• One of my dreams is to do a one-arm pullup.

    我的梦想之一是单手垂挂。

    youdao

  • This constant defines the port on which the pullup resistor is connected.

    这个常量定义了上拉电阻是连接到哪个口的。

    youdao

  • Omit resistor R3 if IC2 includes built-in pullup resistors, as do many modern microcontrollers.

    如果IC2包括内置的上拉电阻,就可以忽略电阻r 3,许多现代微处理器都是这样的。

    youdao

  • It is the responsibility of the host designer to connect external pullup resistors to those lines.

    主机设计者有责任给这些连接线加上外接的上拉电阻。

    youdao

  • The selected function for the GP3/MCLR pin is input, and you must enable the global weak-pullup bit in the microcontroller's configuration word.

    GP3/MCLR管脚的 可选功能为输入,在微处理器配置命令中,必须使能全局弱上拉位。

    youdao

  • I fly the aircraft back down to the 1,500-foot line at 500 feet and modify my airspeed to get at show center for the pullup. I level off at about 500 feet.

    我在500英尺高度上把飞机飞回到1500英尺标线处,并且调整我的空速准备飞到展览中心上空时拉起,在大约500英尺标线处我把飞机改平。

    youdao

  • Because the positive side of C1 cannot instantly change its polarity, it pulls low and slowly charges up again through the internal pullup resistor of the input.

    而C1的正向不能立即改变极性,其被拉低并通过输入的内部上拉电阻,缓慢的再次充电。

    youdao

  • Because the positive side of C1 cannot instantly change its polarity, it pulls low and slowly charges up again through the internal pullup resistor of the input.

    而C1的正向不能立即改变极性,其被拉低并通过输入的内部上拉电阻,缓慢的再次充电。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定