The main complication of silicone oil removal was recurrence retinal detachment.
硅油取出后主要并发症是视网膜脱离复发。
Objective To report a new simplified silicone oil removal surgery for aphakic eyes.
目的探讨一种改良的无晶状体眼硅油取出术。
Organic solvent oil removal: use organic solvent cleared surface process of oil parts.
有机溶剂除油：利用有机溶剂清除制件表面油污的过程。
The optimum operating conditions were studied and the oil removal efficiency was more than 90%.
该设备的最佳除油率大于90%。确定了最佳操作参数。
In the mid-test of oil removal in the sewage, slant oil interceptor and gas float disposal are used.
稠油污水除油系统中试，用斜板隔油和气浮进行处理，含油和悬浮物可达到用热采锅炉进水指标。
Oil removal rate could keep at 85% after the regeneration treatment of stearic acid-modified magnetite.
对饱和吸附后的磁铁矿进行再生处理后，其对石油的去除率稳定在85%。
Character: in the process of paraffin and oil removal, it doesn't corrode the applicable metal surface.
特点：除蜡除油过程中对所适用的金属表面无腐蚀。
The effect of each synthesis factor on the oil removal efficiency of the modified bentonite is discussed.
讨论了各个合成因素对改性膨润土除油效果的影响；
The experimental results show that the oil removal efficiency was more than 90% under optimum operation parameters.
试验结果表明，在优化操作参数条件下，除油率可达90%以上。
The optimal mixed strains G8 was selected and its oil removal ratio is 68.76%, nearly 30% higher than the single strains.
利用这四种菌构建高效混合菌群，筛选出最优混合菌G8，对石油的去除率达到68.76%，比单菌株提高了近30%。
Purpose: To analyze the clinical risk factors of the occurrence of retinal redetachment after expected silicone oil removal.
目的：探讨预期眼硅油取出术后视网膜再脱离的临床危险因素。
The coalescence mechanism was explored through comparison experiment of oil removal performance of several coalescence fillers.
通过对几种聚结填料除油性能的对比试验，探讨了聚结机理。
Conclusions This simplified silicone oil removal surgery for aphakic eyes is simple, safe, effective and deserves to broadcast.
结论这种简化的无晶状体眼硅油取出术简单易行，安全有效。
To shorten the processing time, the surfactant producing strain CY-5 was compounded with strain CY-47 to oil removal experiment.
为缩短处理时间，故将表面活性剂产生菌cy - 5与菌cy - 47进行联合除油实验。
Our Clean air Source removes oil or other liquid droplets from the incoming air using two pre-filters and an oil removal filter.
我们的清洁空气源去除空气飞沫从传入的油或其他液体中使用两个预过滤器和1除油过滤器。
There are few drier suppliers can determine their own products oil removal ability, it depends on oil filter to perform the task.
很少有干燥器供应商能够明确自己产品的除油能力，这有赖于油蒸气过滤器执行该任务。
FJL-40 type air-floated oil skimmer structure, oil removal principle and influence factor of air-floated oil removal are described.
介绍了FJ L - 40型气浮除油机结构、除油原理和气浮除油的影响因素。
The reasons for the silicone oil removal are the complications such as cataract, glaucoma, emulsification of the silicone oil and so on.
取出原因主要为白内障形成、青光眼、硅油乳化等，其中6只眼为视网膜复位稳定无并发症者。
Air purification part: oil removal device, high precision filter, compressed air drying machine, air cushion tank, activated carbon filter;
空气净化部分：高效除油器、精密过滤器、压缩空气干燥机、空气缓冲罐、活性炭过滤器；
The oil removal technique by dynamic state micro-bubbles flotation which is used for the water treatment on offshore oil platform is introduced.
介绍了一种用在海洋石油平台生产水处理中的微气泡浮选除油技术。
The experimental result shows that the organic cationic type oil removal agent is good for solving this kind of oil-bearing wastewater treatment problems.
试验证明，有机阳离子型除油剂能够较好的解决胜利油田注聚采出液含油污水处理问题。
The experimental result shows that the organic cationic type oil removal agent is good for solving this kind of oil-bearing wastewater treatment problem...
试验证明，有机阳离子型除油剂能够较好的解决胜利油田注聚采出液含油污水处理问题。
However, due to the compressed air dryer's main purpose is to reduce the air only water vapor, therefore dryer oil removal ability is difficult to determine.
然而，由于压缩空气干燥器的主要目的仅仅是降低气流中的水蒸气含量，因此干燥器的除油能力很难确定。
The mechanism and reaction dynamics of coalescence were explored through the comparison experiment of oil removal performance of several coalescence fillers.
通过对几种聚结填料除油性能的对比试验，探讨分析了聚结除油反应机理及其动力学。
Whereas the process flow of small high efficiency oil removal device requires higher using condition and after filtation the water quality is easy to exceed standard.
而小型高效除油设施体积小，占地面积少，但要求污水含油量在平稳状态下运行，处理后的水质容易超标准。
Aiming at the problem of oil removal, large water consumption and large waste water treatment in phosphating process, improvement measure of phosphating process is put forward.
针对磷化工艺中存在的除油不彻底、用水量大、废水处理量大等问题，提出了改进磷化工艺措施。
The method of the invention omits the working procedures of coating and antirust oil removal, improves the production efficiency, saves the production time, and reduces the cost.
本发明的方法省略了涂覆和除去防锈油的工序，提高了生产效率，节约了生产时间，降低了成本。
Result shows that the technology is completely applicable to the oil removal in oil-contained silt and has important significance in oilfield production and environment protection.
结果表明，该处理工艺完全适用于含油泥砂的除油，对油田生产以及环境保护都有重要意义。
It was discovered from the experiment that the fibre after modification could make oil removal rate by flushing increase to 1.9 ~ 2.8 times of the original concentration, and could b...
试验结果发现，改性后的纤维可使其冲洗除油率增加为原来的1.9 ~ 2.8倍，经过改性后的纤维可以在含油废水处理中通过反冲洗再生而得到重复使用。
The results show that the product has very good thermo-stability and both of the oil removal efficiency and oil removal speed are satisfactory. The oil remove rate could be higher than 99%.
结果表明：产品具有良好的热稳定性，除油性能良好，除油速度快，除油率可达99％以上。
应用推荐