Poly (vinyl alcohol) (PVA) is widely used in textile industry as a sizing agent.
聚乙烯醇(PVA)在纺织工业中被广泛用作上浆剂。
PVA; oxidized starch; water solubility.
聚乙烯醇;氧化淀粉;水溶性。
A method was established to determine the content of PVA in desizing wastewater.
目的建立一种退浆废水中聚乙烯醇质量浓度测定方法。
The result indicates:the toughness of PVA fiber concrete beams is higher than common concrete in any concrete ages, and increasing with PVA fiber volume ratios increasing.
分析结果表明:无论哪种龄期,PVA纤维混凝土梁的韧性要比普通混凝土梁高,且随纤维含量的增加而增大;
The preparation and characterization of PVA MA membranes by crosslink esterification are described.
介绍了聚乙烯醇(PVA)与马来酸(MA)酯化交联膜的制备及性能表征。
Selecting the suitable PVA product and appropriate method to prepare PVA water solution, and then modifying the solution can keep an optimal applicable effect.
选用适当的品种,用合适的方法制备其水溶液,并对水溶液进行改性,才能达到最佳的使用效果。
The relationship of cotton hollow yarn tensile strength against PVA content is tested, analyzed and discussed.
并对棉型中空纱的强力与PV A含量的关系进行了试验、分析与讨论。
The modified PVA coating process was studied by the crosslinking reaction of the active amino resin and PVA.
利用具备活性的胺基树脂与聚乙烯醇进行交联反应,对改性聚乙烯醇涂布工艺进行了研究。
In this paper, research and development of PVA super water absorbent resin are introduced.
介绍了聚乙烯醇(pva)系高吸水树脂的国内外研究开发情况。
But the cotton fabrics treated by PVA must be desized to enhance their water absorbency.
经pva上浆的棉织物必须经过退浆处理,以增加棉织物对水的吸收性。
Poly (vinyl alcohol) (PVA) is widely applied in the textile as a sizing agent.
聚乙烯醇(PVA)在纺织工业中被广泛用作上浆剂。
Results: The concentration of PVA was the significant factor affecting the particle size (P<0.05).
结果:聚乙烯醇(PVA)浓度是影响微球粒径的的显著因素(P<0.05);
The water durability of PVA crosslink membranes were tested in boiling water. The PVA PAN composite membranes were used for separation of water ethanol by pervaporation.
在沸水中测定了PVA交联膜的耐水性,将PVA与聚丙烯腈(PAN)制成PVA-PAN交联复合膜用于渗透汽化法分离乙醇—水混合物。
Nowadays, starch, PVA and acrylic size are the three kinds of sizes in textile industry.
因此淀粉、PVA与丙烯酸类浆料一起并称为“纺织三大浆料”。
Polyvinyl Alcohol (PVA), Acrylics and Starches are major materials in warp sizing.
聚乙烯醇(PVA)、丙烯酸类及淀粉是经纱上浆的三大主浆料。
The results show that the PVA gel may be a fine carrier for transdermal therapeutic system.
结果提示,这种聚乙烯醇凝胶可望作为药物透皮给药系统的一种新的良好载体。
The solvent effect on the preparation of PVA film by low speed spin machine was studied by using AFM and XRD.
本文采用原子力显微镜和X射线粉末衍射仪研究了PVA溶液旋转涂膜的溶剂化效应。
As for melt time of resin, HPMC, PVA, polymerization vessel may affect it.
对于树脂的熔融时间,HPMC、不同醇解度的PVA、聚合釜均有较大影响。
The vascular embolic agents include steel coil, gelfoam, and PVA.
血管栓塞剂选用钢圈、明胶海绵、PVA微粒三种。
The polyvinyl alcohol (PVA) modified electrode has been prepared on the basis of glassy carbon electrode.
本文提出用玻碳电极为基体制作聚乙烯醇(PVA)修饰电极。
The synergistic chromogenic reaction of Nb(V) with both bromopyrogallol red(BPR) and diantipyrylmethane(DAM) in the presence of polyvinyl alcohol(PVA) is studied.
探讨了在聚乙烯醇(PVA)存在下,铌与溴邻苯三酚红及二安替比林甲烷的协同显色反应。
An alcoholic continuous fermentation using cassava as material, and by immobilization of glucoamylase preparation and yeasts using polyvinyl alcohol (PVA) gel as the carrier was studied.
采用聚乙烯醇(PVA)为载体共固定化酵母菌细胞和糖化酶制剂,并以木薯为原料进行酒精连续发酵工艺研究。
Phanerochaete chrysosporium was entrapped with PVA and the reaction system for dye Biebrich Scarlet with entrapment particles was set up.
以PVA为包埋剂对黄孢原毛平革菌进行固定,并建立包埋颗粒对染料比布列希猩红的反应体系。
The characteristic properties of PVA super water absorbent resin compared with other absorbent resin are detailed.
对pva系高吸水树脂与其它类型高吸水树脂相比的性能特点进行了详细描述。
Polytetrafluoroethylene (PTFE) with mass ratio of 10% was added in the coating process of mixed zinc powder to substitute polyvinyl alcohol (PVA) of traditional technology.
在混合锌粉包覆过程中,添加质量比为10%的聚四氟乙烯(PTFE)取代传统工艺的聚乙烯醇(pva)。
PVA concentration, amount of crosslinking agent, the temperature of heat treatment and base membrane which might affect performance of composite membranes, were also studied.
分析讨论了PVA的浓度、交联剂用量、热处理温度及基膜对膜蒸汽渗透分离性能的影响。
Melting temperature of the modified PVA indicated that the melting temperature of PVA with the alcoholysis of 88 % increased with the increasing of the molecular weight.
改性pva塑化温度的研究表明,醇解度为88%的PVA,随相对分子质量的增加塑化温度升高。
Melting temperature of the modified PVA indicated that the melting temperature of PVA with the alcoholysis of 88 % increased with the increasing of the molecular weight.
改性pva塑化温度的研究表明,醇解度为88%的PVA,随相对分子质量的增加塑化温度升高。
应用推荐