SEM analysis showed that silicon dioxide occupied free space of wood.
SEM分析表明，二氧化硅凝胶存在于木材细胞空隙中。
Corrosion inhibitory properties of the compound were studied by SEM analysis.
通过电镜分析表明合成产物对金属有较好的缓蚀效果。
The results above have been shown by the SEM analysis and the optical instrument measurements.
上述效果从SEM分析和光学仪器测试中得到了证明。
The slag corrosion resistance of the Al_2O_3-MgO castable is investigated by SEM analysis method.
利用SEM分析手段研究了铝镁浇注料的抗渣性能。
SEM analysis of fragments section show that their formation is mostly caused by the shear fracture.
利用扫描电镜对破片断面进行分析，发现破片的形成主要由剪切断裂造成。
Through the experiments and SEM analysis, the effect of processing parameters on porous structure was studied.
论文通过正交实验分析和电镜照片分析，讨论了实验工艺参数对样品孔结构的影响。
The SEM analysis of the cross-section of the carbon membrane shows a good combination between the support and membrane.
扫描电镜对炭膜断面微观形态观察表明，膜层与支撑体之间结合良好。
Appearance of coatings is furrow at low Angle of incidence, it is notch at high Angle of incidence through SEM analysis.
对冲蚀后的涂层进行扫描电镜分析表明，在小攻角下涂层形貌呈犁沟或犁皱形状，大攻角涂层形貌呈凹坑状。
According to the SEM analysis, the influencing factors on the particle size and the appearance of the powder were analysed.
以SEM分析为依据，对影响水解产物形貌、粒度及粒度分布的因素进行了研究。
XRD and SEM analysis indicate that the modified alloy is amorphized to some extent besides of the reduction of particle size.
XRD和SEM分析表明： 球磨后合金颗粒粒径减小， 且有明显的非晶化趋势；
SEM analysis indicated that the morphology of fibers changed regularly with increase of PVP concentration and applied voltage.
SEM分析表明：随浓度和电压不断升高，纤维形貌呈现规律性的变化。
The SEM analysis show that this difference is due to the surface structures of the fruits and the structure of the coating films.
扫描电镜分析表明，最佳配方上的差异与果实的表皮结构及涂膜的结构有关。
Failure analysis on the exhaust valve skirt used in supercharge diesel engine was carried out through metallographic and SEM analysis.
利用金相及扫描电镜对增压柴油机排气门盘部断裂原因进行了分析。
SEM analysis indicated that there was remarkable toughness fracture surface morphology for the epoxy resin system modified with ESBSVP.
SEM结果表明，经ESBSVP改性的环氧树脂体系断面呈现出明显的韧性断裂特征。
The SEM analysis has been used to study the bacterial form and interface action status in the course of reaction between dusts and bacteria.
同时通过SEM分析对粉尘与细菌作用过程中细菌形态和界面作用的情况进行了研究。
The SEM analysis results also show that the pore of hollow-porous carbon fiber regularly varies as the carbonization heating rate increases.
SEM分析显示，随着炭化升温速率的升高，纤维的截面变形程度加剧，孔径增大。
SEM analysis showed that the crystal structure of a good size is about 200 nm or so, XPS analysis showed the traces of manganese, near-ideal theory.
SEM分析表明其晶体结构良好，粒径大约在200纳米左右，XPS分析表明含有微量的三价锰，近乎于理想的理论计算。
SEM analysis of tensile rupture interface also indicates that two fibers with PMMA matrix bind not well, but their composites have good mechanical...
拉伸断裂界面的的SEM分析也表明二种纤维与基体的粘接状态不好，但复合材料同样具有良好的力学机械性能。
The conclusion on the wear mechanism of the composite by the debris topography analysis is coincident to that of the SEM analysis on the worn surface.
通过磨屑形貌分析和对磨损表面的观察与分析所得的关于复合材料的磨损机制的结论是一致的。
The IR spectrum and SEM analysis demonstrated that the graft monomers were bound to the fibers by the ways of physical deposition and chemical bonding.
通过红外光谱和扫描电镜分析，接枝单体是依靠物理沉积和化学键作用与纤维结合的。
The result of SEM analysis shows that, within the same holding time, with normalizing temperature increasing, the layer-mesostructure is denser and denser.
扫描电镜分析表明：在相同的保温时间内，随正火温度的升高， 片层状珠光体越来越密集。
SEM analysis of tensile rupture interface also indicates that two fibers with PMMA matrix bind not well, but their composites have good mechanical property.
拉伸断裂界面的的SEM分析也表明二种纤维与基体的粘接状态不好，但复合材料同样具有良好的力学机械性能。
Through quantitative and SEM analysis, the minim zinc was found remaining on the surface of weld and the zinc thickness on the heat-affected zones appeared gradient.
定量及SEM分析表明，焊缝中表面只残留少量锌，在焊缝两侧的热影响区，锌层厚度呈梯度分布。
SEM analysis identifies spherical particles as well as irregular particles in both dust and topsoil, which indicates input of magnetic particles derived coal combustion.
扫描电镜分析表明，除了不规则的磁性颗粒外，尘土与表土中均发现了球状颗粒，说明二者均含有来自工业燃煤释放的磁性颗粒。
SEM analysis reveals that the amount and structure of the coupling agent, the structure of PAA and the content of SiO 2 all affect the microstructure of the hybrid films.
扫描电镜分析结果表明，杂化膜的微观相结构与二氧化硅的含量、偶联剂的加入有关。
Failure analysis of parietal cracking in scavenging pump made of die casting aluminium alloy was carried out by means of metallographic examination, SEM analysis and so on.
借助金相显微镜、扫描电镜等分析手段，对压铸铝合金清洗泵腔壁断裂失效的原因进行了分析。
Samples of SEM analysis showed that the preparation of aerated concrete hydration products have great difference between standard maintenance and thermal curing maintenance.
样品的SEM扫描电镜分析结果显示，通过标准养护和热养护制备的加气混凝土的水化产物有很大的差异。
The SEM analysis shows that the PCR particles are single continuous particles, which shows that the PCR particles are coagulated from the single polychloroprene rubber latex drops.
SEM分析表明，采用逆凝聚包覆法制备的PCR粒子为单颗连续粒子，说明产物粒子是由单颗的胶乳液滴凝聚而成。
SEM analysis shows that there are lots of fine cracks on the rough sample, but oxides are not detected, while the surface of the polished samples is integrity after heat processing.
SEM分析表明，粗糙表面镀金膜的试样在热处理后，表面薄膜产生了细小的裂痕，但在表面没有探测到氧化物。
SEM analysis shows that there are lots of fine cracks on the rough sample, but oxides are not detected, while the surface of the polished samples is integrity after heat processing.
SEM分析表明，粗糙表面镀金膜的试样在热处理后，表面薄膜产生了细小的裂痕，但在表面没有探测到氧化物。
应用推荐