This topic use the embedded microprocessor to be responsible to control the entire communication card system, thus processing speed is effectively enhanced.
课题采用嵌入式微处理器负责控制整个通信板卡系统，从而将接口处理速度有效的提高了。
The growing processor-memory performance gap was solved. The communication bottlenecks of traditional microprocessor, which is used for media processing application, were discussed.
针对处理器与存储器之间日益增长的性能间隙问题，分析了传统微处理器对媒体处理应用的通讯瓶颈；
In the design, the microprocessor DS80C390 with embedded CAN controller is used to implement the functions of communication between intelligent circuit breakers.
本设计采用内嵌有CAN控制器的DS80C 390微处理器来实现智能断路器的可通信功能。
This instrument based on LPC932 as the key microprocessor to gather , deal with and store data, to control real-time clock, to complete the liquid crystal display and communication.
该仪器基于LPC932单片微机为核心微处理器，来完成数据采集、处理，存储，实时时钟控制，液晶显示，通信等功能。
Communication microprocessor is designed for acquisition device to make the measurement system expandable into multiple measuring devices.
最后为采集设备设计了通信微处理器，使测量系统可扩展多个测量设备；
This paper presents a communication technique between DSP and a data acquisition system based on traditional microprocessor, mainly no hardware principle and software design method.
本文就硬件构成原理和软件设计方法，介绍了DSP芯片与基于传统单片机的数据采集系统通信的技术。
Electronic control unit ECU used AT89C51 microcontroller as a microprocessor, including data acquisition module, switch input module and CAN communication module.
电子控制单元ecu采用AT 89 C 51单片机作为微处理器，设计了数据采集模块、开关量输入模块以及CAN通信模块。
Finally, the software which analyse communication and measuring data between chip microprocessor and PC is completed based VB6.0.
最后，基于VB6。0的环境设计出上、下位机通信和测量数据管理分析软件。
By use of MCS-51 chip microprocessor, it can fulfill the tasks, such system control and management, programmable control communication and continuous regulation of voltage with high accuracy.
该系统采用了MCS - 51单片机实施系统控制与管理、电压连续调整、通讯程控等功能，因而精度高、自动化功能强、使用方便。
Joining a engineering, this paper gives the high speed and low consuming circuit of network communication based on the microprocessor of S3C4510B, it takes DM9161 as a physical layer interface.
文章结合工程实例，基于S3C 4510 B微处理器构建了以DM 9161为以太网物理层接口的低功耗、高速硬件电路。
The detection method of mechanical faulty includes how to choice the microprocessor and how to extend the circuit. The communication methods and the anti-interfere has been decided.
故障检测部分包括主处理芯片的选择、针对主处理器的外围电路的扩展、数据通信方式的确定和抗干扰方法的选择。
Because of its ability of tracking, acquisition and operating as a narrow-band filter, PLL is widely used in many fields such as astronautics, communication, microprocessor, and so on.
由于锁相环具有捕获、跟踪以及窄带滤波的能力，因此它被广泛地应用于航天、通信以及微处理器等许多领域。
Wireless sensor networks, composed by sensors, microprocessor and wireless communication interface, is an interesting field, and gain more and more attentions.
由传感器、微处理器和无线通信接口组成的无线传感器网络是一门日益引起人们研究兴趣的技术。
In accordance with the deficiencies in signal transmission of Marine data acquisition system, the microprocessor-controlled wireless communication system is put forward.
本文针对海上数据采集系统在信号传输方面存在的不足之处，提出采用微机控制下的无线通信方式进行改进。
This terminal's hardware design mainly includes the choice of microprocessor chip, the interface design of MC35 module of communication, the circuit design of memory modules and serial port and so on.
该终端的硬件设计，主要包括微处理器芯片的选型、MC35通讯模块的接口设计、存储器单元及串口电路设计等。
Through programming the com port of microprocessor realized the communication with PC.
通过单片机内部的串行口编程完成了单片机和PC机之间的通信。
A practicable hypercube multi-microprocessor system design is presented with more details of its communication control board.
最后给出一个实用超立方体多微处理机系统的设计，着重讨论了其通信控制板的设计。
This paper describes a way to establish a communication agreement between the 8098 chip microprocessor and the microcomputer, which is suitable for the processing of a large amount of data.
本文介绍一种8098单片机与微机间的通信协议和方法。这种方法特别适合于数据量较大的场合。
To improve BLDCM control result, this paper establishes a full digital double closed loop system which USES microprocessor-TMS320LF2407A to control the communication and speed of BLDCM.
为了提高无刷直流电机的控制效果，运用TMS320 LF 2407 A芯片，建立了无刷直流电机全数字双闭环控制系统，给出了硬件电路设计和部分软件编制方法。
To improve BLDCM control result, this paper establishes a full digital double closed loop system which USES microprocessor-TMS320LF2407A to control the communication and speed of BLDCM.
为了提高无刷直流电机的控制效果，运用TMS320 LF 2407 A芯片，建立了无刷直流电机全数字双闭环控制系统，给出了硬件电路设计和部分软件编制方法。
应用推荐