A new algorithm of oil pressure for sliding bearing was proposed.
提出一种计算滑动轴承油膜压力的新算法。
Oil pressure sensors are used to indicate if the oil system has the right amount of pressure.
油压感应器的功能是显示油压系统的压力值是否正常。
Cast iron relief valve in main oil system to control oil pressure to the compressor bearings.
主油路中装有安全阀以控制压缩机轴承中的油压。
Stop driving the vehicle when the oil pressure warning light comes on and pull over to a safe place.
当油压灯亮起时，把车停在一个安全的地方。
Alloy was melted in channel induction furnace with oil pressure semi - continuous casting ingot.
合金在有芯工频感应炉熔炼，油压半连续铸锭。
Oil pressure is provided by a high pressure oil pump that, generally is belt driven by the engine.
油压是由高压油泵提供的，发动机通过皮带驱动油泵。
This article describes the existing problems and countermeasures for gas-making oil pressure system.
详细介绍了目前造气油压系统存在的问题及解决措施。
Pressure switch is installed in system to realize automatic transfer for pump under low oil pressure.
系统中设有压力开关，以实现在低限油压时的泵组自动切换。
Whenever the oil pressure exceeds the maximum pressure, the regulator valve opens to reduce the pressure.
每当油压力超出最大压力时，打开调节阀，以减少压力。
The hydraulic pressure oil pressure reduces, causes the header not to be able to hang or raises hangs slowly.
液压油压力降低，导致割台挂不起或提挂缓慢。
Check the oil filter to see if it is plugged up with gunk. A clogged oil filter can also result in low oil pressure.
检查油过滤器是否被粘性物质堵住。一个被堵住的过滤器也能引起油压不足。
Pressure switch (optional) is installed in system to realize automatic transfer for pump under low oil pressure.
系统中设有压力开关(可选)，以实现在低限油压时的泵组自动切换。
The Warning LED lights when measured value drops below the set warning value for oil pressure and fuel pressure.
发光二极管灯的警告时，燃油压力测量值降至低于设定压力警告值的石油。
Fuel Tank Gauge, Fuse Box, Thermo Switch, Water Temp. sending Unit, Oil Pressure Switch, Horn, Sensor and so On.
油箱浮子，保险丝盒，温控开关，水温感应器，油压开关，喇叭，传感器等等。
The capacity of oil pressure relief and the conversion factor between oil pressure and gas pressure are measured.
测定了油压与气压间的变换系数和油压释放量。
Introducing the operating principle of a Small High-speed liquid press with Dual-Differential Oil pressure System.
本文介绍一种双差动油路小型高速油压机的工作原理。
In order to unify knowing and benefit manufacture, we must calculate the figure of the oil pressure contacting brake.
通过理论计算确定贴闸皮油压的数值，以便统一认识、指导实践。
Oil pressure feeding mechanism (belongs of optional equipments); simplified and comfortable feeding operations are provided.
油压上料机构（属于选购配备），提供简易、轻松的原料上料操作。
Caused by two failures is mainly due to low oil pressure of work, while the low pressure is mainly due to blockage and leakage.
引起两个故障的主要原因是工作油压偏低，而造成压力偏低的主要原因是堵塞和泄漏。
Stop engine, find causes and remove faults when oil pressure is low, water temperature is high, abnormal smokes or noise happen.
当出现机油压力过低、水温过高以及有异常排烟或响声时，应立即停机查清原因并进行排除。
If oil pressure was low and pump is within specifications, inspect for worn engine bearings or other reasons for oil pressure loss.
如果油压低并且泵在规格表内，则针对油压低的问题检查磨损的引擎轴或其它原因。
The deposit could be effectively removed and oil pressure was renewed by way of choosing effectual cleaner and chemical cleaning technology.
选用恰当的清洗剂，采用合理的化学清洗工艺能有效地去除输油管内的沉积物，恢复输油压力。
This section has to be observed if instruments for the measurement of temperature, oil pressure or vibration have been specified in the order.
如果这些仪器是用于测量温度的，就一定要关注本节内容，且在指令中也一定要注明油压或振动。
Common reasons: May be an internal short-circuiting problem with the oil pressure sensor, which causes the voltage at the pedal to be incorrect.
常见原因：可能是机油压力传感器的内部短路问题，从而使得踏板处的电压不对。
There is an oil pressure sensor near the oil pump that monitors pressure and sends this information to a warning light or a gauge on the dashboard.
在油泵附近有个油压力传感器，它能检测油的压力并传递给警示灯或仪表板上的油量表。
Having analysed the causes of alarm lamp flashing for oil pressure in automobile, pointed that it is concerned with many factors and should handle on time.
对汽车油压警报灯闪亮的原因进行了分析，指出该问题的产生与许多因素有关，应有针对性地及时处理。
Every split part has oil pressure suspensions, so the overall shock is minimized the second split suspension makes soft reaction of the tire even without air inside.
每个分叉都有油压悬挂系统，所以整体的减震效果非常好。第二级分叉悬挂使得轮胎没有充气也一样柔软有弹性。
For example, the characteristics of data acquisition system for sample oil pressure signal of an injection system are of high speed, and special synchronization.
如对喷油系统油压信号的采集，即需要具有高速采集数据的性能，又要能满足特殊同步的要求。
For example, the characteristics of data acquisition system for sample oil pressure signal of an injection system are of high speed, and special synchronization.
如对喷油系统油压信号的采集，即需要具有高速采集数据的性能，又要能满足特殊同步的要求。
应用推荐