The prepared sample was identified using infrared spectroscopy and elemental analysis.
红外光谱和元素分析表明得到的产物为目标产物。
The multi-amidocyanogen sodium phosphate as grind additive was synthesized using mannich reaction, and the as-prepared sample was characterized by IR, DTA analyses.
利用曼尼奇反应原理，制备了多胺基磷酸钠陶瓷助磨剂，采用红外光谱、差热分析等对合成的助剂进行了表征；
The electrons that form the image pass through the sample, so the individual slices have to be prepared and examined.
形成图像的电子通过了这个样品，因此必须准备和检查单个的切片。
Grunberg's team prepared their three-layer sample with the magnetization in the two iron layers pointing in opposite directions.
grunberg的研究小组准备的三层样品中的两个铁层的磁化方向相反。
In this the electrons that form the image pass through the sample, so the individual slices have to be prepared and examined.
它是通过发射电子穿过样本来形成图像，因此每一个切片都要制作和成像。
We prepared a sample PSD layout that is designed according to the Golden Ratio and Golden Rectangle.
我们准备了遵照黄金分割比率和黄金矩形原则设计的PSD格式版面设计示例。
We prepared a sample PSD layout that is designed according to the Fibonacci sequence.
我们准备了遵照斐波那契序列原则设计的PSD格式版面设计示例。
Fourthly, measurement methods of magnetic filed, temperature, transport and magnetization were researched. A sample holder used to electrical transport was prepared.
第四、研究了磁场、温度、电输运和磁化的测量方法，并研制了适合于脉冲磁场测量的样品杆。
The standard and sample solutions should both be prepared in the linearconcentration range and measured at the same wavelength.
应在线性浓度范围内制备标准溶液和样品溶液，并在同一波长处测定。
A serviceable method of determining mulberry leaf fluoride with a Fluorine ion counter was studied, two sample prepared methods to determine influence of result was probed.
研究了采用氟离子浓度计测定桑叶氟化物含量的方法，探讨了不同样本制备方法对测定结果的影响。
For the purpose of this chapter, these definitions apply: the Sample is the specimen under test or an extract prepared from such a specimen.
根据本章目的，使用以下定义：样品是指试验中所使用的试样或试样的提取物。
YSZ solid electrolyte film was prepared by aqueous gel casting. The influences of temperature, relative humidity and sample thickness on drying process were studied.
用水基凝胶注法制备出ysz固体电解质薄膜，研究了温度、湿度和坯体厚度对干燥过程的影响规律。
UV curable offset ink sample was prepared and its thixotropism was discussed.
制备了UV胶印油墨样品，探讨了油墨样品的触变性。
Using conventional method of making visible light emitting porous silicon, an emitting sample with even visible light, detected by naked eyes. is prepared on unpolished polycrystal silicon wafer.
用制备发光多孔硅样品的常规电化学方法，在未抛光多晶硅表面，成功地制备出了均匀地发射肉眼可分辨的可见光样品。
Therefore, a sample prepared from ferrous wiley Mill should not be used to determine the minute iron content in it.
因此，测定试样中的微量铁，决不能用铁质粉碎机制备试样。
The coke sample with different zinc content, whose reactivity index was tested, was prepared by adsorption method.
通过气相吸附法制备吸附不同锌含量的焦炭试样，并对吸附锌的焦炭的反应性进行了检测。
By using commercial copper foil and gold gluing oil, the sample of copper gilding was prepared with traditional gilding techniques.
用市售铜箔和金胶，采用传统贴金工艺制备贴铜样品。
This paper prepared sodium lauryl sulfate with two different methods, and compared the prepared sodium lauryl sulfate's property with standard analytical pure sample.
介绍了用两种不同的方法制备十二烷基硫酸钠，并对制备出的产物的性能与分析纯的标样进行了比较。
The cerium in the sample prepared by solvent-thermal method exists as Ce3+, and it mostly occupies position B of spinel.
溶剂热法制备的铁氧体样品中，铈离子以三价形式存在，因而主要占据尖晶石晶格的B位。
The sample of PAN nascent fibers was prepared by wet-spinning and drying technology.
采用湿法纺丝得到聚丙烯腈(PAN)初生纤维，干燥后得到PAN初生纤维样品。
The use method is that a sample is firstly prepared and then is etched by the etching agent.
使用方法是先制备试样，再用浸蚀剂浸蚀。
With water sample prepared by glucose as treatment object, the operation rules of EGSB (expanded granular sludge bed) reactor in treatment of high strength organic wastewater was studied.
以葡萄糖配制水样为处理对象，研究了接种颗粒污泥的EGSB(厌氧颗粒污泥膨胀床)反应器处理高浓度有机废水的运行规律。
A UV curable offset ink sample was prepared and its thixotropism was discussed.
制备了UV胶印油墨样品，探讨了油墨样品的触变性。
The critical temperature of the sample by this method is as high as 38.8 K, similar to those prepared by the conventional ways.
采用该方法得到的样品的临界温度可高达38.8K，与常规方法得到的样品的临界温度相近。
The sample moderate heat cement which was prepared by lead-zinc tailing was compared with the sample which was prepared by clay.
本文采用铅锌尾矿为原料烧制中热硅酸盐水泥，并与用粘土配料烧制的中热水泥进行对比。
The sample moderate heat cement which was prepared by lead-zinc tailing was compared with the sample which was prepared by clay.
本文采用铅锌尾矿为原料烧制中热硅酸盐水泥，并与用粘土配料烧制的中热水泥进行对比。
应用推荐