The heat transfer of mold flux in mold was investigated in laboratory.
在实验室模拟研究了结晶器内酸性保护渣的传热情况。
The experimental results are of certain significance in guiding the design of the thin slab CC mold flux.
实验结果对于薄板坯连铸保护渣的设计具有一定的指导意义。
The results of industrial application show that the developed mold flux encouraged good utilizing effects.
工业试验表明：研制的保护渣具有良好的使用效果。
The reason and mathematic analysis for carbon pick up from mold flux have been investigated in ultra low carbon steel.
研究高温下耐火材料的相对稳定性及在真空熔炼超低氧钢过程中炉衬材料向钢液供氧的热力学条件和动力学规律。
The vortex flow and mold flux entrapment in the thin slab continuous casting mold was investigated using a 1/4 scale water model.
利用1/4水模型对薄板坯连铸结晶器内的涡流及卷渣行为进行观察研究。
The effect of expanding graphite content and temperature on the thermal conductivity of compound mold flux is studied through laboratorial measures.
研究了可膨胀石墨含量和温度对复合保护渣导热系数的影响规律。研究结果可用于：计算钢锭模帽口散热及帽口内钢水凝固时间；
An unreasonable liquid steel flow behaviors have an effect on inclusion flotation, bubble distribution, liquid mold flux fluid capability and spreadability, shell growth, etc.
不合理的钢液流动行为，会影响夹杂物的上浮、气泡的分布、保护渣的熔化及铺展性能、初生坯壳的形成等。
The distribution of magnetic flux density along narrow face is more uniform than that along the wide face of soft-contact mold.
沿结晶器窄面的磁场分布比较均匀，而宽面上的磁场分布均匀性较差。
The results show that the electromagnetic flux overlap aooears distinctly at the corner of rectangular soft-contact mold.
结果表明，矩形软接触电磁连铸结晶器角部存在明显的磁场叠加现象；
Average heat flux and local flux in mold for round billet are studied.
对圆坯连铸结晶器平均热流和局部热流进行了研究。
Manufacture and application of a kind of improved phenolic resin used as sintering flux to shape laser rapid molding sand mold was introduced.
介绍了激光快速成型砂型铸模用的一种烧结剂的制作和应用。
The heat flux of curved mold for round casting was measured by special-designed heat flux sensor.
笔者采用专门设计的热流传感器对弧形连铸圆坯结晶器的热流进行在线检测。
And the surface velocity of molten metal in the mold was minimal at a magnetic flux density of 0.5 t, it agreed well with measured surface level fluctuations in water modeling.
施加0.5T的磁场使结晶器内金属液的表面流速最小，这一计算结果与实验结果十分吻合。
And the surface velocity of molten metal in the mold was minimal at a magnetic flux density of 0.5 t, it agreed well with measured surface level fluctuations in water modeling.
施加0.5T的磁场使结晶器内金属液的表面流速最小，这一计算结果与实验结果十分吻合。
应用推荐