When the distance of two nozzles was fixed, the offset of impinging stagnation point on the axis increased with the ratio of velocity and the nozzle diameter.
当喷嘴间距一定时，轴线撞击面驻点偏移量随气速比和喷嘴直径的增大而增大。
Then, the experiment of flow separation in the nozzle was done with a solid rocket motor, and the inside pressure data along the axis of the nozzle was gotten.
然后，利用某型号固体火箭发动机进行喷管分离流试验，测得了喷管壁面上沿轴向的压强分布数据。
The flow properties including chemical species distribution along axis of the nozzle were also presented.
并给出计算条件下喷管轴线上的物理量和化学组元分布。
Thrust misalignment in parabolic nozzle is investigated for the situation where the gas flow is misaligned with respect to the axis of the supersonic region of the nozzle.
研究了当气流偏离抛物型喷管超音速段对称轴时所引起的喷管推力偏心。
An elongate nozzle can extend from the vacuum chamber along a longitudinal axis and have an exit window at a distal end of the nozzle.
细长喷嘴可从真空室沿着纵轴延伸并具有喷嘴上部的出射窗。
The increase of the angle between centerline of nozzle orifice and axis of secondary combustor can promote collision number, but the effect is small.
喷口中心线与补燃室轴线的角度增加对碰撞有催进作用，但影响效果相对较小；
The thrust characteristics of axis symmetry nozzle were mainly measured in test. For the nozzle having a vectoring angle, the deflection efficiency was measured too.
对于轴对称喷管模型主要进行了喷管的推力特性测量，对于实施矢量偏转后的喷管模型除了给出了喷管推力特性外，还给出了喷管的偏转效率。
The hollow-axis motor drives the offset nozzle and rotates the arc on the tip of wire at high speed, so as to ensure enough penetration into the sidewalls in narrow gap welding.
在该系统中，焊丝穿过电机的空心轴后从导电嘴的偏心孔送出，电机带动导电杆和偏心导电嘴旋转，从而使焊丝端部的电弧以一定直径高速旋转，以保证窄间隙焊接接头具有足够的侧壁熔深。
The main products are: JP Series winch irrigation system, the transfer of irrigation system, PYC series of vertical rocker-type nozzle, QZ, QH, QSZ, QSH series axis (mixed)-flow submersible pump.
主要产品有：JP系列绞盘式喷灌机、移管式喷灌机、PYC系列垂直摇臂式喷头、QZ、QH、QSZ、QSH型系列轴（混）流式潜水电泵。
The flange face of agitator mount nozzle shall be perpendicular to vessel axis within tolerance of 1/500.
安装搅拌器的设备口的法兰面同容器轴线的垂直度容许偏差为1/500。
The flange face of agitator mount nozzle shall be perpendicular to vessel axis within tolerance of 1/500.
安装搅拌器的设备口的法兰面同容器轴线的垂直度容许偏差为1/500。
应用推荐