been studied, and the particle motion during the bubble collapse has been observed and analyzed.
研究了颗粒浓度及粒径对空泡溃灭的影响，以及观察和分析了空泡溃灭过程中的颗粒运动。
The influences of various thin slurries with different solid particle sizes on filtration intensity are discussed.
实验研究了不同分级粒径对过滤强度的影响。
In the present study, higher power frequency makes the solid particle of the semi-solid AZ91D more spherical.
在试验范围内，随电磁搅拌电源频率的增大，半固态AZ91D合金组织中固相颗粒形态越来越圆整。
A charged particle moving through a gas or a solid produces ion pairs.
带电粒子通过气体或固体就产生离子对。
Spray granules were prepared by controlling the powder particle size and solid content of slurry.
通过控制料浆中粉料的粒度及料浆固含量，制成喷雾颗粒料。
应用推荐