ADT2550F is New IR Receiver IC with low input current and 22ms pause time acceptable.
ADT2550F是新的红外线接收器IC与低输入电流和22ms暂停时间可以接受的。
By putting the high-power (high current) and low power sections in different boxes we can help protect the input signals from harm.
通过将大功率(大电流)和小功率放大电路分置在不同的单元中，就可以避免输入信号受到干扰。
The typical SourceMeter instrument doesn't have as high an input impedance or as low a current capability as a source-measure unit.
典型的数字源表不像源-测量单元那样具有极高输入电阻或极低的弱电流测量能力。
An electrometer makes an ideal coulombmeter because it has very low input offset current and high input resistance.
静电计是一个理想的库仑计，因为它具有非常低的输入偏置电流和很高的输入电阻。
Simulation and experimental results show that the proposed converter has sine wave input current and output voltage, low harmonic content, adjustable power factor, and zero voltage commutation.
仿真和实验结果表明：所提出的变换器输入电流和输出电压为正弦，谐波小且输入功率因数可控，并可实现零电压换流。
Experiment result showed, the topology can make the device get to high Power Factor (PF), low Total Harmonic Distortion (THD) of input current, low ripple of output voltage, and high efficiency.
实验结果表明，应用该电路拓扑的实验装置，其功率因数较高，输入电流的总谐波畸变较低，输出电压纹波小，而且整个装置的效率也比较高。
The algorithm yields low common mode voltage and current, acceptable PWM ripple at the input and output of the inverter, and has no overvoltage problems unlike AZSPWM1.
该算法产量低共模电压和电流，在可接受哒PWM输入纹波 和输出哒逆变器，并没有过电压 提问题不要像AZSPWM1。
The high temperature materials, phased array sensor, and low current requirements stabilize the output signals over a wide range of input voltage, ambient temperature, or output frequencies.
高温材料，相控阵传感器，低电流的要求较稳定的输入电压，环境温度，或输出频率范围的输出信号。
The system consists of the AC input stage, single phase PFC, main inverter, output low-pass filter, auxiliary power supply, and load current sharing circuit, etc.
整个电源由输入电路、功率因数校正器、主逆变器、输出滤波电路、辅助电源、均流电路等部分组成。
A easier and low-cost power control method is proposed in this paper, based on the regulation of the average input current of the inverter.
通过控制逆变器输入平均电流调节负载功率，简化了电路设计；通过单片机发出高频加低频调制的半桥驱动信号，消除调光过程中的电弧不稳定现象。
A easier and low-cost power control method is proposed in this paper, based on the regulation of the average input current of the inverter.
通过控制逆变器输入平均电流调节负载功率，简化了电路设计；通过单片机发出高频加低频调制的半桥驱动信号，消除调光过程中的电弧不稳定现象。
应用推荐