A two-dimensional placement method of minimum area is presented by digraph representation.
本文采用有向图表示、提出一种二维的最小区域布局方法。
The dissertation proposes a signal-flow driven placement method of analog integrated circuits.
本文提出了一种信号流驱动的模拟集成电路布局方法。
This dissertation focuses mainly on placement method and algorithms of analog integrated circuits.
本文主要研究模拟集成电路的布局方法以及布局算法。
A new weighted pole-placement method is proposed to design a robust controller for the flexible system.
提出了一种新的加权极点配置方法来设计挠性系统的鲁棒控制器。
Traditional concrete placement method can not meet the construction quality requirement of sharp slope concrete roofing.
传统的混凝土浇筑施工方法已不能满足大坡比混凝土屋面施工质量要求。
In the paper, a new sensor placement method is developed on the basis of mode independence and principal subset selection.
在振型独立性的基础上，提出了一种基于主列筛选的传感器配置方法。
Combining coherency identification with information content, an optimal placement method of rotor Angle transducers is proposed in this paper.
结合同调分群与基于信息含量的方法，提出了一种转子角测量装置的优化配置方法。
Based on experiment, by improving production and placement method of index particle, a new measurement method to test the granular flow parameters by drawn-body equation is proposed.
在试验的基础上，改进标志颗粒的制作方法与放置方法，提出利用放出体方程求解散体流动参数的新方法。
Zero placement method in the frequency domain is utilized to design robust multi-hump EI optimal arbitrary time-delay filter (OATF) by placing two or more filter zeros nearby the system poles.
采用频域的零点配置方法，通过在系统极点附近配置多个滤波器零点设计强鲁棒性的多峰极不灵敏（E I）最优随机时滞滤波器。
Pole placement method is used in the selection of hyperplane to simplify the design. This method is more convenient and with less computation than the method based on the quadratic performance index.
在开关超平面的选择上，采用了极点配置法，而不是基于二次型性能指标，从而减少了计算量，简化了设计。
The mathematical model of inverted pendulum system is built, and a controller is designed based on the pole placement method with full state feedback to make the inverted pendulum system work stably.
通过建立倒立摆系统的数学模型，应用状态反馈控制配置系统极点设计倒立摆系统的控制器，实现其状态反馈，从而使倒立摆系统稳定工作。
The sliding surface is designed by the "pole-placement" method and the variable structure control is determined by the "reaching law approach".
采用极点配置方法设计滑模面，基于趋近律方法求取变结构控制律。
The sliding surface is designed by the "pole-placement" method and the variable structure control is determined by the "reaching law approach".
采用极点配置方法设计滑模面，基于趋近律方法求取变结构控制律。
应用推荐