At last we describe the software design, including software design of CPLD basing on VHDL and software design of DSP.
最后是软件部分的编程，包括CPLD部分的硬件描述语言程序设计，和DSP部分相关的程序设计。
We have realized the hardware and the software design of DSP high speed data acquisition system. Used the reasonable filter algorithm to increase the system data acquisition precision.
实现了DSP高速数据采集与监控系统的硬件和软件设计，采用了合理的滤波算法提高系统数据采集精度和实时性。
This paper introduces a method of hardware constitution and software design of embedded system containing Ethernet interface and adopting DSP as its core processor.
介绍了以DSP为核心具有以太网接口的嵌入式系统的硬件电路组成和软件设计方法。
This paper presents the hardware, software design and structure diagram of the DSP chip which improves the system stability and reliability.
文中给出系统硬件、软件设计结构和原理图，改善了原有光电测速精度，提高了系统工作稳定性和可靠性。
Introduction was made to basic structure and performance of DSP chip, giving out hardware design plan for induction motor vector control plan, software control algorithm.
介绍了DSP处理器的基本结构和性能，给出了感应电机矢量控制的硬件设计方案和软件控制算法。
The design of the emergency control equipment for frequency and voltage based on digital signal processor (DSP) is presented with the hardware build and the software frame mainly discussed.
介绍了一种基于数字信号处理器(dsp)的频率电压紧急控制装置的设计方案，重点阐述了系统的硬件搭建和软件框架。
This paper presents bushless DC motor servocontrol system based on DSP, then makes a brief about control strategy and design scheme of software and hardware that realizes this control system.
介绍了一种基于DSP的无刷直流电机伺服控制系统，简述了实现该控制系统的软件和硬件设计方案及控制策略。
The paper introduced fundamental principle of SVPWM technology, and gave a SVPWM control method of switching mode of switch determined by hardware based on TMS320F2407A DSP and its software design.
文章详细介绍了SVPWM技术的基本原理，并给出了一种基于TMS320F2407ADSP的由硬件决定开关切换模式的SVPWM控制方法及其软件设计。
This paper gives a design of sensor-less direct torque control system based on DSP (TMS320LF2407A). The hardware and software schemes are introduced.
提出了一种基于DSP（TMS320LF2407A）无速度传感器直接转矩控制系统，给出了硬件设计和软件设计方案。
This article introduces the DSP software design of the vehicle license plate snapping system and describes the achievement of the JPEG2000 compression.
本文主要介绍了车牌抓拍系统的DSP软件设计，并详细阐述了JPEG2000编码算法的实现。
The platform of blocking learning system using DSP technology and the design of the hardware module, software module and the building blocks experiment are also described.
该文介绍了自主模块化dsp技术的实验教学系统平台以及硬件模块、软件模块和积木式实验的设计。
The working principle, algorithm analysis and software design method of a simplified V. 23 2fsk modem based on DSP which is a kind of programmable chip are introduced in this article.
介绍了简易v .23二进制频移键控(2fsk)调制解调器的工作原理、算法分析以及基于可编程器件DSP的软件设计方法。
The paper mainly describes the design of the inverter, including circuit, DSP software design and PWM waveform generate theory.
重点叙述逆变器的设计，包括电路结构、DSP软件的设计、PWM波形的产生原理；
In this paper, a software implementation of picture product correlation algorithm based on TMS320C6000 DSP is presented. The design based on C6701 is introduced mainly.
提出了在TMS320C 6000系列DS P上实现图像积相关算法的软件方案，重点介绍C6701的设计方案。
Flexible setting of interrupt and DMA is adopted in the software design, which improves the efficiency of data transfer and performance of DSP.
在软件设计中，通过灵活设置中断与DMA，不仅提高了图像数据的传输效率，而且充分发挥了DSP的高速性能。
This paper describes hardware and software design of data acquisition system for UWB search and rescue radar, which adopts TMS320VC5509 as the core processor and is based on FIFO and DSP.
文中介绍了以TMS320 VC 5509为核心处理器，基于FIFO和DSP的超宽带搜救雷达数据采集系统的硬件和软件设计。
Design of the system driver, including the software of FLASH's erase and programming by DSP, BootLoader and the interface communicator between the DSP and the RTL8019AS.
系统部分驱动程序的设计，包括DSP对FLASH烧写和擦除的软件实现、程序的自举加载、DSP与RTL 8019as接口通信程序设计。
A kind of implementation of traffic signal controller based on DSP is suggested in this paper, and the detailed design of hardware and software is also introduced.
文中提出了一种基于DSP的交通信号控制机的实现方法，同时给出了具体的硬件、软件设计。
An example of multi-DSP chips' parallel processing system is discussed in this paper, which consists of 20 TMS320C31 chips, and the frame of hardware and software design are discussed in the meantime.
本文介绍了以20片TMS320C 31芯片组成的多dsp芯片并行处理系统的设计实例，并给出了系统硬件组成和软件设计。
A hardware design project concerning fuzzy in temperature control system based on DSP was introduced, emphasizing the importance of the software method applied to the fuzzy-PID controller.
介绍了基于DSP的恒温模糊控制系统的硬件设计方案，着重介绍模糊pid控制器的软件实现方法。
Taking the design of the industry on-line state detection Data Acquisition System as example, the paper discusses the main processes on the software and hardware design based on DSP and USB.
本文以应用于工业测试系统的在线状态检测数据采集系统的设计为例，讨论了基于DSP数字信号处理器和USB通用串行总线接口数据采集系统的软硬件设计的主要步骤和过程。
On the basis of hardware functions of DSP and the method of calculating the mover's position of PMSLM, the design of system hardware frame and software flow is completed.
在DSP硬件功能和电机动子位置估算方法的基础上，完成了系统的硬件架构设计和软件流程设计。
This topic is mainly done with DSP chip TMS320VC5509A as the core on the PCB board design and combined with the CCStudio software debugging board of each functional modules.
本课题主要是完成以DSP芯片TMS320 VC 5509a为核心的板卡的设计与结合CCS软件对PC B板卡的各功能模块进行调试。
Chaper4 describes the design of the hardware and software of the gripper controller based on DSP.
第四章介绍了基于DSP的手爪控制器的硬件和软件设计。
A kind of fingerprint acquisition system is presented based on DSP, in which composing, design and realization of hardware and software are introduced.
提出了一种基于DSP的指纹采集系统，主要介绍了系统的组成原理、硬软件电路设计与实现。
The function of ADS7811, interface circuit between ADS7811 and DSP (TMS320F206) and design of software are introduced in this paper.
文中介绍了ADS7811的功能和它与数字信号处理机的接口电路以及软件设计方法。
Surrounding the actualization of the algorithm, the author accomplished the main hardware and software design of the DSP target. The upper computer software has also been designed.
作者还以实现算法为中心，完成了主要的硬件设计和DSP目标板的软件系统的设计以及上位机程序的设计。
A new control mode of diamond pressure machine was introduced, which is embedded control system based on DSP (TMS320LF2407), also, hardware design and software design were introduced in this paper.
本文提出了一种金刚石压机的新型控制模式—基于DSP (TMS320 LF 2407)的嵌入式控制系统，并介绍了该控制系统的软硬件设计。
Chapter five discusses the software design and implementation of the DSP sub system.
第五章详细论述了下单元中的DSP子系统的软件设计和实现。
Chapter five discusses the software design and implementation of the DSP sub system.
第五章详细论述了下单元中的DSP子系统的软件设计和实现。
应用推荐