To investigate a new type of low stress precision cropping system, it is necessary to obtain the feasibility that the heat stress was used to prefabricate the ideal crack of V-shaped notch tip.
针对研究新型低应力精密下料系统时，需要获得热应力预制V型槽尖端理想裂纹方法的有效性问题。
Compared with traditional image segmentation methods, C-V model has some special advantages: it can accommodate itself to the changes of the object's Geometric topology and obtain continuous boundary.
因而C -V模型具有其它传统图像分割方法不具备的许多优点：它可以自动适应目标几何结构的拓扑变化，获得连续边缘。
This paper introduces the notion of compatibility between preorderings and V-valuations on commutative rings with units and obtain some relevant results.
在带有单位元的交换环上，引入了V-赋值与亚序间的相容性，并得出了一些性质。
Then the static analysis was carried out with ABAQUS to obtain the distortion and stress characteristics of V-type rod, and then the ADAMS simulating results were taken as the initial conditions.
将计算结果作为有限元分析的初始边界条件，在ABAQUS中进行了静态强度分析，获得了其变形及应力分布情况。
An data-processing method was developed to obtain the device parameters from the resistance-voltage(R-V) characteristics measured in long-wavelength HgCdTe photodiode.
报道了一种适用于碲镉汞长波光伏探测器的由典型电阻电压（R-V）曲线提取器件基本特征参数的数据处理途径。
It is considered that the V-N micro-alloy high carbon wire rods obtain the high strength and toughness mainly due to grain refining and precipitation strengthening.
研究认为钒氮微合金化硬线钢主要通过细晶强化和沉淀析出强化，从而提高钢材的强韧件。
It is considered that the V-N micro-alloy high carbon wire rods obtain the high strength and toughness mainly due to grain refining and precipitation strengthening.
研究认为钒氮微合金化硬线钢主要通过细晶强化和沉淀析出强化，从而提高钢材的强韧件。
应用推荐