Effect of water quench process on tensile properties of microalloyed dual phase (DP) steel was investigated.
研究了水淬工艺对微合金双相钢组织和力学性能的影响。
Effects of cold drawing and water quench process on mechanical properties of prestressed wires have been studied in laboratory.
在实验室条件下研究了冷拔与水淬火工艺对予应力钢丝力学性能的影响。
Effects of cold drawing and water quench process on mechanical properties of prestressed wires have been studied in laboratory.
研究表明碳素钢予应力钢丝采用水淬火取代铅浴进行索氏体化处理是可行的。
By this simulation, the primary characteristics of quench process are revealed, and the main causes making quench ring damage have been found.
通过模拟揭示了激冷过程本质特征，探讨了现行激冷环损坏的主要原因。
It is difficult to directly measure the surface temperature of the probe due to the complexity of heat transfer behavior on the probe surface in quench process.
由于淬火过程中探头表面传热行为的复杂性，所示直接测量探头表面温度是非常困难的。
In this article, the design of "-"spinneret of Polyester FDY was introduced. The effect of spinning temperature , spinning speed and quench process to the flat target of the filament were discussed.
介绍了涤纶FDY扁平丝“-”型喷丝板的工艺设计，主要讨论了纺丝温度、纺丝速度、侧吹风等工艺对纤维扁平度指标影响。
The Mo recovery process was tested from the smelting slag of Bi reverberatory furnace by water quench leaching, and the tested process was compared with the present soda leaching process.
进行了铋反射炉熔炼渣水淬浸出回收钼的工艺试验研究，并将试验工艺与现有的纯碱浸出提钼工艺做了对比分析。
The process has low cost, simple operation, high thermal efficiency. It can be achieved that parts or components partially quench, and the high performance surface of material is obtain.
该工艺成本低、操作简单、热效率高，可以实现零件或部件的局部淬火，使材料获得性能优异的表面。
It's a feasible practice to quench in air for castings made of steels with higher hardenability to reduce or avoid its deformation and crack during heat treatment process.
采用高淬透性钢进行空冷淬火是一种减少铸件热处理变形和开裂的有效措施。
This paper introduces the process requirement and the basic technology with Quench. It shows an example of Quench used in 100MN A1 extrusion press and the result of the cooling.
介绍了铝型材挤压机输出系统淬火装置的基本要求、基本技术，简述了100MN铝挤压机淬火装置及同类产品的冷却效果。
This paper introduces the process requirement and the basic technology with Quench. It shows an example of Quench used in 100MN A1 extrusion press and the result of the cooling.
介绍了铝型材挤压机输出系统淬火装置的基本要求、基本技术，简述了100MN铝挤压机淬火装置及同类产品的冷却效果。
应用推荐