The bearing loads and crankshaft fatigue strength are calculated according to the principle of a simple beam.
轴承负荷及曲轴疲劳强度的计算均按简支梁进行。
The effect of different mathematical models on lateral vibration analysis of multi-span simple beam bridge is discussed in this paper.
讨论了铁路多跨简支梁桥不同计算图式对横向振动分析结果的影响。
And numerical example is adopted to explain the influence of external prestress to the vibration frequency and modality for simple beam.
通过数值算例验证了体外预应力对简支梁桥振动频率和振动模态的影响。
The method unites non-prestressed concrete and prestressed concrete, simple beam and combining section beam in designing theories and methods.
该方法把无预应力混凝土与预应力混凝土构件、简单梁与组合截面梁的设计理论和方法统一起来。
The principal vibration of a simple beam with elastic supports was analyzed and the analytical formulation of normal vibration mode was derived.
给出了弹性支承桥梁和车体的振动方程并通过对具有弹性支座简支梁主振动的分析，得出了梁主振型的解析公式。
The result shows seven-freedom unit finite element method has high precision to analyse simple beam of rectangular section, it can replace complex analytic solution.
说明采用七自由度单元的有限元法进行矩形截面简支梁的弯翘分析，有很高的精度，可以代替繁琐的解析解。
Secondly, the equivalent plane truss element analysis program of plane stress problem is worked out, by which cantilever beam, simple beam and perforated wall are analyzed.
其次，编制了平面应力问题等效铰结平面桁架单元有限元法分析计算机程序。
Based on the definition simple beam, the finite element method is used to analyse some simple beams, with symmetric structure and loading, and symmetric beams, with different support.
从简支梁定义出发，应用有限元法，对结构、受力对称的简支梁以及不同支承的对称梁进行了计算。
Based on the simple beam theory, it analyzes the vibrancy character of straight-leg flexure structure, and derives the practical formula of this structure to calculate the resonance frequency.
运用梁的理论讨论了一种常见的结构——直脚型结构的振动特性，提出了计算结构谐振频率的实用算法。
CZM is used as a benchmark to check the precision and applicability of beam-bending method, such as SBT (Simple Beam Theory), CBT (Corrected Beam Theory) and ECM (Experimental Compliance Method).
本文采用内聚力模型作标准来判别各种基于梁弯曲理论的方法，这些方法包括简单梁理论、修正梁理论和实验柔度法。
CZM is used as a benchmark to check the precision and applicability of beam-bending method, such as SBT (Simple Beam Theory), CBT (Corrected Beam Theory) and ECM (Experimental Compliance Method).
本文采用内聚力模型作标准来判别各种基于梁弯曲理论的方法，这些方法包括简单梁理论、修正梁理论和实验柔度法。
应用推荐