A much smaller power loss occurs in the cable when energy is transmitted at high voltage.
用高压输送电能时,沿输电线的功率损耗小得多。
Reactive power optimization is an effective method for improving the electricity quality and reducing the power loss in power system.
电力系统实现无功优化控制是保证系统电压质量、降低网损的重要措施。
Allocating power loss in transmission networks to each participant fairly is one of the important contexts of transmission management.
将支路损耗合理地分摊给各电网用户是电力市场传输管理的重要内容之一。
Reactive power optimization is of great importance to voltage quality guarantee, power loss minimization and thus security and economic operation of power system.
电力系统无功优化对保证电压质量、降低运行损耗,实现电网的安全经济运行具有重要意义。
The cooling system can cut down the power loss by 90 %, save the fuel up to 10 % .
与传统方式相比,自控电动冷却系统的功率消耗减少90%左右,节省燃油10%以上。
Deep IGBT selection and power loss calculation, power module thermal model knowledge.
较深的IGBT选型及功耗计算知识,功率模块热模型创建。
And it also goes into detail on balance experiment of power loss of these two bearings.
并详细地介绍了这两种轴承功耗对比试验的情况。
And accordingly the system power loss, voltage, and equipment action times can be optimized.
从而可兼顾系统有功损耗、电压质量及设备动作次数的综合优化效果。
The operation of unbalanced three-phase loads of distribution network will increase power loss.
配电网三相负荷不平衡运行将增加配电网的电能损耗。
The voltage and reactive power control system can improve voltage quality and reduce the active power loss.
电压无功控制系统对于提高电压质量,降低电网的有功损耗有着重要的意义。
Due to their low torque, they are suitable for applications where high speed and low power loss is required.
此类轴承的扭矩较低,因而适用于要求高速度、低能耗的装置中。
The turning power loss in the wheeled locomotion mechanism (WLM) is a key parameter for wall-climbing robots.
移动机构转向功耗是爬壁机器人的关键性能参数。
It is especially applicable for sintering Mn-Zn soft ferrite material with high permeability and low power loss.
特别适用于锰锌高导软磁铁氧体和低功耗软磁铁氧体等高档铁氧体材料的气氛烧结。
The secondary discharge is an important factor for power loss in the high-voltage and high - power solar cell array.
二次放电是造成空间高压大功率太阳阵功率损失的主要原因。
Large single hook lift system in mine has problems in reactive power loss, and energy waste during decentralization.
叙述了矿井单钩提升系统大马拉小车、无功损耗大、下放段能量白白浪费的问题。
Therefore, decreasing the electric power loss during the process is one of the approaches of electric energy saving.
降低这些过程中的损耗是节约电能的途径之一。
The voltage and reactive power control system for substations can improve voltage quality and reduce the active power loss.
变电站电压无功控制系统可提高电压的质量和降低电网的有功损耗。
Changing the resistance of filter, it studies the connection of the average power and peak power loss with filter resistance.
改变滤波器电阻阻值,研究滤波器上平均功率损耗、峰值功率损耗与滤波器电阻阻值的关系。
Pressure loss is one of important factors in evaluating muffler performance, which is related to power loss of engine directed.
压力损失是评价消声器性能的重要指标之一,直接关系到发动机的功率损耗。
The analysis and calculation indicates that the power loss induced by the elastic deformation of rubber hose can not be ignored.
通过分析及计算表明:软管的弹性变形所消耗的能量是不容忽视的。
When submersible pumps for wells have qualified efficiency, the high head and flow of impellers will generate reactive power loss.
在效率合格的情况下,井用潜水泵的叶轮扬程和流量偏高时会产生无功损耗。
The conic mechanical seal has been used in sand pumps in oil fields with well performance, long life, low leakage and low power loss.
锥面机械密封已应用在离心砂泵上,经钻井公司使用,效果良好,泄漏量小,寿命长,功耗低。
An asymmetrical half-bridge operation in soft switching mode can reduce switching power loss and improve the efficiency of power supply.
不对称半桥工作在软开关模式可以减小开关损耗,提高电源的效率。
The design of the heating resistance used in thin film gas sensitive devices and power loss of the resistors are discussed in this paper.
主要讨论薄膜气敏元件加热电阻的设计及功耗的计算,同时也讨论加热电阻材料必须具备的条件。
In ac power network, the way of phase-shifting capacitors to compensate reactive power loss is always adopted to raise network power factor.
在交流电网中,常常采用移相电容器补偿无功功率损耗的方法来提高网络的功率因数。
The active power loss calculation and service life analysis of parallel transformers under economic operation mode are introduced in detail.
介绍了在并列运行变压器经济运行模式下,变压器有功损耗的计算和使用寿命分析。
Combining with the field experiments, it discusses the calculation of reactor impedances, the impact of test field and the active power loss.
结合现场试验经验,讨论了试验电抗器的电感量取值、试验场地的影响、试验有功损耗等试验相关问题。
Combining with the field experiments, it discusses the calculation of reactor impedances, the impact of test field and the active power loss.
结合现场试验经验,讨论了试验电抗器的电感量取值、试验场地的影响、试验有功损耗等试验相关问题。
应用推荐