Sintering test on mix with addition of lime-boron slime was conducted.
进行了配加硼灰泥粉的烧结试验。
This paper describes the sintering test of adding fine ore of Australia in Pingxiang steel.
介绍了萍钢公司烧结配加某澳大利亚矿粉的烧结试验。
Temperature effect on the desulfurization of sintering process is investigated by mini-sintering test.
用烧结饼微型试验法研究了温度对烧结过程脱硫的影响。
The sintering test and production with addition of high-grade magnesia fine to replace the dolomite were conducted in ANGANG sintering plant.
介绍了在安钢原料条件下配用高镁粉的烧结试验及生产情况。
The sintering test and production with addition of high-grade magnesia fine to replace the dolomite were conducted in ANGANG sintering plant.
烧结试验是指导烧结厂设计和生产工艺条件优化的基础，也是烧结研究的重要组成部分。
The feasibility and economy of indus trial slag utilized for sintering production are investigated through sintering test and production practice.
通过烧结试验和生产实践，研究了工业废弃渣用于烧结生产的可行性和经济性。
The sintering pot test for sintering feed composition optimization was presented in this paper.
介绍了利用烧结杯进行优化烧结原料结构的试验情况。
The influence of iron materials, alkalinity, fuel consumption and moisture on sinter strength were studied through the sintering cup test and the drum index test.
通过烧结杯试验和对转鼓指数的测定研究了铁料、碱度、燃料消耗和水分等因素对水钢烧结强度的影响。
The experimental test, plant test and production practice of sintering with proportion of Mesa J iron ore were conducted in sintering plant, SOUGANG MINE Co.
就首钢矿业公司烧结厂进行的配加马萨杰矿粉烧结的实验室试验、工业试验和工业生产情况进行了系统介绍。
In the condition of laboratory test, sintering experiments were carried out with full limonite blend.
在实验室条件下，进行了全褐铁矿的烧结实验研究。
This article studies the influence of iron materials, basicity, fuel consumption and moisture on sinter strength through the sintering pot test and the tumbling test.
本文通过烧结杯试验和转鼓指数测定研究了铁料、碱度、燃耗和水分对水钢烧结矿强度的影响。
In this thesis, some test methods, such as Heating Microscope, DTA-TG, Thermal Dialation Testing, were used to research the sintering properties of cemented carbide in submicron grain, systematically.
采用高温显微镜、同步热分析、热膨胀实验等方法，系统的研究了亚微细硬质合金的烧结特性。
The test results show that sintering productivity is greatly increased, sinter strength is further improved as well as reducibility and reduction degradation index also changes better.
试验结果表明，烧结生产率大幅度提高，烧结矿强度进一步改善，烧结矿还原性及还原粉化指标也变好。
The test results show that hot- air sintering can increase sinter rate and tumbler strength, but decrease productivity.
试验结果表明，热风烧结可以提高钒钛磁铁精矿烧结矿的成品率和转鼓强度，但利用系数降低；
With sintering pot test it is found out the reasonable chemical component in sinter under the condition of Xuan Steel as well as the control range of various components for low-silicon sinter.
通过烧结杯试验，找出了宣钢原料条件下烧结矿合理化学成分、烧结矿低硅条件下各种化学成分的控制范围。
The reasons of high energy consumption on sintering machine No. 2 at Xiangtan I&S Co were discussed from the results of heat balance test.
根据湘潭钢铁公司（以下简称湘钢）2号烧结机能耗现状和热平衡测试结果分析了该烧结机能耗高的原因。
The selection and optimal amount of mineralizer in sintering cement clinker with coal gangue as one of raw materials instead of clay was studied by orthogonal test.
采用正交试验法研究了以煤矸石代替黏土烧制水泥熟料时矿化剂的选择及最佳掺量问题。
The problems of mineralizer selection and its optimal additive amount in sintering of gangue cement clinker using coal gangue instead of clay were studied by orthogonal test method.
采用正交试验法研究了以煤矸石代粘土烧制水泥熟料时矿化剂的选择及最佳掺量问题。
On the basis of the above test, we suggest that the crack propagation law for all electric porcelains depends on sintering composition of test materials, environment and loading conditions.
试验还表明电瓷材料静态疲劳裂纹扩展规律与材料的配方、环境和受力等因素有关。
This paper studied the sinter pot test of adding Robe River Ore to Ji - dong Concentrate under the sintering-operating condition of Tangshan Iron and Steel Company.
本文按唐山钢铁公司烧结工艺条件，对冀东矿配加罗伯河矿进行了烧结杯试验研究。
The results of plant test have indicated that the igniter is able to satisfy the sintering ignition requirements at Panzhihua Iron &Steel Co. , and result in significant energy saving efficiency.
经工业试验证明，该点火器能满足攀钢烧结点火工艺要求，并有明显节能效果。
The effect of sintering process and glass content on the coating properties was researched. A heat-resistant silicone resin is selected as a good coating of organic material by TGA and IR test.
将玻璃填料、有机硅树脂、溶剂等其它助剂按一定比例配制成高温涂料，进行耐高温性、柔韧性、干燥时间、附着力等性能的测试。
The effect of sintering process and glass content on the coating properties was researched. A heat-resistant silicone resin is selected as a good coating of organic material by TGA and IR test.
将玻璃填料、有机硅树脂、溶剂等其它助剂按一定比例配制成高温涂料，进行耐高温性、柔韧性、干燥时间、附着力等性能的测试。
应用推荐