Moving characteristic of double toggle is in accordance with mould open and close requirement, which is high speed and stable.
双曲肘机铰，运动特性符合机器开合模具要求，高速稳定；
As a result, a mould with double stripper mechanism was needed, that is to say, there were levers and ejector pins on the stationary mould half and ejector pipes on the moving mould half.
为保证顺利脱模，模具设计采用了双脱模机构，即定模采用杠杆、推杆顶出机构，动模采用推管二级顶出机构。
In the design of the plastic mould, a latch_lock mechanism was designed to transfer the machine driving force from the moving half to the fixed half to make the ejection system of the fixed half work.
在塑料模具设计中，设计一种延时脱开机构将机床动力由动模传递给定模，使定模顶出机构工作；在侧抽芯机构中设计出一种顶出机构，改善塑件的成型质量，防止塑件脱模时的变形。
The formula for moving mould casting passage assemble gap in the case of no steel leaking has been deduced by the viscosity fluid mechanics method.
本文应用粘性流体力学的方法推导了在钢不钻漏情况下移动式结晶器浇铸通道配合间隙公式。
Acentric ingates are used to set on the moving mould and slag-collector is set at the end of ingate and at converging zone of liquid metal from two sides.
选择偏心的分支浇道，并将浇道设置在动模一侧。在浇道的末端和两侧金属液汇集区域分别设置集渣包。
The effect of slow moving resulted by tension force can also not effectively overcome, though the utility model is improved, comprising opening a dead slot on the mould and adding a direct die.
虽经改进，在胎具上开空槽、增设导向模等，仍不能有效克服纬线张力造成的迟滞效应。
The effect of slow moving resulted by tension force can also not effectively overcome, though the utility model is improved, comprising opening a dead slot on the mould and adding a direct die.
虽经改进，在胎具上开空槽、增设导向模等，仍不能有效克服纬线张力造成的迟滞效应。
应用推荐