Then this paper presents the method to simulate active jamming.
在此基础上，研究有源干扰的模拟方法。
This paper presents a new method to simulate large areas of near-shore waves.
提出一种可以逼真地模拟大面积近岸海浪的方法。
It is an efficacious method to simulate the SEU with Heavy Ion produced by Accelerator.
依靠加速器产生的重粒子进行单粒子翻转的模拟实验，是一种有效的验证方法。
A numerical method to simulate nonlinear fluid-rigid structure interaction problems is developed.
给出了一种模拟非线性流体-刚体结构相互作用问题的数值方法。
It is a feasible method to simulate the firing process of the gun by use of muzzle strong impact.
通过炮口强冲击模拟火炮的射击过程是一种技术可行的火炮动力后坐模拟方法。
The calculated results indicate that it is feasible to use LES method to simulate the cavitation.
计算结果表明，采用大涡模拟方法模拟空化是可行的。
Last, the article applies the method to simulate the engineering of No. 3 of Dalian Quick Railway.
最后本文利用循环运行网络对大连快速轨道3号线轨道工程施工进行了计算机模拟。
A new numerical method to simulate ground water flow in fractured or faulted aquifer is presented.
本文提出了模拟裂隙与断层含水层中地下水流动的一种新的数值方法。
First, use the finite element method to simulate the cylindrical specimen and the plate specimen rutting test.
首先，采用有限元方法建立模型，模拟圆柱形试件和板式试件的车辙试验。
This paper used a finite-rate method to simulate the three-dimensional combustion process in a plasma generator.
针对等离子点火器内三维湍流燃烧流场，采取有限速率化学反应模型，模拟其物理化学过程。
Complex analysis is an effective finite element method to simulate the dynamic response of rock soil mass to earthquake.
复反应法是用来分析地震动力作用下岩土体动力性质的有限元方法之一。
A new method to simulate wrinkles on individual face model was presented, which applied convolution surface to face modeling.
将卷积曲面应用于人脸建模，提出了在个性化人脸模型上生成皱纹的新方法。
This paper makes use of Monte Carlo method to simulate the uncertainty of extracted DEM using Jiangning as an experimental area.
本文以江宁为实验区，用蒙特卡罗方法对所提取的DEM进行不确定性模拟。
At last, the study of using Monte-Carlo method to simulate the growth of thin films by physical vapor deposited is also predicted.
最后对蒙特卡罗方法模拟薄膜生长的研究进行了展望。
A method to simulate the characteristics of insulated gate bipolar transistor (IGBT) with PSPICE program is proposed in this paper.
提出了一种用PSPICE程序模拟绝缘栅双极型晶体管(IGBT)特性的方法。
Use finite element and infinite element technology, and unified method to simulate flow noise, vibration noise and sound propagation.
采用有限元和无限元技术，用统一的方法模拟流动噪声、振动噪声及声传播问题。
The method to simulate the temperature field with cooling pipes by ANSYS is proposed, and the key problems in the process is analyzed.
提出了用ANSYS有限元软件模拟冷却水管温度场的计算方法，并对模拟过程中的关键问题进行了分析。
Use of imaginary elastic wall method to simulate the action of moving particle's on the wall of vessel at balance state was suggested.
本文提出，在用蒙特卡罗方法模拟平衡态容器中运动粒子的器壁行为时，可以采用假想弹性壁方法。
A simulating algorithm based on resistor net cell which is a method to simulate sheet resistors with any shapes is presented in this paper.
提出了一种模拟任意形状的薄层电阻的方法——电阻网络元模拟算法。
In the numerical model a 'narrow slot 'method is adopted to simulate mobile shore line and an eddy viscosity method to simulate wave breaking.
模型中通过“狭槽法”来处理波浪在岸线处的动边界条件，采用涡粘模型来模拟波浪破碎引起的能量耗散。
A method to simulate network operations by adding the corresponding Branch-Impedance Matrix to the original network is described in this paper.
文中介绍了采用向网络操作前的原网络追加相应的支路阻抗阵来模拟网络操作的方法。
In the later chapter, system dynamics is used as an effective modeling method to simulate the supply chain system and compare the performance of the enterprises.
在模拟结果的基础上，重点讨论了供应链企业在不同运作模式下的表现和资金约束对供应链企业绩效的影响。
Anew method to simulate the hydrocyclone classification was developed in this paper for overcoming the shortcomings of theoretical and empirical simulating method.
本文针对通常水力旋流器理论模型和经验模型存在的缺陷，提出了利用“黑箱理论”与“相似理论”相结合的模拟方法——相似模拟法。
The normal method to simulate earthquake acceleration time history is analyzed, and it is shown clearly that choice of initial acceleration time history is important.
分析了地震加速度时程模拟的常规方法，指出初始加速度时程的选取十分重要。
The mechanism of this effect was further investigated by using finite element method to simulate the evolution of pre-damage voids during the subsequent loading process.
并进一步对初始损伤孔洞在后续加载中的演化行为的细观有限元力学进行模拟计算及微孔洞初始损伤对钢的延性起裂韧性影响的机理进行了研究。
Based on the hierarchical block element method presented earlier, a new concept of subordinate cover and a method to simulate the tension crack in rocky block are proposed.
基于阶谱块体单元法，提出了二次覆盖的概念和一种分析岩石块体受拉开裂破坏的方法。
To achieve the purpose, we have developed a calculation method of numerical simulation and the ways on how to use the method to simulate a model of the area source properly.
采用数值模拟计算的方法，对面源模式做了实际计算，并将其计算结果与虚点源后置法做了分析和比较。
A new method to simulate directly and predict the formation process of shrinkage cavity, its final shape and position for steel castings and ingot was proposed using computer.
提出了可用计算机直接模拟钢铸件、铸锭缩孔形成过程及最终形状和位置的直接模拟法。
In this paper, a method based on the combination of Manifold and Singular Boundary Element method to simulate seismic responses and failure processes of structures is presented.
本文提出了用流形无法和子域奇异边界元法相结合模拟结构地震响应及地震破坏的方法。
In this paper, a method based on the combination of Manifold and Singular Boundary Element method to simulate seismic responses and failure processes of structures is presented.
本文提出了用流形无法和子域奇异边界元法相结合模拟结构地震响应及地震破坏的方法。
应用推荐