In the connection design of steel structure, the shear plate with high-strength bolt connection is extensively used at the flexible joint where the beam is connected to the weak axis of the column.
钢结构节点设计中，梁与柱弱轴方向的柔性连接常采用剪力板高强螺栓连接，螺栓群所承受的荷载有竖向力和偏心力矩。
The results showed that most multiaxial fatigue cracks were initiated and propagated along the direction of maximum shear plane or on the direction perpendicular to the tubular specimen's axis.
研究表明，多轴疲劳裂纹主要是沿最大剪切平面或垂直于管形试样的轴线方向扩展。
Radial stress, axis stress and shear stress at the critical interface regions are obtained and compared.
对各情况下的轴向、径向和剪切应力做了比较分析。
Field structure, microstructures and quartz C-axis analysis all indicate sinistral shear sense of the ductile shear belt.
野外构造、显微构造与石英C轴组构分析皆指示为左旋走滑韧性剪切带。
Analyses of the shear type and the three-dimensional deformation demonstrate that the QDSZ belongs to a lengthening-broadening shear zone with the lengthening quite obvious along the Y-axis.
剪切作用类型及三维参照变形分析表明，青邑韧性剪切带属加长-变宽类型的一般剪切带并且在Y轴方向上有所增长。
Maximum shear stress generally takes place at the neutral axis of ship section.
最大剪应力通常发生在剖面的中和轴处。
On the base of the general theory of thin-walled members, we deduce a new critical moment formula of steel beam under transverse loads which pass the shear center and parallel to the main axis.
就国内现有的薄壁钢梁弯扭失稳理论进行了分析，从薄壁杆件的一般理论出发，推导出荷载过截面弯心并与主轴平行的受弯钢梁的临界弯矩公式。
The results show that strength of NEPE solid propellant under multi-axis stress state is related to strain; octahedral shear stress nonlinearly increases with the average main stress.
研究表明，多轴应力状态下NEPE固体推进剂强度与应力相关，八面体剪应力随平均主应力的增加呈非线性增加；NEPE推进剂的破坏强度随拉伸速率的增加而提高。
This paper presents oblique-optical-axis shear speckle method.
本文提出了斜光轴剪切散斑干涉法。
Shear yield stress was defined as the intercept point on the Y-axis.
剪切屈服应力被定义为Y轴上的交会点。
Axis symmetrical pure radial and pure shear vibrations were investigated theoretically for disk concentrators, whose thickness varying step-wise, linearly or exponentially with radial distance.
理论上研究了盘形聚能器的轴对称纯径向振动和纯扭转振动。所用盘形聚能器的厚度，沿半径按阶梯形，锥形和指数形变化。
Axis symmetrical pure radial and pure shear vibrations were investigated theoretically for disk concentrators, whose thickness varying step-wise, linearly or exponentially with radial distance.
理论上研究了盘形聚能器的轴对称纯径向振动和纯扭转振动。所用盘形聚能器的厚度，沿半径按阶梯形，锥形和指数形变化。
应用推荐