Decreasing the particle size is usually conducted by applying a shearing force.
通常使用剪切力减小颗粒粒度。
The distribution of storey shearing force in frame-shear wall structure is discussed.
讨论了框剪结构在弹性和弹塑性工作状态下楼层剪力的分配机理。
However, under cyclic shearing force, brick masonry also undergoes evident hysteretic behaviour.
其实,砌体在周期性剪力作用下具有显著的滞回性质。
The firmness, elasticity and shearing force of bread by rheometer during storage of bread were determined.
采用流变仪测定了面包在贮存期间的硬度、弹性及剪切力的变化。
It is concluded that exerting the vibration when shearing, the shearing force and work will be obviously decreased.
结果表明:剪切时施加振动,会显著减小剪切力和剪切功。
There was positive correlation between shearing force and acid detergent lignin, hemicellulose and cellulose content.
剪断力随着酸性洗涤木质素、半纤维素和纤维素含量增加而增大,呈正相关关系。
The vertical pressure acted on rod is also studied. Its size and distribution rules confirm the shearing force theory.
对拉杆上所受的垂直压力进行了研究,其大小及分布规律有力地验证了剪力理论。
Meanwhile, in the superposition beat shearing force wall, the precast block and the core concrete part can work cooperatively.
叠合板式剪力墙中,预制板与核心混凝土部分能够较好地共同工作。
Abstract: This experiment was conducted to study the correlations between shearing force and nutrient contents of cotton stem.
摘要本试验旨在研究棉秆剪切力与营养成分含量之间的相关关系。
Additionally, it is possible to generate shearing force by some factors like the change of temperature or support displacement.
另外,温度、支座位移等因素也可能引起较大的面内剪力。
For shearing force lag in outer tube, sections of beams in outer tube are augmented and sections of corner columns are adjusted.
针对外筒的剪力滞后,设计中尽量增大了外框筒裙梁的截面高度,并适当调整了角柱截面。
The theoretical design and calculation of the circular-section I-shaped beam shearing force sensor have been emphasized in this paper.
本文着重论述了圆截面工字梁剪力传感器的理论设计与计算。
Knurling machine is the key equipment to increase shearing force of the combined profiles of thermal barrier strips and aluminum alloy.
开齿机是提高隔热条与铝合金组合型材剪切力的关键设备。
If the compressive and tensile forces are greater enough to make the layers of the material slide upon each other, a shearing force results.
如果压缩力和拉伸力足够大,使得材料的各层次间相互滑移,那么就产生了剪切力。
The flume experiment shows that the low strength soil in the action of wave shearing force would slide, as the result, strong erosion happens on the bottom.
通过水槽实验发现,底床强度弱区的土体在波浪剪切力作用下,会发生整体滑动现象,造成床面的剧烈侵蚀。
The natural frequency of taper and top plate taper beam are calculated in detail, and the effect of shearing force in beam on the natural frequency is discussed.
具体地计算了圆锥形悬臂杆及平头圆锥悬臂杆的固有频率值,同时,讨论了剪力对固有频率的影响。
In order to make strength analysis, analog conversion method was used to obtain the shearing force, which could not be determined on the shearing machine directly.
为了进行强度分析,文中在剪切力的获取上采用了模拟转换方法,从而解决了在剪切机上不能直接得到剪切力的困难。
This paper introduces the bending moment and shearing force calculation formula of rudder and rudderstock according to the model required by classification society.
本文给出了按船级社规定的模型计算舵和舵杆中的弯矩和剪力的公式。
A new method for computing shear strength of reinforced concrete flat plate without shear reinforcement while transferring shearing force only is presented herewith.
提出了无剪切钢筋的钢筋混凝土平板在仅传递剪力时,其抗剪强度的计算方法。
The shearing force and overturning moment of column is reduced, and the shear force and moment at the top of pile is decreased compared with linear interaction system.
与线性相互作用体系相比,柱的剪力和倾覆力矩减小;桩顶的剪力和弯矩也有所减小。
The analysis includes the height of sloshing wave, the stress and the strain of the tank wall, the uplifting of the base plate and the base moment and base shearing force.
包括储液晃动波高,罐壁的应力和应变,底板的提离以及基底弯矩和剪力。初步分析了浮放储液罐的“象足”变形产生原因及破坏机理。
In this paper, the formula. of distribution coefficient of the counter-balancing shearing force in the structure of water gate is derived by method of mechanics of material.
借助于材料力学方法,从分析竖向力平衡入手,推导出不平衡剪力分配系数的计算公式。
This paper discusses the application of calculation formulas of high strength bolt connection in bearing type under the action of both shearing force and axial tensile force.
本文讨论了承压型高强度螺栓连接在同时承受剪力和杆轴方向拉力时其计算公式的应用。
The glass fiber reinforced plastic material prepared by the above process has high mechanical strength, large shearing force and bending strength, and good abrasion resistance.
由上述工艺制备出的玻璃钢材料具有机械强度高、剪切力和抗弯强度大和良好的耐磨性能。
This paper analyzes the relation between equivalent shearing force of elastic righting moment and bending tension for steel wire ropes, and the experimental method and results are also introduced.
分析了钢丝绳弯曲恢复力矩的等效剪力与抗弯拉力的关系,并介绍了实验方法和结果。
The plane and vertical distributions of sediment and its dynamical quota, sedimentary shearing velocity, sedimentary shearing force, erosive shearing force, solidification, rheological property, etc.
工程区沉积物的平面及柱状分布及其物理力学指标、沉速、淤积切力、冲刷切力、固结过程、流变参数等的实验测定。
The Field Pull-out Tests and Computation of Distribution of Shearing Force of Pressure-type Anchor;
分析了静水压试验过程中钢管的受力情况,简要介绍了试验压力计算公式的推导过程。
Shearing force, which is necessary in device inspection, increases with the die dimension, and challenges the reliability of back metallization process greatly.
剪切力是器件考核的基本项目,随管芯面积的增大而增大,这就对背面金属化可靠性提出了较高的要求。
Shearing force, which is necessary in device inspection, increases with the die dimension, and challenges the reliability of back metallization process greatly.
剪切力是器件考核的基本项目,随管芯面积的增大而增大,这就对背面金属化可靠性提出了较高的要求。
应用推荐