A few of them were made for histological and SEM observation.
对部分样品进行组织切片和扫描电镜观察。
The SEM observation shows that thermal fatigue is the major cause of the failure of the ste…
电镜观察显示热疲劳是硬质合金热挤压模具失效的主要原因。
The SEM observation indicated that the xylanase could improve the fibers swelling and softening.
纤维的SEM观察表明，经木聚糖酶处理的浆纤维更为柔软润胀。
The SEM observation demonstrates that microscopic fracture mechanisms of these three magnets are different.
扫描电镜断口观测显示不同磁体微观断裂机制不同。
The SEM observation shows that thermal fatigue is the major cause of the failure of the steel hard alloy die.
电镜观察显示热疲劳是硬质合金热挤压模具失效的主要原因。
Typical samples were tested and characterized by four-ball tester, optical microscope, XRD and SEM observation.
采用四球试验机、光学显微镜、XRD、SEM等分析手段进行了测试与表征。
SEM observation showed that the surface of 1420 Al-Li alloy turn colors, and rust spot become bigger after salt corrosion.
电镜扫描观察发现，1420铝锂合金锈点直径较大，且连成片，表面明显变色。
Anatomical characters and SEM observation of glands revealed that the glands of leave in Cerasus was one kind of secretory tissue.
对樱属植物叶腺体结构与形态作了解剖和扫描电镜观察，证实腺体属于分泌组织。
SEM observation shows that the typical cavities are obvious in fracture surfaces of tensile samples after superplastic deformation.
利用扫描电镜观察断口发现典型的超塑性空洞形貌特征。
SEM observation showed that collagen sponges were adhered on the pores of the scaffolds and apatite was deposited on the collagens…
对材料形态的观察表明，胶原贴附在孔隙中，钙磷盐沉积在胶原上。
SEM observation showed that collagen sponges were adhered on the pores of the scaffolds and apatite was deposited on the collagen sponge.
对材料形态的观察表明，胶原贴附在孔隙中，钙磷盐沉积在胶原上。
Ac- cording to the above test results and SEM observation, it seems that the durability of vinylon fibre in cement matrix is satisfactory.
上述试验结果与扫描电镜观察均证明，维纶纤维在水泥基材中有良好的耐久性。
SEM observation revealed that puffy coking charred layers were formed by lots of closed bubbles in ABS specimen filled with IFR after burning.
扫描电子显微镜观测发现，经IFR阻燃的ABS在燃烧时形成了由无数封闭孔洞构成的蓬松焦化炭层，表明IFR对ABS具有良好的膨胀阻燃效果。
The effect of denitrification on the surface configuration and chemical composition of PBS was analyzed by using IR spectrum and SEM observation.
利用红外光谱和扫描电子显微镜对反硝化生物膜生长前后pbs颗粒表面形态、化学组成的变化进行了分析。
SEM observation showed that collagen sponges were adhered on the pores of the scaffolds and apatite was deposited on the collagen sponge. Tests...
对材料形态的观察表明，胶原贴附在孔隙中，钙磷盐沉积在胶原上。
The structure of spheroidal carbide in wear resistant white iron was investigated by SEM observation and EPMA of ion etched metallographic specimen.
用离子蚀刻加扫描电镜观察和微区成分分析的方法研究了耐磨白口铁中球形碳化物的结构。
Kinetics of hydrothermal reaction in lime-sand system was investigated by means of quantitative phase analysis, SEM observation, and compressive strength measurement.
本文采用定量相分析法测定灰砂系统水热反应的水化物，并通过SEM观察及试块强度测定等研究了灰砂系统水热反应动力学。
The composites showed well interconnected pore structure and homogenous distribution of CS and PLA as the PLA volume fraction was not higher than 50% by SEM observation.
SEM观察表明，控制PLA的体积分数不高于50%，则复合材料的孔隙结构相互贯通，CS和PLA分布均匀。
The cyclic voltammetry, the linear sweep, SEM observation and surface analyzing technology were used to study non uniform characters of valve regulated lead acid battery.
采用循环伏安、线性扫描、电镜扫描观察及表面能谱分析等方法对阀控密封铅酸蓄电池的板栅部分不均衡性进行了研究。
SEM observation showed that collagen sponges were adhered on the pores of the scaffolds and apatite was deposited on the collagen sponge. Tests show that the hybrid st...
对材料形态的观察表明，胶原贴附在孔隙中，钙磷盐沉积在胶原上。
The effects of particle volume fraction, tensile rate and interface bonding strength on the properties of GB/HDPE composites were studied by tensile test and SEM observation.
通过GB／HDPE的拉伸实验和断口形貌分析，研究了颗粒体积分数、拉伸速率、界面强度对GB／HDPE复合材料力学性能的影响。
Based on amino-acid composition determination, fungus testing, and SEM observation, the result shows that the elemental reason of the brittle silk forming is the fungus growing.
通过氨基酸成分测试、霉菌测试、电镜观察等项试验，表明霉菌是产生脆弱丝的基本原因。
A statistic analysis of lithology, thin section, SEM observation and mercury injection data reveals the physical properties and pore structures of the reservoirs in the study area.
通过对研究区岩性数据、薄片、扫描电镜以及压汞实验资料的统计分析，对储层的物性特征和孔隙结构进行了研究。
The room temperature and high temperature mechanical properties of the composites were studied, and the fracture behavior of the composite was investigated by in-situ SEM observation.
测试了材料的室温与高温性能；通过SEM动态原位拉伸试验研究了复合材料的断裂过程；
The surface morphology progression of grey cast iron due to cavitation erosion induced by tap water has been studied carefully by cavitation corrosion test and SEM observation in turn.
采用空泡腐蚀与定位跟踪观察交替进行的方式，研究了灰口铸铁在自来水中空泡腐蚀过程的表面形貌演变。
The SEM observation considered that the pulverization and oxidation of hydrogen storage alloys during charge discharge cycles was a important factor of the degradation of MH electrodes.
扫描电镜(SEM)观察认为，贮氢合金在充放电过程中的不断粉化和氧化是贮氢电极失效的主要原因。
This paper discusses the effect of mechanical treatment on pulp properties during medium consistency fluidization by the measurement of the pulp properties and SEM observation of the fibers.
本文在对中浓纸浆进行流体化处理后，对纸浆的主要性能参数进行检测，并通过扫描电镜观察了纤维形态的变化，从而了解中浓纸浆流体过程对纸浆性能的影响程度。
This paper discusses the effect of mechanical treatment on pulp properties during medium consistency fluidization by the measurement of the pulp properties and SEM observation of the fibers.
本文在对中浓纸浆进行流体化处理后，对纸浆的主要性能参数进行检测，并通过扫描电镜观察了纤维形态的变化，从而了解中浓纸浆流体过程对纸浆性能的影响程度。
应用推荐