Developed excogitates of two decumbence and one hovizoutal molding die realized increasing height of branch pipe of heat pressure tee and reducing radius of synodical arc of tee.
研制出两套立式模具和一套卧式模具，实现了用工艺方法增加热挤压三通支管高度，缩小三通相贯区内拐角处圆弧半径的目的。
The optimization of drawing technique was researched, and the influence of different blank holder force and minimum die fillet radius on stamping forming was studied as well.
对该零件成形工艺进行了优化，研究了不同的压边力、最小模具圆角半径对冲压成形的影响，通过对模拟结果的分析得出了空调前板的最优化成形方案。
NIB : Green roller defect on the small end radius; caused by taper die failure. A sharp protrusion on the small end of the roller.
由于圆锥模具缺陷造成的半成品滚子小端倒角缺陷， 滚子小端有尖锐的突出。
Die structure based on the process of forming small fillet radius is introduced, and deduced the formula according to the principle of volume invariably.
介绍形成小圆角半径的圆孔翻边模具的结构特点，按体积不变的原则，推导了计算公式。
The radius of the punch and die cutting edges is laid out to produce the desired circular shape without nicking into the circle as the work proceeds.
在工作过程中，冲头与凹模切口的半径定位，确保形成所需的圆形，而不至于在圆边产生“缺口”。
The influences of die radius, load and temperature on the flow properties of FEP melt were investigated by using a melt flow indexer.
应用熔体流动速率仪考察了口模半径、载荷及温度对聚全氟乙丙烯（FEP）流动性能的影响。
It is found that with the increase of the material strength, the tendency of wrinkling increases. The die radius has the largest effect...
随着材料强度的增加，倒角半径对起皱的影响降低，压力和翻边高度对起皱的影响增加，模具半径对起皱的影响最大。
The springback Angle increases with the increase of the punch round radius and clearances between the punch and the die while decreases...
回弹角随凸模圆角半径和凸凹模间隙的增大而增大，随压边力、板料厚度、摩擦系数和材料硬化指数的增大而减小。
The springback Angle increases with the increase of the punch round radius and clearances between the punch and the die while decreases...
回弹角随凸模圆角半径和凸凹模间隙的增大而增大，随压边力、板料厚度、摩擦系数和材料硬化指数的增大而减小。
应用推荐