Amorolfine hydrochloride ethosomes showed a slow release rate.
盐酸阿莫罗芬醇质体释放速度较慢。
HA with a specific targeting property could increase the bioavailability of paclitaxel and control the release rate of the drug.
既利用透明质酸对癌细胞的靶向性，提高了紫杉醇的生物利用度，又达到了药物缓释的效果。
Finally, it is demonstrated that the increase of nitrogen content in propellant formulation is an important approach to raising the energy release rate at low pressure.
最后，论证了适当增加配方中的氮含量是提高低压下能量释放率的重要途径。
An energy method for determining fracture toughness of fibrous composite laminates was based on the theory of elastic energy release rate and crack-growth resistance in this paper.
应用线弹性断裂力学的弹性能释放率及裂纹扩展阻力等基本概念和理论，建立起确定纤维增强高分子聚合物复合材料断裂韧性的能量方法。
The solutions are compared with the energy release rate of linear elasticity.
解答与线弹性的能量释放率进行了比较。
RESULTS:The granularity, water content and release rate met the requirements.
结果：本品的粒度、水分、释放度等均符合规定。
At last, the boundary collocation method is used to calculate the energy release rate.
最后，用边界配置法计算了能量释放率。
This model is based on gas release rate and jet fire model to estimate the hazard area.
该模型是基于气体释放速率和火灾模型来估计危险影响区域的。
Aim To prepare puerarin enteric nanoparticles and investigate their release rate in vitro.
目的制备葛根素肠溶纳米粒，并对其体外释放度进行考察。
The equations of loading and bounding surfaces are described in strain-energy release rate.
加载面、边界面方程均以损伤能量释放率表示。
METHODS High molecule polymer excipient was used in the process and release rate was determined.
方法：用高分子化合物作辅料制备缓释片，测定释放度。
OBJECTIVE To prepare vitamin C sustained-release tablets and determine their in vitro release rate.
目的：研制维生素c微囊并制成缓释片剂，评价其体外释放特性。
Objective: To study the in vitro release rate of ambroxol HCl osmotic pump controlled release tablets.
前言：目的：研究盐酸氨溴索渗透泵控释片的体外释放度。
Objective To investigate the release rate and pharmacodynamics in vitro of of vincristine sulfate liposomes.
目的考察硫酸长春新碱脂质体的体外释放度及其药效。
The formulas for radiation densification, swelling, fission gas release rate and transient release are given.
给出了辐照密实、肿胀、裂变气体释放率和瞬时释放表达式。
To perfect the calculation, we calculated the heat release rate with the actual diagram of work after testing.
样机试验后，再根据实测示功图来计算放热率，从而完善了计算。
Numerical solution of these equations yields the intensity factors and the energy release rate at the crack tip.
求解这些方程组，获得了裂纹尖端的强度因子和能量释放率。
In the case of constant load, the energy release rate will increase with time until it reaches a higher limit value.
在常载荷的情况下，能量释放率将随时间而增长，直到它达到某一较高的极限值。
In addition, mass loss rate was not the only parameter influencing heat release rate in cone calorimeter for agaric.
同时，木耳的质量损失速率不是影响其热释放速率的惟一因素。
In the case of constant displacement, the energy release rate will decrease with time, until it reaches a lower limit value.
在常位移的情况下，能量释放率将随时间而减少，直到它达到某一较低的极限值。
Objective to study on the factors involved in the release rate of metformin hydrochloride in vitro sustained-release tablets.
目的对盐酸二甲双胍缓释片体外释放度相关因素进行研究。
The control of auto-ignition time and heat release rate is the most difficult technical question in realizing HCCI combustion.
但HCCI燃烧存在运转范围窄、着火时间和放热率不好控制等缺点，具体实施上还有许多困难。
Results: The release rate of ambroxol hydrochloride osmotic pump controlled release tablets prepared was conformed to requirement.
结果：制得的盐酸氨溴索渗透泵控释片释放度符合要求。
Disturbances in the recirculating flow regime can produce related variations in the heat release rate in the primary mixing region.
回流区域内的扰动可使主要混合区内热量释放发生相应的变化。
The varying tendencies of mass loss rate, temperatures of each point, and CO concentration were all consistent with heat release rate.
质量损失速率、各点温度以及产物一氧化碳浓度变化曲线均与热释放速率曲线的变化趋势保持一致。
For the paraffin wax -natural rosin coated urea, the ratio of paraffin wax to natural rosin is of major importance to the release rate.
就石蜡-天然松香包膜尿素而言，包膜层中石蜡和天然松香的配比是影响石蜡-天然松香包膜尿素养分释放速率的重要因素。
The energy release rate and failure criterion for mixed mode are investigated by means of the method of equivalent linear crack extension.
利用当量直线裂纹扩展法研究复合型裂纹的能量释放率及相应的断裂判据。
Some heat release rate formulas are added to the application software for calculation on the properties of the fire smoke flow in building.
将各种非稳态火源热释放速率计算式嵌入建筑物火灾烟流性状预测软件并进行了算例验证。
The expression of energy release rate is deduced by means of the path-independent M-integral, and corresponding numerical results are given.
利用与路径无关的M积分导出能量释放率表达式并给出相应的数值解。
Heat release rate of the fire is calculated and the distribution of temperatures and concentration of carbon monoxide of smoke are discussed.
计算了火灾释热速率以及着火大空间烟气的温度场和一氧化碳浓度场的变化。
应用推荐