Using the test signal method, a detailed analysis of subsynchronous oscillation for a HVDC system is performed.
对一个仅含有直流输电线路的系统，采用复转矩系数——测试信号法，对其次同步振荡特性进行了分析。
Finally, the paper simulated to the rotor initial point estimate method using DSP related tool and confirmed the accuracy of high frequency voltage signal method.
最后，利用DSP相关软件，对转子初始位置估算方法进行模拟仿真，验证了高频电压信号注入法理论的正确性。
Based on CC1000 wireless sensor networks development platform, the odometer location error is corrected by measuring RSSI parameter and using maximum signal method.
在CC 1000无线传感器开发平台上，对节点RSSI参数进行测量并采用最大信号法定点修正定位误差。
On the basis of this, injecting frequency conversion signal method on measuring capacitive current is selected to use here. It is reliable and its error is small, timeliness is good.
在此基础上，选择了对地电容电流测量的注入变频信号法，该测量方法具有测量误差小、实时性良好、安全可靠的特点。
By using test signal method, the sub-synchronous electrical damping characteristics of a generator and the impacts of the designed SEDC on the generators electrical damping are analyzed.
采用测试信号法，通过计算发电机组的次同步电气阻尼特性，分析所设计的SEDC对发电机组次同步振荡的抑制效果。
A new test signal method based approach to design power oscillation damping (POD) controller for TCSC is proposed, by which the bulky eigenvalue calculation of state matrix can be avoided.
提出了一种基于测试信号法的TCSC功率振荡阻尼(POD)控制器的设计方法，避免了计算量庞大的状态矩阵特征值计算。
A new test signal method based approach to design power oscillation damping (POD) controller for TCSC is proposed, by which the bulky eigenvalue calculation of state matrix can be avoided.
提出了一种基于测试信号法的TCSC功率振荡阻尼(POD)控制器的设计方法，避免了计算量庞大的状态矩阵特征值计算。
应用推荐