Ports are numbered from 0 to 65535 and only one application at a time may register for a single port.
端口的数字可以从0到65535并且一个程序每次只能有一个端口。
If this variable is not set, it will default to the partition that is defined with port 0 on the machine (in the db2nodes.cfg file).
如果没有设置该变量，那么它将默认地等于用机器上的端口0定义的那个分区(在db 2 nodes . cfg文件中)。
Enter interface managementethernet 0 — Configures the management port from the configure prompt.
输入interface managementethernet0——在配置提示符上配置管理端口。
The STA adapter is always bound to Port 0.
STA网卡只能被绑定到端口 0。
Note: if you set the source port to 0, your operating system will specify the source port.
注意：如果你的端口被设置为0，你的操作系统将被指定为源端口。
To use concurrent transactions within a single VM, we just open a db4o server on our database file, directing it to run on port 0, thereby declaring that no networking will take place.
要在单个VM上执行并行事务，只需要在数据库文件上打开一个服务器，指定其运行端口为0，这样声明就不会有网络的发生。
Port Numbers must be greater than 0 and less than 65536. Please enter a number within this range.
端口数目必须大于0小于65536。请键入一个在这个范围内的数目。
DMA can run constantly or can be triggered by exterior interruption (INT3-0), interior interruption (timer and serial port), at the end of transfers, send interruption signal to CPU.
DMA可以被外部(INT3 - 0)、内部的(片内定时器和串口)中断触发运行，传输完成后可以向CPU发出中断请求。
Port 0 is also the multiplexed low-order address and data bus during access to external program and data memory.
端口0也是复低位地址和在利用外部程序和数据存储器的数据总线。
For the five-port waveguide junction properly to be used in a six-port reflectometer, needing the reflection coefficient looking into anyone port is less than 0.
为了使五端口波导网络能较好地工作于六端口反射计中，要求各端口反射系数的绝对值小于0。
When you sample an analog port it will return a value between 0 and 1023, proportional on the voltage (05 volts) on the signal pin (pin 3).
当你对一个模拟端口采样时，它会返回一个与信号针脚（脚3）上的电压成比例的，范围在0至1023之间的值。
Send Port referenced by Orchestration Port '{0}' has been deleted.
业务流程端口“{0}”引用的发送端口已被删除。
A port of 0 creates a socket on any free port.
端口号为0表示在任意空闲端口创建套接字。
SendPortGroup referenced by Orchestration Port '{0}' has been deleted.
业务流程端口“{0}”引用的发送端口组已被删除。
Normal working hours at Discharging Port shall mean from 0 (zero) to 24 (twenty-four) o 'clock, including Saturdays, Sundays and holidays.
在卸港的正常工作时间意即零时(0)至二十四时(24)，包括周六、周日和节假日。
Normal working hours at Discharging Port shall mean from 0 (zero) to 24 (twenty-four) o 'clock, including Saturdays, Sundays and holidays.
在卸港的正常工作时间意即零时(0)至二十四时(24)，包括周六、周日和节假日。
应用推荐