Fig. D: Moebius clock advances a single-sided paper loop with printed times.
图D：驱动印有时间刻度的单面纸带前进的莫必斯时钟。
On the stove, a piece of paper was stuck on the front of the clock, obscuring the face: "Ignore this clock.
一张字条贴在放在炉子的钟上，遮了钟面：不要看这钟，放在炉子上的钟老是不准。
This actually seems like a decent DIY project — it probably wouldn’t take much work to sync a paper shredder to your alarm clock.
这似乎是一个像样的DIY工程--也许往你的闹钟里同步装上一个碎纸机并不费力。
This actually seems like a decent DIY project - it probably wouldn't take much work to sync a paper shredder to your alarm clock.
这似乎是一个像样的DIY工程——也许往你的闹钟里同步装上一个碎纸机并不费力。
The models studied in this paper include linear shift register sequences, feedforward sequences and clock controlled sequences.
本文研究的模型包括线性移位寄存器序列，前馈序列和钟控序列。
This paper is mainly a research on time consistence in Distributed Virtual Environment. Some clock synchronizations are introduced in it. Combined with practice, the result is proposed at last.
要做到时空一致，时间一致是关键，本文主要对分布式虚拟环境中时间一致性进行了研究，介绍了几种时间同步的方案，并结合实际应用，给出了实验的结论。
This paper mainly analyzes the application of the IBIS model in the system board design and system clock design for mobile computers.
本文主要分析了IBIS模型在移动微机板参设计和在系统时钟设计中的应用。
The paper introduces the design of digital clock based on FPGA and VHDL, the time of clock can be displayed with the digital driving circuit.
介绍了利用VHDL硬件描述语言结合FPGA可编程器件进行数字钟的设计，并通过数码管驱动电路动态显示计时结果。
This paper presented a type of timing clock LCD.
本文介绍了一种定时闹铃lcd。
According to the requirement of BTB's design, the paper adopts the symmetrical clock tree technique.
针对BTB的设计要求，确定采用树状网络分布的时钟分布技术。
Based on LFVC (Leap Forward Virtual Clock), this paper proposes a scheme named WLFVC, which is a fully distributed wireless scheduling scheme for WLAN (wireless LAN).
基于前跳虚时钟(LFVC)算法，本文提出了适用于无线以太网(WLAN)环境的全分布式的调度算法WLFVC。
This paper analyzed the means and principle of clock supply, and described the ways of timing transmission. At the same time, the advantages and disadvantages were also instructed.
分析了时钟提供的方式和原理，描述了定时传送的情况，并指出了它的优缺点。
This paper carries out comprehensive interpretation on three inferences in the proposition of clock paradox by space-time diagrams.
利用时空图对时钟佯谬命题中的三个论断作了全面诠释。
A new tool that can test the clock base frequency error of energy measuring devices and provide GPS standard time to calibrate real-time clock was introduced in this paper.
介绍了一种用来测量电能计量装置的时钟基频误差，并提供GPS标准时间以校准其实时时钟的新型工具。
This paper discusses the design and implementation of a low-power digital clock chip.
本文讨论了一种低功耗时钟芯片的设计与实现。
This paper gives an application of high OCXO and GPS synchronization clock in data-gathering.
本文给出了一种高精度恒温晶振（OCXO）和GPS同步时钟在数据采集中的应用。
This paper introduces the functions and work principles of serial clock chip DS1302, the design of interface circuit with AT89C51 single -chip microcomputer in the spray irrigation controller.
本文介绍了串行时钟芯片DS1302的功能和工作原理，并给出ds1302在灌溉控制器中与AT 89 C51单片机的接口电路设计。
This paper presents a clock control circuit in which an electronic clock is made by a MCU AT89C2051 16-bit timer and real-time control is achieved by the electronic clock's function of precise timing.
提出的时钟控制电路，是利用单片机at89c 2051的16位定时器做成电子时钟，并利用电子时钟的精确定时作用实现了实时控制。
A method for subdividing the grating pulse signal by means of using computer clock pulse is presented in this paper.
本文介绍了一种利用计算机时钟脉冲细分光栅脉冲信号相位的方法——改进型时钟脉冲细分技术。
This paper discusses the application of clock representation in three phase transformer connections and other fields.
论述了“时钟表示法”在三相变压器联接组别和在其他方面的应用。
The paper discusses the integration schemes for official communication and private communication and for clock system and passenger information system (PIS) of metro and light railway project.
本文主要对地铁轻轨项目公务通信与专用通信、时钟与乘客资讯系统整合进行了方案探讨。
The theory of operation, design considerations, design, characters, main features of model ST0202 high performance digital clock are described in this paper.
本文介绍ST0202高性能数字钟的设计出发点、工作原理、设计特点和主要性能。
Sometimes he looked up at the clock, and then he went back to reading his paper.
他不时地抬起头看看时钟，然后又接着看报纸。
This paper adopts a strategy of fitting offset to adjust time, to conquer the impact of network delay and jitter on clock synchronization effectively.
该文提出采用拟合偏差方法进行时钟调整的策略，以有效克服网络延迟和抖动对时钟同步的影响。
The paper introduces the principle of PLL clock synthesizer and the structure of MC12429, designs the circuit of the High Frequency clock synthesizer.
本文介绍了PLL合成时钟源的原理，介绍了MC 12429的结构，设计出了高频时钟源电路图。
To erase redundancy of the clock, improve clock utilization rate and reduce power dissipation, this paper proposes the logic design of low power flip-flop based on double edge trigger.
从消除时钟冗余，提高时钟利用率以达到降低功耗的思想出发，提出基于双边沿触发的触发器的逻辑设计。
This paper introduces the frequency deviations of NIM4 Cesium fountain clock , the method and result of a new evaluation.
详细介绍NIM4铯喷泉钟系统频移及其不确定度的最新评定方法和结果。
In this paper the novel method of using holographic optical element (HOE) to realize optical clock distribution was presented.
提出了采用偏振全息术制做全息光学元件以实现光学时钟分布的方法。
Combining the Constructivism Ideology and taking the case of digital clock design, this paper presents the Application of Constructivism Ideology in Embedded System course teaching.
结合嵌入式系统课程的特点，并以数字时钟的设计为例，介绍了将建构主义教学理论应用于嵌入式系统课程教学。
Combining the Constructivism Ideology and taking the case of digital clock design, this paper presents the Application of Constructivism Ideology in Embedded System course teaching.
结合嵌入式系统课程的特点，并以数字时钟的设计为例，介绍了将建构主义教学理论应用于嵌入式系统课程教学。
应用推荐