The predicting formula of the drawbar pull of driven wheels running on the sand is obtained by model test.
通过模拟试验，得出了驱动轮在砂地上行驶时的挂钩牵引力预测公式。
This paper discusses test and determination of the predicting formula for cutting resistance cf coal and rock and be referred to use for design calculation of bucket wheel excavator.
介绍煤岩切割阻力试验和预测公式，以供轮斗挖掘机设计计算使用和参考。
One of predicting methods of is to extrapolate its creep behavior based on the combination of testing data and theory formula.
在实验数据和理论公式相结合的基础上对格栅蠕变行为进行外推，这是预测格栅的长期使用寿命的方法之一。
Based on the theory of jet diffusion the formula for predicting the position of dune in equilibrium scour pit are deduced theoretically.
并在此基础上，利用射流扩散理论导出平衡冲刷坑堆丘位置的预报公式。
Based on the theory of transient well test, combining formation parameters analysis obtained from formation test, the formula of predicting productivity has been found.
利用不稳定试井原理，结合地层测试已取得的地层参数进行分析，得出预测产能的公式。
At present CALPHAD technique is not capable of predicting even whether there exists intermediate compound and much more predicting nothing about its formula and the number of intermediate compounds.
针对相图模式识别评估，给出了一种新方法来计算预报中间化合物的生成与否和中间化合物的种类以及数量。
Finally, an approximate formula is presented for predicting symmetrical wrinkling critical loads.
最后，提出了一个对称皱屈载荷的计算公式。
A method for predicting bloom possibility of IS containing compound in the formula design was proposed.
提出了配方设计中对含不溶性硫黄胶料喷硫可能性的测算方法。
The formula is proposed for predicting the creep-coefficients of high-strength concrete of different aggregates.
分析了细骨料和粗骨料对高强混凝土徐变性能的影响规律，提出了徐变系数的预测计算公式。
The results of numerical calculation compared well with test data, as illustrated that this semi-empirical and semi-theoretical formula for predicting the bore pressure is feasible.
通过计算结果与实测结果对比，基本一致，说明用此半经验半理论公式预测涌潮压力是可行的。
The stochastic death factors of earthquakes are analysed and the formula of predicting death numbers caused by earthquakes is establishes.
分析了地震的随机性死亡因素，建立了推算地震死亡人数的公式。
Finally, a formula used for predicting the change of wall thickness by the process parameters was given. The results obtained in this study could be us...
研究了空心件楔横轧成形过程壁厚变化的规律，并给出了根据工艺条件预测壁厚变化值的公式。
Besides, formula for predicting ultimate shear strength of low-rise shear wall has been proposed as well.
在此基础上，提出了低剪力墙抗剪能力的计算公式。
The failure mechanism of a roll shell in continuous roll casting is discussed and a formula for predicting its fatigue life is established.
分析了铸轧辊套的失效机理；提出了铸轧辊套疲劳寿命预报公式。
It has been verified that the possible error of predicting ultimate load by use of the simplified formula will not be greater than 3%, which is permitted in engineering practice.
比较表明，采用简化公式计算引起的误差最大不超过3%，在工程计算所允许的范围内。
The mechanism of flocculation dewatering was discussed, a primary experiential formula of predicting wet content of filter c…
对絮凝脱水机理进行了探讨，在实验数据的基础上提出可以预测滤饼含湿量的初步经验公式。
A practical method for predicting the reflective crack initiation life is developed, and the corresponding formula in the closed form is obtained.
在此基础上，导出了预估反射裂缝形成寿命的简便方法与公式。
The predicting of the new searching center by the application of a 3-order difference formula speeds up the calculation further.
应用三阶差商公式预估新的搜索中心，使运算速度得以进一步提高。
The comparisons with flume experimental data and three empirical formulas show that the proposed formula has fairly good accuracy in predicting the equilibrium bed concentration.
通过与试验资料及经验公式的比较对本文建立的关系式进行了检验，结果表明本文所得计算公式与实际符合较好，可用于悬沙床面平衡浓度的计算。
The comparisons with flume experimental data and three empirical formulas show that the proposed formula has fairly good accuracy in predicting the equilibrium bed concentration.
通过与试验资料及经验公式的比较对本文建立的关系式进行了检验，结果表明本文所得计算公式与实际符合较好，可用于悬沙床面平衡浓度的计算。
应用推荐