The optimum tube spacing equals approximately to the departure diameter of the bubbles during a pool boiling.
最佳管距对应的管束水力当量直径近似等于池内沸腾时的气泡脱离直径。
The heat transfer data of nucleate pool boiling on a smooth flat surface were measured in HC170/HFC23 system.
实验测量了新型共沸混合工质HC170/HFC23的池核沸腾传热特性。
The present paper reports pool boiling experiments of the mechanically made porous surface tubes with ribbed tunnels (JK-2 tube).
本文报道了肋形隧道机械加工表面多孔管(JK—2管)单管管外池沸腾实验。
Heat transfer experiments were carried out for pool boiling on vertical and horizontal compact heated tube array used for evaporator.
对紧凑式排列管束在水平和竖直两种排列方式下的池内沸腾换热特性进行了实验研究。
For the horizontal tubes bundle an enhanced action on the pool boiling heat transfer exists. Heat transfer coefficient of the tube bundle is...
管束对池沸腾换热有增强效应，水平管束的沸腾换热系数明显高于单管的沸腾换热系数。
A new method has been presented to predict the nucleation site density in nucleate pool boiling based on the investigation of the microstructure of boiling surface.
本文提出了一种新的基于沸腾壁面微结构分析的预测核态池沸腾中汽化核心密度的方法。
The effect of magnetite concentration and applied magnetic field on pool boiling heat transfer of a water-based magnetic fluid was investigated on a horizontal heater.
研究了磁性微粒浓度、外加磁场对水基磁性流体在水平加热棒加热情况下的沸腾传热影响。
For the horizontal tubes bundle an enhanced action on the pool boiling heat transfer exists. Heat transfer coefficient of the tube bundle is higher than that of a single tube.
管束对池沸腾换热有增强效应，水平管束的沸腾换热系数明显高于单管的沸腾换热系数。
A steady numerical simulation of the effect of nano-particles on nucleation sites in nucleate pool boiling heat transfer was conducted based on the experimental boiling curves.
根据实验所得沸腾曲线，对纳米颗粒悬浮液进行稳态数值模拟，计算了不同过热度下活化核心的密度。
For efficiently cooling electronic components, experiments were conducted to study the pool boiling heat transfer performance of FC-72 over silicon chips with surface microstructures.
针对电子器件的高效冷却问题，对表面加工有微结构的硅片上FC- 72的池沸腾换热性能进行了实验研究。
The hydrodynamic instability model is spread for finite geometries in order to explain effects of size of microelectronic devices on the mechanism of formation of pool boiling critical heat fluxes.
动力学不稳定性模型被推广到有限几何形状的加热面，以解释微电子器件尺寸对池内沸腾换热临界热流形成机理的影响。
An experimental investigation on transient of wall temperature in start-up process of pool boiling heat transfer, on vertical plain tube and narrow annuli under atmospheric pressure, was carried out.
在常压下对竖直光管和环隙流道内沸腾换热启动阶段的壁温变化规律进行了实验研究。
An experimental investigation on transient of wall temperature in start-up process of pool boiling heat transfer, on vertical plain tube and narrow annuli under atmospheric pressure, was carried out.
在常压下对竖直光管和环隙流道内沸腾换热启动阶段的壁温变化规律进行了实验研究。
应用推荐