The networked control system with packet losses is described as jump system.
将存在数据丢包的网络控制系统描述为跳跃系统。
Shenguang III control system is a typical application of networked control technology in weaponry arming.
神光III控制系统就是网络化控制技术在武器装备上的一个典型应用；
This paper deals with fault tolerant control of a Networked control Systems (NCS) problem with network delay.
本文是针对一类有网络延时的网络化控制系统，研究其故障容错控制问题。
Networked control systems are integration of controlling science, computing science and networking technology.
网络控制系统是控制科学、计算机及网络技术的综合应用。
The optimal estimator of system state for networked control systems without full state information is presented.
给出了网络控制系统在不完全状态信息时系统状态的线性最优估计器；
The design of stochastic optimal controllers of networked control systems with output feedback is also presented.
讨论了网络控制系统在输出反馈情况下随机最优控制器的设计；
Networked control systems are integration of controlling science, computing network and communicating technology.
网络控制系统是控制科学和计算机网络及通讯技术的综合应用。
The paper proves that optimal controllers can stabilize the exponentially mean square of networked control systems.
并证明了该最优输出反馈控制律可使网络控制系统均方指数稳定。
With regards to the characteristics of uncertain delay of networked control system, two control schemes are introduced.
针对网络控制系统具有不确定时延的特性，介绍了网络控制系统的两种控制方法。
A discrete sliding mode control is proposed for the problem of network-induced time delays in networked control systems.
针对网络化控制系统中存在的网络诱导时延问题，提出了一种离散滑模控制方法。
Assuming the transfer delay to be ignored, the networked control system is an asynchronous dynamic system with N-events.
假定传输时延可以忽略，则整个网络控制系统可以描述为一个具有N个事件的异步动态系统。
And then the methods of scheduling, control and scheduling co-design in networked control systems are studied in this paper.
本文主要对网络控制系统的调度方法以及控制与调度协同设计方法进行研究。
The research contents of this thesis are about stability analysis of networked control systems (NCS) with multiple-time delay.
本论文的研究内容为网络控制中多延时系统的稳定性分析。
Considering the constraints of network bandwidth, multiple-packet transmission was adopted here in the networked control system.
针对网络带宽的限制，在网络控制系统中需要采用多包传输。
The sufficient condition to the exponential stability of the networked control system is derived from the conclusion of the ADSs.
利用异步动态系统的相关结论，给出网络控制系统指数稳定的充分条件。
This paper proposes a new method to design state feedback controller for networked control system (NCS) with time-varying delays.
为带时变时延的网络化控制系统提出了一种新的状态反馈控制器的设计方法。
The networked control systems have many uncertain characteristics, so there is a new challenge to the design of robust controller.
网络控制系统具有很多不确定性，对控制器的鲁棒性设计提出了新的挑战。
The problem of robust controller design for dynamic output feedback networked control systems with uncertain time-delay is studied.
研究了具有不确定时延的动态输出反馈网络控制系统鲁棒控制器设计问题。
Aiming at the networked control problem, a united model is established including variable network time-delay and data dropout, etc.
针对网络控制问题，建立包含变网络时延及网络传输丢包等的统一模型。
In this paper, a novel adaptive predicted control method was proposed to analyze NCS (networked control system) with random delays.
采用自适应预测控制的方法对带有随机时延的网络化控制系统进行分析和研究。
This paper deals with the problem of stabilization and L_2-gain analysis of networked control systems subject to actuator saturation.
针对含执行器饱和网络化控制系统，研究其镇定问题与L_2增益分析。
We consider the networked control system (NCS) from linear quadratic Gaussian (LQG) method, switched system and neural network control.
对网络控制系统分别从高斯型二次最优（LQG），切换系统和神经网络控制三个方面来考虑。
The problem of robust fault-tolerant control for networked control systems (NCS) with uncertain time-delay and uncertain parameter is studied.
研究了一类具有网络诱导时延和参数不确定性网络化控制系统鲁棒容错控制问题。
A new method is proposed to obtain the maximum allowable delay bound (MADB) of multi-input and multi - output (MIMO) networked control systems.
提出确定多输入多输出网络控制系统的最大允许时延界的新方法。
The fault diagnosis of multi-input and multi-output distributed networked control system with periodic communication sequence(PCS)was investigated.
提出了带有周期通信序列（PCS）的多输入与多输出分布式网络化控制系统的故障诊断方法。
The modeling, analysis and control of the model-based networked control systems (NCSs) with multi-rate input sampling are studied in this dissertation.
本文主要研究了基于模型的网络化输入多率采样控制系统的建模、分析与控制问题。
A sampled-data control system approach is presented to a class of affine nonlinear networked control systems described by a hybrid dynamic system model.
利用采样数字控制系统的方法分析了一类混杂动态系统模型描述的仿射非线性网络控制系统的稳定性问题。
A new stability analysis method of networked control system is provided, and the conditions of network time delay which can make system stable are derived.
提出了一种新的网络控制系统稳定性分析方法，得到了使系统稳定的各网络延时应满足的条件。
Networked control systems (NCS) are a kind of closed-loop control systems where the sensors, the controller and the actuators exchange data through network.
传感器、控制器与执行器的数据经网络进行传输与交换的闭环控制系统称为网络控制系统。
Exponential stability and controller design problems for networked control system (NCS) with time-varying delay and multiple-packet transmission were studied.
对时变时延多包传输网络控制系统的指数稳定性和控制器设计问题进行研究。
应用推荐