Second, the calculation formula of radial rigidity is deduced according to the deformation of rollers under the radial load with axial position preload.
其次，由轴向定位预紧轴承受径向载荷时各滚子的变形，推导出轴承的径向刚度计算公式；
The second kind of model is complete coupling one and this model includes the coupling temperature field equation, fluid coupling seepage model equation, rock coupling deformation equation.
第二类模型为完全耦合模型，包括耦合温度场方程、流体耦合渗流方程和岩石耦合变形方程。
A new phenomenon of re-dissolution of second phases and re-formation of supersaturate solid solution found in processes of severe plastic deformation was summarized.
综述了在室温强塑性变形过程中发现的新现象：第二相颗粒的回溶，合金基体重新形成过饱和固溶体。
Second, the elastic deformation, the elastic stress distribution, and the local and global elastic buckling modes were calculated and presented.
其次，计算并描述了槽型舱壁在侧向水压力作用下的弹性变形与弹性应力分布，以及舱壁局部与总体弹性屈曲模式。
Second, the thickness of the wooden door, attention is not handle the thin the lighter the better, the suitable for 42mm thickness of wooden door, such 65mm - not easy deformation.
注意木门的厚度，木门不是手感越薄越轻越好，木门的合适厚度为42mm-65mm，这样的门不容易变形。
At the time of deformation reached 40%, the appearance of the crystal changed greatly: the size refined, boundary turned clear, second phase disappeared and twin crystal structure appeared.
变形量为40%时，轧板的晶粒形貌发生了显著变化，晶粒变得细小，晶界清晰，第二相完全消失，并出现孪晶组织。
The deformation before aging can increase the defect's quantity in the alloy, and accelerate the precipitating of the second phase.
而时效前冷变形可以增加合金内部位错等缺陷的数量，加速了合金第二相的析出。
The second episode is characterized by NW-SE direction compression-shortening deformation with formation of two conjugate fracture cleavages or kink bands.
第二期为平行造山带的挤压缩短变形，形成区域透入性共轭破劈理或膝折带。
The first lateral deformation nearly equals half of the second one.
得出第一横向变形约为第二横向变形的百分之五十。
With the increase of deformation temperature, thick second phase reduces, the strength of T6 alloy increases, but plastic decreases first and then increases.
变形温度升高，合金中的粗大第二相减少，T6态铝合金强度随变形温度的升高而增大，塑性则先降低后增加。
On the second place, detailed analysis was implemented for the pipe end deformation process during mechanical expanding, and forming criterion was also obtained.
详细分析了管端机械扩径的变形过程，总结了机械扩径成形条件；
The area has undergone six stages of tectonic deformation with the second episode of Caledonian Movement (D_2) and the fifth episode of Himalayan Movement (D_5) as the most important ones.
该区经历了六个构造形变期，以相当于 主加里东期的第二期（D_2）与喜马拉雅期的第五期（D_5） 形变期最为重要。
The impaction of long blade with high energy can cause large deformation and the blade will curl as U shape and tear the wall of the containment ring at the second impact position.
高能量长叶片撞击将形起大变形，叶片弯曲成U形，机匣在第二次撞击处被撕裂击穿。
In the second part, the deformation curvature, which is determined by second derivative of curve fitting of the deformation of the retaining structure, is proposed.
提出由曲线拟合围护墙变形，两次求导后得到变形曲率。
The rocking is the main part of seismic acceleration at the top of super structure, the swing takes the second place, and elastic deformation is quite small.
上部结构柱顶加速度反应主要由基础转动引起的摆动分量组成，平动分量次之，而弹性变形分量很小。
The method for the additional deformation of the bar with initial stress was modified, by using a second-order deformation theory.
第八章讨论了上述理论的应用范围，提出了用二阶理论改进的方法。
In order to compute bulging of wide face of continuous cast slab, it is necessary to solve a third order differental equation for creep or a second order one for elastoplastic deformation.
连铸板坯宽面鼓肚对铸坯中心偏析和裂纹有较大影响，为计算板坯宽面鼓肚，按蠕变规律，需解一个三阶微分方程，按弹塑性规律，需解一个二阶微分方程，十分费时。
Furthermore, the second-order effect and shear deformation of the structures were magnified due to semi-rigid connections, the ultimate load resistance of the structures was reduced simultaneity.
半刚性连接还对结构的二阶效应及剪切变形的影响起放大作用，降低结构的极限承载力。
The structure change of Zinc coating after deformation has also been investigated. The second adhesion mechanism duri...
还研究了镀层受力变形后的结构变化，并提出二次粘附成型机理。
Special attention was paid on the microstructure evolution and mechanical properties of the ECAP samples. Deformation twins were found in most grains after the first and second pass of ECAP.
文中主要研究了工业纯钛在室温下进行ECAP多道次变形的组织结构演变，并测试了变形试样的力学性能。
Special attention was paid on the microstructure evolution and mechanical properties of the ECAP samples. Deformation twins were found in most grains after the first and second pass of ECAP.
文中主要研究了工业纯钛在室温下进行ECAP多道次变形的组织结构演变，并测试了变形试样的力学性能。
应用推荐