Consequently, no load current flows through R6 because Q2, whose base-emitter voltage is now 0v, has turned off.
由于Q2的基极-发射极的电压为0 V而截止，因此没有负载电流流过r6。
A static load balancer allocates processes to processors at run time while taking no account of current network load.
静态负载平衡在分配任务的时候并不考虑现时的网络负载情况。
Of course, the current specifications for the arch-bridge design will allow no such load to go over it.
这个特大荷载在现行桥梁设计规范中是绝对不允许通过江口桥。
The average of the line currents at rated voltage is the no-load current.
额定电压下线路电流的平均值即是空载电流。
In the no-load test of transformer, because of the low power factor and non-sinusoid current waveform, the high precision measurement is difficult.
变压器的空载试验中，由于功率因数低，空载电流不是正弦信号，高精度测量其有功功率具有一定的难度。
Its main transformer is made of imported cold rolled silicon steel, So its power loss is little with low no-load current.
该系列点焊机，主变压器均为进口冷轨硅钢片，因此，主变压器功耗小，各型空载电流小。
No fuse breaker, over pressure, over heat and over current protectors for compressor, over temp. protector, over load protectorof fan, dry heat pr techto.
无熔丝开关，压缩机超压，过热，过电流保护超温保护，风机过载保护，保险丝，干烧保护器，缺水保护。
Leakage current is very low after subjected to high temperature, no-load condition, or after long period of storage at normal temperature.
在高温无负荷或常温长期放置后，尚能保持良好的，低漏泄电流及特性。
Whereas if the switchgear load current is over 1250a is running, there is no necessary to keep the heater on.
但负荷电流1250a以上的开关柜在运行状态下，加热器可不投入。
The first harmonic winding and harmonic winding no-load property curve are gained when field current is change.
通过改变励磁电流的大小，得到了基波绕组和三次谐波绕组的空载特性曲线。
This article discusses the differential protection malfunction of transformers with no-load Input caused by, analyzes the emergence, hazards and characteristics of excitation inrush current.
论述了变压器空载投入时差动保护误动作原因是由励磁涌流引起的，分析了励磁涌流的产生、危害及其特点。
We study the calculating method and program the calculating software to simulate the exciter flow current on the no-load switching-in of transformer.
对涌流瞬态过程进行了分析，研究计算办法并编制了计算软件，可以对变压器空载合闸时的励磁涌流进行计算模拟。
Used for points and load current, closed loop current, no-load transformer and cable charging electric current, close short circuit current.
用于分合负荷电流，闭环电流，空载变压器和电缆充电电流，关合短路电流。
Used for points and load current, closed loop current, no-load transformer and cable charging electric current.
用于分合负荷电流、闭环电流、空载变压器和电缆充电电流。
If only phase current is used in breaker failure protection, miss trip may occur no matter the threshold of current is higher or lower than load current.
如果仅采用相电流判据，将无法避免失灵保护误动或者拒动。
If only phase current is used in breaker failure protection, miss trip may occur no matter the threshold of current is higher or lower than load current.
如果仅采用相电流判据，将无法避免失灵保护误动或者拒动。
应用推荐