Main ferrosilicon, silicon slag, manganese, silicon carbide, Si-Al-Ba-Ca, Si-Mn alloy, silicon barium iron and other metal.
主营硅铁、硅渣、锰铁、碳化硅、硅铝钡钙、硅锰合金、硅钡铁等金属。
The productivity of cutting Si-Al alloy can be greatly improved by using cutter coated with diamond film in high-speed dry cutting.
金刚石薄膜涂层刀具高速干切削硅铝合金可提高生产率。
According to the characteristics of active filter, Fe-Si-Al is used and minimum volume method is adopted to optimize the design of inductance.
根据有源滤波的特点提出了采用铁硅铝作为铁心材料,利用最小体积法对电感进行了优化设计。
In this paper, the dry-cutting tests were carried out by diamond film coated tool on Si-Al alloy and this tool's cutting properties were studied.
文中通过用金刚石薄膜涂层刀具对含硅量不同的硅铝合金进行干切削试验,探讨其切削性能。
Using diamond film coated tool, the dry-cutting tests are carried out on Si-Al alloy with different Si-contained. The cutting properties are studied.
通过用金刚石薄膜涂层刀具对含硅量不同的硅铝合金进行干切削试验,探讨其切削性能。
Logging interpretation can estimate ash, Fe, Si and al contents in the coal seam.
测井解释能对灰分、铁、硅和铝含量作出评估。
Influence of some alloying elements on the electrical conductivity of al Si alloys was investigated.
研究了一些合金元素对铝硅合金电导率的影响。
Al Si alloy was widely used because of its good properties, Iron is the most common impurity in al Si alloy.
铝硅合金因其具有优良的性能而得到了广泛地应用,铁相是铝硅合金中最为常见的杂质。
In This paper, the influence of the cinder composition and the ratio between ca, si and al in raw materials on the autoclaved silicate products performance has been studied.
研究了炉渣的组成及原料的钙硅铝比对硅酸盐蒸压制品性能的影响。
The purification effect of Al-Si melt by composite refining technique was studied, the main existing form and its interaction of inclusion and gas in Al-Si melt were introduced.
研究了复合精炼对铝硅合金熔体的净化效果,并介绍了铝硅合金熔体中主要氧化夹杂物与气体的存在形态及其相互作用。
Based on the greenness idea, the greenization planning on the hypoeutectic cast Al-Si alloy is provided.
根据绿色化思想,对铸造亚共晶铝硅合金进行了绿色化规划探讨。
It reviews the optimization measures of Al-Si piston alloy, including kinds, chemical composition, grain refinement, modification, alloying and heat treatment.
评述了铝硅活塞合金的种类,化学成分,晶粒细化,变质处理,合金化和热处理工艺等优化手段。
The preparation of hypoeutectic Al-Si alloy billets for semisolid forming by low temperature casting was studied .
研究了低温铸造法制备亚共晶铝硅合金半固态成形用坯料。
The results have shown that heat treatment can improve the microstructure of the Al-Si base composite manufactured under case condition.
实验结果表明,热处理能改善铸态下制得的铝硅基复合材料显微组织形态。
The rare-earth luminescent materials coated with Si and Al were prepared by the sol-gel route.
采用溶胶-凝胶法制备硅铝二元膜包覆稀土发光材料。
Morphology transformation of eutectic silicon in Al-Si alloy during solid solution was observed by OM and SEM.
通过金相和扫描电镜观察研究了铸造铝硅合金中的共晶硅在固溶热处理过程中的形态变化。
The results of electrochemical experiments and moisture and hot experiments indicate that the electrolytic Al - Si alloy has excellent corrosion resistance.
电化学试验和湿热试验结果表明电解铝硅合金具有良好的耐蚀性。
Modification mechanism and existing form of Sb and Mg in Al-Si alloy were studied by using optical microscope and scanning electron microscope.
采用金相和扫描电镜分析研究了锑、镁在铝硅合金中的存在形式和变质机制。
The influence of side-introduced power ultrasonic treatment on the solidification characterization of ZL102 Al-Si alloy was discussed.
研究了功率超声处理对ZL102铝硅合金凝固特性的影响。
On the two materials, Al-Si alloy has greater platform stress and long platform region, the overall compression performance of Al-Si alloy is better than pure Al.
对上述两种材质而言,铝硅合金平台应力值较大,且平台区域较长,铝硅合金的压缩性能整体高于纯铝。
The primary silicon particles precipitating from the solidification of Al-Si hypereutectic alloy was regarded as inclusions.
将铝硅过共晶合金凝固过程中析出的初生硅颗粒视为夹杂物颗粒。
Using this technology, the smelting process of Al-Si alloy may be simplified. The technology reduces the overall cost which the Al-Si alloy is smelted while reducing loses and saving energy.
采用该工艺后,可减少一次铝硅合金的熔炼过程,在降低烧损、节省能源的同时,降低了铝硅合金熔炼的总体成本。
Hypereutectic Al-Si alloy which has small proportion, low coefficient of thermal expansion, good wear resistance and dimensional stability is an ideal piston material.
过共晶铝硅合金比重小、热膨胀系数低、耐磨性和体积稳定性好,是理想的活塞材料。
Hypereutectic Al-Si alloy with the quality of low density, good heat stability and high wear-resistance, is an ideal wear-resistant and heat-resistant material.
过共晶铝硅合金具有低密度、良好的热稳定性和高耐磨性,是一种理想的耐磨耐热材料。
Effects of high magnetic filed on Al-6wt % Si hypoeutectic alloy modification was studied.
研究了强磁场对亚共晶铝硅合金变质处理的影响。
The porosity and thickness affect markedly on the sound absorption property of Al-Si closed-cell aluminum foam: the sound absorption coefficient increases along with increasing porosity;
铝硅闭孔泡沫铝的孔隙率和厚度对其吸声性能影响显著:吸声系数随孔隙率增加而增加;
The results show that graphite with good corrosion resistance can protect the heat-exchange tube from the corrosion of molten Al-Si alloy.
结果表明,石墨良好的抗腐蚀性将保护换热管不受熔融铝-硅合金的腐蚀。
The results show that the higher the rotating speed of centrifugal casting machine with magnets is, the finer and more uniform the microstructure of Al-Si alloy is.
结果表明,在安装磁铁情况下,离心机转速越高,铝硅合金的组织越细小均匀。
The main spectral properties of Li-like Si soft-X-ray laser are examined theoretically based on the relevant experimental study Xu Zhizhan et al.
根据“类锂硅离子软x射线激光实验研究”一文,本文从理论上考察了该激光的主要光谱性质。
Three patterns of deoxidation and controlling methods of deoxidation products for Si-killed steel, Si&Al-killed steel and Al-killed steel are introduced.
介绍了硅镇静钢、硅铝镇静钢、铝镇静钢三种脱氧模式及脱氧产物的控制方法。
应用推荐