Fluid can produce strongest internal swirl when the needle is far from the nozzle exit.
可见流体在针阀与喷嘴出口间隙大的时候其内部旋流强度大。
The optimum jet distance for jet pressure pulsation was about 7-14 times of nozzle exit diameter.
实验还表明,自激振荡脉冲喷嘴射流存在最优喷距,最优喷距的大小为喷嘴出口直径的7~14倍。
In this paper, employing rigorous variational calculus, equations of control surface at maximum thrust nozzle exit are derived.
本文用严格的变分法导出了最大推力喷管出口控制面方程。
The discrete vortex method was adopted to simulate and analyze the vortex structure and pressure distribution of the flow field at the nozzle exit.
采用离散涡方法模拟了两种不同形状哨嘴的喷嘴出口流场旋涡结构和压力分布。
Uniform distribution of cavitation at the nozzle exit section is obtained by increasing length-diameter ratio and leads to the improvement of atomization.
从燃油空穴雾化理论的角度出发,空穴强度的提高以及在出口截面上的均匀分布都有利于燃油的破碎雾化。
At the region near the nozzle exit, a vibrating flow phenomenon is found, which is associated with the expansion waves and shock waves reflections inside the gas jet.
发现了在接近喷嘴出口的区域里,出现了与射流内的激波、膨胀波有关的振荡流。
The influence of gas velocity from nozzle, distance between parts and nozzle exit, moving velocity of nozzle and crosswind velocity were systematically investigated on shielding gas field.
系统研究了喷嘴保护气流速度、喷嘴出口距零件表面距离、喷嘴移动速度和侧风速度对气体保护效果的影响。
The various flow patterns and corresponding various characteristics of local heat transfer of impingement flow are considered for the short distance between nozzle exit and target surface.
本文阐述了短距冲击情况下各种流型及相应的各种局部换热特性。
The various flow patterns and corresponding various characteristics of local heat transfer of impingement flow are considered for the short distance between nozzle exit and target surface.
本文阐述了短距冲击情况下各种流型及相应的各种局部换热特性。
应用推荐