The design of a novel high frequency fluorescent lamp IC, on which low voltage control circuit and high voltage power device encapsulated in one chip, is introduced.
本文介绍了一种高频荧光灯镇流器芯片的设计，在芯片的实现上充分体现了低压控制电路与高压功率器件在单一芯片上的兼容性。
By means of the commonly-used domestic variable duration impulse integrated controller, alternative design was carried out on PWM control chip of switching power on overseas equipments.
介绍了利用国内常用的脉宽调制型集成控制器对国外装置上开关电源的PWM控制芯片的替换设计。
In this paper, by the use of dual-current control mode and intelligent UC3842 chip as the core, a single-chip switching power supply circuit are presented.
本文使用双电流控制模式，以智能芯片uc 3842为核心，设计了单片开关电源的实用电路。
Intelligent dual power supply controller takes P87C591 single chip machines as the core, which is the core test and control component of dual power supply switching switch.
智能双电源控制器以P 87c591单片机为核心，是双电源切换开关的核心检测及控制部件。
To maintain the constant average optical power and extiction ratio, the temperature compensation loop and automatic power control loop are incorporated in this chip.
为了保持工作中的稳定平均输出功率和恒定消光比，采用了温度补偿电路和自动功率控制电路。
The system Simplifies hardware circuit by using a MAX5451 digital potentiometer chip, it also digitized the laser power control.
系统采用MAX5451数字电位计不但简化了硬件电路，而且使功率的控制数字化。
This system consists of interactive-drawing programming system, control of working, power source with large power pulse, the main unit uses pentium 586 chip.
本控制系统由交互式绘图编程、加工控制、大功率脉冲电源三部分组成，主机采用奔腾586计算机。
Lead ASIC frond-end design team to complete Synthesis, STA, Equivelant Check, Post Layout Simulation, DFT, ATE, Power Control. Make sure RTL code is ok for chip implement.
负责带领整个团队实施芯片的综合、静态时序分析、逻辑一致性分析、后仿真、DFT、ATE、功耗控制。从芯片实现的角度对模块的RTL代码和芯片的RTL代码进行把关。
Based on the special power measurement chip, real-time, accurate and quick measurement of electric parameters is realized and the performance of the control system is improved.
提出一种基于三相电能专用计量芯片的设计方案，实现对系统所需要的电力参数进行实时、准确及快速的计量，提高了整个控制系统的性能。
The DSP sends out the phase shifting control signal and then that amplified by IR2110 chip. It can realize ZVS of the full bridge converter main power switch by the phase shifting drive control.
由DSP发出移相控制信号并经芯片IR 2110驱动放大，在移相驱动信号的控制下可以实现全桥变换器主功率开关的ZVS。
This paper presents a new designed thermal cycling heater system for PCR in microfluidic chip. It includes the power design, the control project and algorithm experiment.
介绍了一种适用于微流控芯片P CR扩增的新型循环加热系统，包括系统可控电源电路设计、控制方案确定及控制算法实验。
The SCR Rectifier Auto-SAW power source and wire feeder with single chip computer control is introduced in this paper.
本文介绍一种SCR整流埋弧自动焊机电源及送丝控制，单片机应用系统。
Adoption INTEL80C51 single chip microcomputer as control core for producing pure hydrogen, it can control production the craft with necessary interface circuit and power amplifier circuit.
采用INTEL 80c51单片机做为纯氢发生器的控制核心，配备必要的外围接口电路及功放电路对制氢生产工艺进行控制。
A control system based on single chip microprocessor is designed for submerged arc welder with magnetrol power source.
针对磁放大器式电源埋弧自动焊机设计了单片机控制系统。
This paper makes use of ordinary power supply chip TL494, which having characteristic of PWM output, DC motor speed-varying control circuit has been designed.
本文利用最常见的用于电源的PWM电压调节芯片TL494，设计成直流电机调速控制电路。
This dissertation chiefly introduces the analysis of this inverter power and the design of hardware and software of this UPS, and the core control chip is TMS320F240 which is produced by ti corp.
本文主要介绍逆变电源的分析和该ups逆变系统的硬件设计和软件设计，主控制芯片采用TMS320F240。
Main circuit uses independent RC pulse generator and control circuit can control the main circuit based on 8051 single chip microcomputer and TC4427 high-speed power MOSFET driver.
其主电路采用了独立式RC脉冲放电回路，控制电路则通过8051单片机和TC4427高速MOSFET驱动器完成对主电路的控制。
To satisfy demand for uninterrupted power supply, the developing scheme of double power switch controller taking M68HC908SR12 controller as main control chip was introduced.
针对不间断供电的需求，介绍了一种以m 68hc 908sr12单片机为主控芯片的双电源转换控制器的研制方案。
This paper deals with the designs of the hardware and software based on the HSO of 8098 single-chip microcomputer as the way of control signal in the si-control power modulation system.
该文介绍了在可控硅功率调节系统中，采用8098单片机hso端作为控制信号输出通道的硬件和软件设计。
AT89C52 was a sort of cheap Single Chip Microcomputer and was applied to control system of reactive power compensation device.
控制系统采用价格比较便宜的AT89C52单片机作为控制系统主体。
Design the CAN bus address encoder, communication terminal digital display circuit, control relay circuit, LNK501 switching power supply chip circuitry.
设计了基于CAN总线的地址编码器，通信总站的数码显示电路，控制继电器电路，LNK501开关电源芯片电路。
Every drive board can drive a diode laser. The function of control unit single chip in the driver board is to control the aging process of 16 laser diodes in current mode or in output power mode.
驱动板的控制单元-单片机实现对16个半导体激光器的老化过程进行监控，从而使激光器工作在上位机所指定的恒流状态或者恒功状态下。
Methods for controlling reception, decoding and power switching of infrared remote control encoding are described on the basis of microcomputer AT89C2051 single-chip processor.
以微处理器at89c 2051单片机为核心介绍了红外遥控编码的接收、解码及电源开关的控制方法。
This paper presents a new automatic compensation system of high tension reactive power, which consists of single-chip microcomputer, high tension capacitor and control device.
本文介绍了一种由单片微型计算机、高压电力电容器和控制装置组成新的高压无功确率自动补偿系统。
A data acquisition system with the MCS-51 single-chip microcomputer control and a software for dynamic behavior detection of arc welding power source is described in this paper.
本文介绍了一种由MCS - 51系列单片机构成的数据采集系统以及用于电焊机动特性的测试软件。
The switching circuit determines whether to apply the power supply voltage to a chip in response to the control signal.
开关电路响应控制信号确定是否向芯片施加电源电压。
Based on the single-chip technology, an intelligent monitoring and control system for power supply system is designed, and the discussion is focus on its rectifier module control.
基于单片机技术，设计了一种智能化通信电源监控系统，并重点对整流模块监控单元进行介绍。
This paper presents a temperature control system of silicon control power governor using AT89C52 chip microcontroller.
讨论了AT 89 C52单片机实现的可控硅调功温度控制系统。
A new way to generate stable ac current is found with feed back control system by single chip microcomputer. So a new high power ac current regulator is developed.
再用单片机组成反馈控制系统，从而找到了交流稳流的新方法，研制出一个大功率交流稳流电源。
A new way to generate stable ac current is found with feed back control system by single chip microcomputer. So a new high power ac current regulator is developed.
再用单片机组成反馈控制系统，从而找到了交流稳流的新方法，研制出一个大功率交流稳流电源。
应用推荐