One of the differences is trivial: You're now looping over a list rather than an array, which causes minor changes in the loop control.
其中有一点微不足道的差别：现在将在一张列表内而不是在数组中循环，这将导致需要在循环控制中执行一些小更改。
This type of rotor position sensor lays a foundation for the closed-loop control of step motor.
这种新型位置传感器为进一步实现步进电动机闭环控制奠定了基础。
Networked control systems (NCS) are a kind of closed-loop control systems where the sensors, the controller and the actuators exchange data through network.
传感器、控制器与执行器的数据经网络进行传输与交换的闭环控制系统称为网络控制系统。
The dynamic positioning system is a closed loop control system which resists against the disturbance by wind, wave, and current with the help of thrusters on the vessel.
动力定位系统是一种闭环控制系统，采用推力器来提供抵抗风、浪、流等作用在船上的环境力，从而尽可能使船舶保持在海平面要求的位置上。
The accurate measurement of oxygen content in flue gas of coal-fired power plant has significant meaning for the realization of combustion system's closed-loop control and optimization running.
燃煤电厂烟气含氧量的准确测量对实现燃烧系统的闭环控制和优化运行具有重要的意义。
The design succeeds in realizing open-loop control of step-motor.
设计成功实现了步进电机的开环控制。
The instantaneous optimal closed-open-loop control equations are derived.
求出了瞬时开闭环最优化控制方程。
We present a novel current-following SPWM inverter with delay-loop control.
研究了一种滞环控制的电流跟踪型SPWM逆变器。
The voltage ratio is derived and the system closed-loop control is realized with PI regulator.
从理论上推导了电压传输比，采用PI调节器实现了系统的闭环控制。
DELTA AC servo motors and controllers to determine the precise length cut, closed loop control.
采用台达交流伺服电机及控制器实现精确定长剪切，全闭环控制。
Parameter perturbation bounds for robust stability of the closed loop control system are given.
给出了闭环控制系统保持大范围一致稳定时参数摄动应满足的限度。
The closed loop control of the motor position and velocity are realized using the microcomputer.
采用计算机实现了变磁阻电机的位置和速度闭环控制。
Measurement principle of three coordinate measuring machine based on half-closed loop control is introduced.
介绍了一种基于半闭环控制的三坐标测量机的测量原理。
To realize real time closed loop control, high performance 16-bit DSP TMS320F240 is adopted as control kernel.
控制系统以16位数字信号处理器TMS320F 240为核心，对整个电源进行了实时的闭环控制。
In this paper, the closed-loop control method of hybrid step motor using the harmonic back EMF is investigated.
研究了利用谐波反电势信号实现混合式步进电动机闭环控制的方法。
Due to the particular load characteristic, both the current loop and voltage loop control circuits are devised.
并且针对其独特的负载特性，在设计电流闭环控制电路的同时，还设计了电压环控制电路。
It can be concluded that by way of torque feedback closed loop control, transmission shift shock can be reduced.
实验结果表明，通过扭矩反馈闭环控制方法，可以减小变速箱换档的冲击。
The single close-loop control method of HFL inverter based on voltage feedback was designed for better performance.
控制系统采用瞬时电压单闭环控制策略，以提高高频链逆变电源的动静态特性。
The paper makes experimental research for its designing scheme of double close-loop control based on fuzzy self-tuning PI.
并且对模糊自整定PI双闭环控制设计方案进行了实验研究。
This paper presents a parametric open plus closed loop control approach to controlling chaos in continuous dynamical systems.
针对可能呈现混沌性态的连续动力学，提出了一种参数开闭环控制方案。
Brushless motor control system design based on C8051 was introduced, speed and current double close loop control was realized.
论述了基于C8051的直流无刷电机控制系统设计，实现了速度、电流的双闭环控制。
A novel plasma spray power supply based on ZVS soft-switching technology and double close loop control mode is presented in this paper.
介绍了一种基于零电压软开关技术和双闭环控制模式的大功率等离子喷涂高频开关电源。
A general introduction was made on effect, control principle and PLC logic control of the loop control system in high speed rod rolling.
概述活套控制系统在高速线材轧制中的作用、控制原理、PLC逻辑控制及活套调节对精轧机和夹送辊、吐丝机之间张力的影响。
The closed loop control strategy by model tracking2-freedom rotation speed and the sight-based velocity estimation method are introduced.
提出了模型跟踪2自由度转速闭环控制策略和基于观测器的车速估算方法。
The instantaneous voltage PID control inverter has advantage on circuit and cost, compared with voltage current dual-loop control inverter.
逆变器瞬时电压PID控制与电压电流双环控制相比，在电路结构、成本等方面更具优越性。
The Closed loop control technique is managed for lessening transmission error, increasing the precision and stability of the tobacco machine.
利用闭环控制技术，减小机组的传动误差，提高了控制精度与稳定性。
And the experimental tests had been carried out to verify the established model as well as the dynamic characteristics under opening loop control.
并通过实验，对所建立的动力学模型及开环控制下平台的实际动态特性进行了验证。
And the experimental tests had been carried out to verify the established model as well as the dynamic characteristics under opening loop control.
并通过实验，对所建立的动力学模型及开环控制下平台的实际动态特性进行了验证。
应用推荐