The characterization of pre-curing catalyst show that the pore volume and specific surface area had little change after vulcanization.
预硫化催化剂的表征结果表明，催化剂硫化前后孔容和比表面积变化不大。
The resin content, the volatile content and the pre-curing degree of the silica/phenolic resin prepreg cloth were on-line determined by near infrared diffuse reflection spectrum.
采用近红外漫反射光谱技术对高硅氧/酚醛预浸布的树脂含量、挥发分含量和预固化度等质量指标进行了在线测定。
Producing MDF with MUF adhesive can effectively improve the water resistance, reduce formaldehyde emission and effectively control the pre-curing problem caused by the high temperature tube-drying.
用三聚氰胺改性脲醛 树脂（MUF）胶粘剂生产MDF可以有效地提高耐水性，降低游离甲 醛释放量，并使得因管道施胶引起预固化问题得到有效控制。
The pre cured tobacco leaves of growing and ripeness do not contain TSNA, and they are formed and accumulated during curing, aging after harvesting.
大田正常生长及成熟的青烟不含TSNA，是采收后在调制、贮存陈化过程中逐步形成和积累起来的。
The period of pre-processing during liquid crystal cell assembly is divided into five parts from alignment film printing to sealant curing.
将液晶盒前段成盒制程从配向膜印刷到框胶固化结束所经历的时间分为五部分。
This paper reviewed the pre - sent state, research goal and the method of latent system curing at moderated temperature, which was used as the curing agent of structural adhesive.
本文综述了结构胶粘剂的潜伏性中温固化体系的现状、研究方向和方法。
Low viscosity resilient casting resin. Recommended for pre-filled silica formulations with low caking tendency used with amine curing system for low voltage cable joints.
低粘度弹力浇铸树脂，建议与先加入的硅微粉和胺类固化剂合用，用于低压电缆的连接。
The effect of curing regime, pre-wetting degree of lightweight aggregate, and the volume rate of sand on the frost resistance of high strength lightweight concrete is investigated.
采用快速冻融法研究了养护制度、轻集料的预湿程度和体积砂率对高强轻集料混凝土抗冻性能的影响。结果表明：轻集料混凝土具有良好的抗冻性能。
The article introduces technical processes of using these two kinds of pastes respectively, including surface treating, coating, pre-drying, exposuring, developing and post-curing, ect.
分别介绍了这两类印料的使用流程，包括表面处理、涂布、预烘、曝光、显像、后固化等工序。
The article introduces technical processes of using these two kinds of pastes respectively, including surface treating, coating, pre-drying, exposuring, developing and post-curing, ect.
分别介绍了这两类印料的使用流程，包括表面处理、涂布、预烘、曝光、显像、后固化等工序。
应用推荐