A tuning method for decentralized PID controllers was developed based on probabilistic robustness for use in multi-input-multi-output plants with varying parameters.
基于概率鲁棒方法，针对具有实参数不确定性的多输入多输出被控对象，提出一种分散PID控制器设计方法。
An multi-input intellect alarm device based on CAN bus is designed.
设计了一种基于CAN总线的多路智能报警装置。
The support vector machines(SVM) model with multi-input and single output was proposed.
建立了多输入、单输出的支持向量机（SVM）预测模型。
This paper shows that, for a multi-input-multi-output system, a generalized input can be derived.
本文证明，对于多输入、多输出系统可以导得一广义输入量。
Then the dynamic configuration is derived, which is a multi-input and multi-output nonlinear system.
它是一个多输入多输出的非线性系统。
We consider the global stabilization of a class of multi-input cascade switched nonlinear systems with a linear switched part.
研究一类带有部分线性系统的多输入级联非线性切换系统的全局镇定问题。
The key to VSC for multi-input nonlinear system is the design of a switch function which should ensure the stabilization of sliding mode.
多输入非线性系统变结构控制器设计的关键之一是寻求切换函数使得滑动模态渐近稳定。
Sensor array can measure many signals synchronously. However, it is the key of sensor array to decompose and pick up multi-input signals.
传感器阵列可同时对多个信号进行测量，而对多个输入信号进行解耦和并行提取是其关键。
This article, at first, establishes residual random process for the multi-input and mono-output linear system of stationary random process.
本文首先对平稳随机过程的多输入单输出线性系统建立剩余随机过程。
AD73360 is a programmable three-phase electrical parameter measurement IC chip. It is mainly used in industry ammeter and multi-input systems.
AD 73360是一主要适用于工业电表和多路输入系统的可编程三相电量测量ic器件。
A new method is proposed to obtain the maximum allowable delay bound (MADB) of multi-input and multi - output (MIMO) networked control systems.
提出确定多输入多输出网络控制系统的最大允许时延界的新方法。
A partners choice algorithm is proposed based on cooperative multi-input multi-output(MIMO) transmission in energy-constrained sensor networks.
针对无线传感器网络高能效传输要求，提出了一种基于虚拟多输入多输出（MIMO）传输的协作中继节点选择算法。
A systematic procedure has been developed for the synthesis of robust regulatory control systems comprising multi-input multi-output controllers.
本文对于包含多输入多输出控制器的鲁棒控制系统作了系统化的研究。
The buoyancy force moment balance equation imposed simplifies the multi-input twi-output coupling (system) into multi-input single output system.
将气囊浮力力矩平衡关系式引入方程组，使多输入双输出耦合系统简化为多输入单输出系统。
The fault diagnosis of multi-input and multi-output distributed networked control system with periodic communication sequence(PCS)was investigated.
提出了带有周期通信序列（PCS）的多输入与多输出分布式网络化控制系统的故障诊断方法。
Decoupling control is an important issue of multi-input and multi-output system, and it's also the difficult problem of modern industrial production.
解耦控制是多输入多输出系统的重要问题，是现代工业生产的难点问题。
The method fit for the program operation of the computer can be easily used for the synthesis of a finite automation with multi-input and multi-state.
该方法适宜于计算机编程操作，因此可方便地用于多输入多状态有限自动机的综合。
For this generalized input, Nyquist criterion can be used to determine the stability of a multi-input-multi-output system as in a single-input system.
对于这一广义输入量，可以象单输入系统那样应用奈魁斯特准则来判别系统的稳定性。
Then a C2R Data Envelopment Analysis (DEA) decision model with multi-input and output was built to assess whether technique and scale were simultaneously efficient.
在此基础上，建立了基于技术与规模同时有效的多投入多产出的C2R数据包络分析决策模型。
On this basis, the application sphere of unascertained rational number filtering is analyzed and it applied to the data-processing conditions of multi-input and single-output.
在此基础上，分析了未确知有理数滤波的适用范围，指出其应用于多输入单输出的数据处理情况。
By adopting fuzzy neural networks method, the cooperation CWA model of multi-input and multi-output is established which is used in supporting vehicle collision warning system.
基于报警准则采用模糊神经网络方法，提出一种多输入、多输出的协作预警算法模型，用于支持碰撞预警系统。
A global sliding model variable structure control approach and a sort of hierarchical switching scheme used with equivalent equation are proposed for a class of multi-input systems.
在多输入系统控制中提出了全程滑模变结构控制方案和利用等效滑模方程进行的递阶滑模变结构控制方案。
A global sliding model variable structure control approach and a sort of hierarchical switching scheme used with equivalent equation are proposed for a class of multi-input systems.
在多输入系统控制中提出了全程滑模变结构控制方案和利用等效滑模方程进行的递阶滑模变结构控制方案。
应用推荐