The design of the injection mold of multiple points, plates and molded surfaces is simplified by using lock catch facility, joined tie-bar structure and decreasing the guide-pin amount.
应用锁扣装置、组合拉杆结构，减少导柱数量，简化了多点多板多分型面注塑模具的设计。
Direction: Cleanse hair and swab down , apply appropriate amount evenly over hair to mold hairstyle.
使用方法：洗净头发并擦干，再取适量均匀涂于秀发上，即可随意塑造理想发型。
The amount of bacteria, microzyme, mold and actinomycete in medium-temperature Daqu were higher than those in high-temperature Daqu.
中温大曲中细菌、酵母、霉菌和放线菌数量均高于高温大曲。
Finally, we have to open mold and produce small amount of products. Then customers would demand to change something, but at that time, we have no way to change them.
最后不得不开模，最后小批量出货，客户说产品需要改什么什么，但那个时候模具已经没办法改动了。
Finally, we have to open mold and produce small amount of products. Then customers would demand to change something, but at that time, we have no way to change them.
最后不得不开模，最后小批量出货，客户说产品需要改什么什么，但那个时候模具已经没办法改动了。
应用推荐