This is the most suitable arrangement when there is mounting error or shaft deflection .
这是最合适的安排，当越来越多的错误或轴偏转。
Bearings with logarithmic profiles are less susceptible to shaft deflection and misalignment.
有对数轮廓的轴承对歪斜和角误差不太敏感。
Single units are suitable for standard linear movements or where there is a severe shaft deflection.
单单位适合标准线性运动或那里是一个严重的轴偏转。
With a number of examples the paper introduces a safe, reliable, easy and cost-effective method for correcting stern shaft deflection.
本文结合实例介绍了一种安全、可靠、省时、省钱的纠正尾轴弯曲超差的方法。
The entire rotating assembly shall be designed with sufficient rigidity for minimal shaft deflection at extreme pump operating conditions.
整个旋转总装都应该具有足够的硬度，即使在极端的泵运行环境下，所产生的轴偏差也是最小的。
Self-aligning Ball Bearings are particularly suitable for applications where misalignment occurs from errors in mounting or from shaft deflection.
调心球轴承特别适合应用在从安装偏心或轴挠度的错误发生。
Rotational deformation of the shaft will produce maximum deflection.
转动的泵轴会弯曲变形，产生最大挠度。
The shaft shall be guided by glass-filled TFE bearings to protect against deflection.
阀杆应该由玻璃填充TFE轴承引导以确保不会偏移。
The paper has studied straightening stress and residual deformation of circular shaft by using elastic - plastic theory, deueloped calculation formula of straightening loud in given deflection error.
从弹塑性理论出发以圆截面轴为例对校正应力与残余变形进行了分析研究，提出了在给定弯曲误差下的校正载荷的计算公式。
Axis line deflection and asymmetric load distribution of the rotary kiln induce the cracking of supporting shaft frequently.
回转窑运行中由于轴线偏移，支承载荷分配不均导致托轮轴疲劳断裂。
The deflection Angle of the long shaft of the oval relative to the aspiration hole is preferably 10 degree at both sides.
该椭圆的长轴在吸气孔附近，相对于吸气孔的偏转角度较佳为两侧各10度范围内。
This paper puts forth the calculating formula of the deflection caused by shear distortion, which has a reference value to the design of the main shaft of the machine tool.
本文给出了考虑剪切变形引起的挠度计算公式，对现代机床的主轴设计具有一定的指导意义。
It was shown that computed bending moments along pile shaft and deflection occurred at pile top are consistent with the measured ones.
桩身弯矩和桩顶位移的计算值与实测值基本符合。
It was shown that computed bending moments along pile shaft and deflection occurred at pile top are consistent with the measured ones.
桩身弯矩和桩顶位移的计算值与实测值基本符合。
应用推荐