The networked control system with packet losses is described as jump system.
将存在数据丢包的网络控制系统描述为跳跃系统。
Finally, the controller design of networked control system with data dropouts is investigated.
最后，研究了网络控制系统有数据包丢失情况下控制器的设计。
The networked control system can be modeled as Markovian jump linear systems with two operation modes.
将网络化控制系统建模为具有两种运行模式的马尔可夫跳变线性系统。
The optimal estimator of system state for networked control systems without full state information is presented.
给出了网络控制系统在不完全状态信息时系统状态的线性最优估计器；
With regards to the characteristics of uncertain delay of networked control system, two control schemes are introduced.
针对网络控制系统具有不确定时延的特性，介绍了网络控制系统的两种控制方法。
Assuming the transfer delay to be ignored, the networked control system is an asynchronous dynamic system with N-events.
假定传输时延可以忽略，则整个网络控制系统可以描述为一个具有N个事件的异步动态系统。
This thesis is concerned with problems of networked control system and remote communication technology based on network.
本文对网络控制系统和基于网络的远程通信这两个问题做了研究。
Considering the constraints of network bandwidth, multiple-packet transmission was adopted here in the networked control system.
针对网络带宽的限制，在网络控制系统中需要采用多包传输。
The sufficient condition to the exponential stability of the networked control system is derived from the conclusion of the ADSs.
利用异步动态系统的相关结论，给出网络控制系统指数稳定的充分条件。
This paper proposes a new method to design state feedback controller for networked control system (NCS) with time-varying delays.
为带时变时延的网络化控制系统提出了一种新的状态反馈控制器的设计方法。
In this paper, a novel adaptive predicted control method was proposed to analyze NCS (networked control system) with random delays.
采用自适应预测控制的方法对带有随机时延的网络化控制系统进行分析和研究。
Networked control system shares the resource, reduces system wiring and increases the convenience of system diagnosis and maintenance.
网络化控制系统实现了资源共享、减少了系统布线、提高了系统的可诊断性和可维护性。
We consider the networked control system (NCS) from linear quadratic Gaussian (LQG) method, switched system and neural network control.
对网络控制系统分别从高斯型二次最优（LQG），切换系统和神经网络控制三个方面来考虑。
Networked control system is a comprehensive control system based on network, it combines computer, telecommunication and control technology.
网络控制系统是基于网络技术的分布式控制系统，是融合了计算机技术、通信技术与控制技术的复杂系统。
Due to the bandwidth constraint and the unreliable transmission of network, data-packet dropout exists inevitably in networked control system.
由于网络带宽的限制以及网络的不可靠传输等特点，不可避免的使系统中存在数据包丢失的现象。
The fault diagnosis of multi-input and multi-output distributed networked control system with periodic communication sequence(PCS)was investigated.
提出了带有周期通信序列（PCS）的多输入与多输出分布式网络化控制系统的故障诊断方法。
Firstly, the concept and model of networked control system is given. After that, the article makes an analysis of its advantages and disadvantages.
首先，本文给出了网络化控制系统的概念及其模型，分析了其优缺点。
A sampled-data control system approach is presented to a class of affine nonlinear networked control systems described by a hybrid dynamic system model.
利用采样数字控制系统的方法分析了一类混杂动态系统模型描述的仿射非线性网络控制系统的稳定性问题。
In networked control system, network is not only one medium through which data of control system can be transmitted but also one part of control system.
在网络控制系统中，网络不仅是控制系统的数据传输的一种媒介，同时也是控制系统的一部分。
A new stability analysis method of networked control system is provided, and the conditions of network time delay which can make system stable are derived.
提出了一种新的网络控制系统稳定性分析方法，得到了使系统稳定的各网络延时应满足的条件。
Firstly, the networked control system model with random time-delay is simplified and transformed into a discrete-time system model with uncertain parameters.
首先对具有随机时滞的网络控制系统模型进行简化，导出了具有不确定系数的时滞离散时间系统模型。
Exponential stability and controller design problems for networked control system (NCS) with time-varying delay and multiple-packet transmission were studied.
对时变时延多包传输网络控制系统的指数稳定性和控制器设计问题进行研究。
Although networked control system has many advantages, induced delay and data dropout which is caused by network can greatly affect performance of control system.
虽然网络控制系统有很多的优点，但是由于网络带来的诱导延时和数据丢包对控制系统的性能有很大的影响。
The experimental result shows BLDCM response rapidly and run stableness in networked control system and proves the validity and feasibility of this control system.
实验结果表明：在网络控制系统中无刷直流电动机转速响应快速，运行平稳，证明了这种新型控制系统的有效性和可行性。
A two-degree-of-freedom internal model controller (IMC) is designed for networked control system (NCS) to deal with the network-induced delay and plant uncertainty.
针对网络化控制系统中网络时滞与对象模型不确定性，提出了一种二自由度内模控制器的优化设计方法。
If the network time delay of networked control system satisfies these conditions, the poles of networked control system are in a circular area on the complex plane.
只要系统的网络延时满足这些条件，网络控制系统的极点便分布在复平面内的一个圆形区域内。
Then, by Lyapunov function and linear matrix inequality(LMI), the sufficient conditions are given to make the singular networked control system exponentially stable.
利用李雅普诺夫函数方法和线性矩阵不等式方法，给出了广义网络控制系统指数稳定的充分条件。
With regards to the characteristics of uncertain transmission delay and packet dropout of networked control system (NCS), a distributed model is proposed in this paper.
针对网络化控制系统(ncs)具有不确定性的传输迟延与数据丢包特性，设计了一个分布式的网络化控制系统模型。
The sufficient stability conditions of SISO and MIMO networked control system with data dropouts are presented, data dropout rate is determined to ensure stability of NCS.
给出了单输入单输出和多输入多输出网络控制系统中存在数据包丢失情况下均方随机稳定的充分条件和丢包边界的确定方法。
The sufficient stability conditions of SISO and MIMO networked control system with data dropouts are presented, data dropout rate is determined to ensure stability of NCS.
给出了单输入单输出和多输入多输出网络控制系统中存在数据包丢失情况下均方随机稳定的充分条件和丢包边界的确定方法。
应用推荐